Question about 2006 Dodge Magnum

1 Answer

Cranks fine, want move from park position

Have a 2006 Dodge Magnum, drove to class and back this morning. Started to go again at 5:30pm, crank fine, but could not move the gear shifter from park or any other position.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Water intrusion in the junction block is kina what it sounds like to me.
they were doing a recall on this vehicle.
there was corrosion happening to the wires.

Posted on May 29, 2009

  • cabrown451
    cabrown451 Mar 14, 2012

    hAD THE EXACT PROBLEM WITH MY CHARGER HAD TO CHANGE THE DRIVE SHAFT DUE TO SENSOR FAILURE, IT IS A KNOWN PROBLEM AMONG DODGES

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cadillac 2006 won't crank drove fine last night this morning not start


make sure shifter is in park, take out of park and put back into park,then try to start . sometimes the linkage is not all the way there and the safety switch will not let the engine start

Aug 15, 2015 | Cadillac Cars & Trucks

1 Answer

My 97 intrepid will start up, but putter out within seconds


Map Sensor or Crank Sensor. If you have a code reader the map sensor should throw a code, the crank sensor most often will not. Both will cause the car to start, idle to around 1,000 R's and then die.

Apr 11, 2013 | 1997 Dodge Intrepid

1 Answer

2007 magnum se 2.7 v6 wont turn over


Sounds like the engine is toast.
The warning light means the oil pressure has dropped below 10psi which can mean the engine is low on oil, or that something has happened to the oil pump or other components.
The crank bearings may be seized from lack of oil.
See if you can turn the crank by turning the alternator pulley.

Jan 26, 2013 | 2006 Dodge Magnum

1 Answer

1997 Lincoln Towncar, cranks but won't start?


first you need to test for spark if there is spark then check for fuel if there iis no spark have your ignition module ckecked for fuel take the lifuel line off from fuel tank to fuel lilter it is not difficult.

Jan 24, 2013 | Cars & Trucks

1 Answer

My 2007 dodge charger didn't crank so I jumped it


A battery from 07 is still decently new to be that bad, but I would check the alternator first, just get the car running and unhook the positive cable from the battery, if the car dies the alternator is bad.

Oct 22, 2012 | Cars & Trucks

1 Answer

1997 mpv mini van runs great. While traveling i drove from SC to Atl GA....parked and went into motel for evening...the next morning i had very difficult time getting it re started....Like it was not...


I think you should check your battery and alternator.If they both check good you may have a battery draw,something draining the battery over night.Check your doors make sure they are closing like they should.

Jul 28, 2009 | 1997 Mazda MPV

1 Answer

Can not get gear shifter to move from parking


sounds like a problem with the shift interlock solonoid, lack of power to it, or it went bad. also check the brake switch as it sends power to the shift interlock when u depress the pedal

Jul 19, 2009 | 2005 Dodge Magnum

1 Answer

My 1997 Dodge Avenger's engine won't start


Try cam and/or crank sensor. If crank to cam timing isn't detected properly it'll crank all day but won't start. I had similar problem on my 2.5L V6 Avenger....drove home fine, no engine light, next morning it cranked, but wouldn't start. The crank sensor was faulty.

Jan 11, 2009 | 1997 Dodge Avenger

Not finding what you are looking for?
2006 Dodge Magnum Logo

Related Topics:

236 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...