Question about 1993 Ford Tempo

2 Answers

Need to replace broke window on 93 ford tempo.Pass. side

Passenger side window needs to be replaced on 93 ford tempo.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

  • Expert
  • 195 Answers

Have a junk yard do it for you, they are dirt cheap and good at it if they do it, and have your glass in stock.

Posted on Jun 21, 2015

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 93 Answers

Door Glass, Front Removal

  1. Remove door trim panel and watershield. Refer to Section 01-05. need to replace broke window on 93 ford tempo.Pass - ani_caut.gif CAUTION: Prior to removing center pins from the rivet, it is recommended that a suitable block support be inserted between door outer panel and glass bracket to stabilize glass during rivet removal. Remove center pin from each rivet with a drift punch. Using a 1/4-inch diameter drill, drill out remaining rivets as damage to plastic glass retainer and spacer could result.
  1. Remove two rivets attaching glass to run and bracket assembly.
  1. Remove glass.
  1. Remove drillings and pins from bottom of door.
Installation
  1. Snap plastic retainer and spacer into two glass retainer holes. Make certain that metal washer in the retainer assembly is on outboard side of glass.
  1. Insert glass into door.
  1. Position glass to glass bracket. Install two rivets to secure glass to glass bracket. NOTE: Two 1/4-inch-20 x 1-inch bolts and two 1/4-inch-20 nut and washer assemblies may be used as alternates for glass retention. However, torque must not exceed 4-7 Nm (36-61 lb-in). Equivalent metric retainers (6mm) may be used.
  1. Install door trim panel and watershield. Refer to Section 01-05.


2-Door Vehicles


n5878h.gif





n5879g.gif

Posted on Jun 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse box in a 93 tempo


under the dash left side may have to remove plastic cover

Jan 02, 2014 | 1993 Ford Tempo

2 Answers

Trying to see diagram of where the fuel filter is for a 93 ford tempo, and it is a 4 cyc. can't find it on the car


On the 1993 Ford Tempo with the 2.3L 4-cylinder engine, the fuel filter is located on the right fender apron near the power steering reservoir.

Apr 17, 2011 | 1993 Ford Tempo

1 Answer

93 ford tempo need rear bumber


your best bet is a junk yard ,to replace jack rear of car chock front wheels for safety ,i believe is about eight bolts holding it against a flat plate you cannot miss it four on each side put w-40 if needed to remove

Mar 07, 2011 | 1993 Ford Tempo

2 Answers

Ford tempo auto seat belts not working


You will need to replace the trac and motor. Try a salvage yard to save money.

Apr 03, 2010 | 1993 Ford Tempo

1 Answer

Installing New HeadLight Cover 1990 Ford Tempo


yes replace the lens and that will fix the problem.

May 28, 2009 | 1990 Ford Tempo

1 Answer

I have a 92 ford tempo, im replacing a passenger side drive shaft that broke, i was able to remove the old one with no problem, now im having problem with the new one, i cant install the other hud into the...


The knuckle has to be separated from the lower control arm and pulled out to install. Did you compair the two shafts? You might have one that is boxed wrong.

May 06, 2009 | 1992 Ford Tempo

1 Answer

Passenger Side Power Window


The pass door window switch needs to be replaced.

Oct 22, 2008 | 2002 Ford Mustang

2 Answers

Timing chain


Timing chain does not need to be replaced like a timing belt. It will only need to be replaced if it starts making noise or causing problems

Oct 15, 2008 | 1991 Ford Tempo 4 Door

1 Answer

1992 Ford Tempo can not roll the automatic windows down on the front driver and passenger side. Can you help me troubleshoot? Maybe a list to go down before I take it to the shop. Thank you, Vickie


It could be the door window switch but most likely the window motor has gone bad. need to take off door trim and check both of these out. Need to see if you have power to the switch and motor and check out the grounds as well. good luck!

Aug 07, 2008 | 1992 Ford Tempo

Not finding what you are looking for?
1993 Ford Tempo Logo

419 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...