Question about 1994 Toyota Corolla

2 Answers

How to remove the taillights on 94 Toyota corolla DX. I was able to remove the 3 screws, But there are two other clips on the side of quarter panel holding on to the lights.

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Lift the trunk lid. There should be two screws holding in the tailight assembly. Remove them. Assembly should pull out with some force. If it doesnt pull back on your trunk carpet behind the light assembly and there will be a skinny stud poking through. Hit it wit a rubber mallet.

Posted on Jun 09, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 20 Answers

The clips are cheap looking plastic correct?before you remove them goto a parts store and see if you can buy new ones.if not have them look at it to find something similar.they are cheap plastic and need to be pryed off in most cases and will break.try to be careful.

Posted on May 29, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacing quarter glass on left side on 2005 pontiac gto


Remove the door opening weather-strip. Refer to Door Opening Weatherstrip Replacement in Doors.
Remove side sill trim plate. Refer to Door Sill Plate Replacement in Interior Trim.
Remove the lower quarter panel trim. Refer to Rear Quarter Trim Panel Replacement in Interior Trim.
Remove the center pillar upper trim panel. Refer to Center Pillar Upper Trim Panel Replacement in Interior Trim.
Remove the quarter upper trim panel. Refer to Rear Quarter Upper Trim Panel Replacement in Interior Trim.
Remove the center pillar outer applique. Refer to Center Pillar Applique Replacement in Exterior Trim.
Remove the roof drip molding. Refer to Body Side Roof Drip Molding Replacement in Exterior Trim.

Important: It is necessary to use new nuts when reinstalling the quarter window.
Remove the nine quarter window nuts (1), securing the quarter window assembly (2) to the body opening.
Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
Important: When removing the quarter window from the body opening make sure that the attaching pins are clear of the outer body.
Remove the quarter window (2) from the body opening.

Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement in Seats.
Remove the rear seat back. Refer to Rear Seat Back Replacement in Seats.
Remove the door sill plate. Refer to Door Sill Plate Replacement .

Remove the 3 quarter trim panel retaining screws (1).
Starting at the lower edge of the trim panel and moving alternately clockwise and counterclockwise, pull outward on the trim panel to disengage the eight rear quarter trim panel attaching clips (2).
Remove the quarter trim panel from the vehicle.
Remove the 4 radio speaker grille speed clips (1), securing the speaker grille.
Remove the speaker grille (2).
Remove the rear quarter trim panel insulator (1), from the back of the quarter trim assembly (2).
Remove 7 rear quarter trim panel armrest retaining clips (1).
Remove 7 rear quarter trim panel armrest retaining nuts (2).
Gently pry the quarter trim panel armrest insert assembly (3), away from the rear quarter trim panel and remove.

You mite look for a video on youtube !

Dec 23, 2016 | Pontiac Cars & Trucks

1 Answer

Opening the side board of side door of my toyota corolla car. I have removed the clippings but how would I remove the window riser control?


Manual window locking clip pops out from window handle shaft.

Power window rear door switch is held by four screws on onside of door panel. Remove panel to access.

Power window front door switch pops out of armrest.

Oct 04, 2009 | 1997 Toyota Corolla

1 Answer

How do i replace interior door handle for my toyota corolla 2001 on the driver side


you must remove the door trim panel. the inside handle is bolted to the door with a lock and latch cable attached to it. screw at door hanle cover and another under window and lock master switch, then push clips holding around edge of panel. you will also need to remove small cover for inside of mirror

Oct 03, 2009 | 2001 Toyota Corolla

1 Answer

How do i remove the backdoor panel to replace window on 2003 toyota corolla le?


Remove the rear door armrest by prying upward (secured with 3 clips/claws)

Remove the rear window switch assembly by prying upward (secured with 4 clips/claws)

Remove one phillips head screw from behind the inside door release handle.

Remove two phillips screws from either side of the door pull pocket

Pry the bottom edge of the panel away from the door, releasing 7 pop-in fasteners

Lift up on the panel to remove it from the door.

Once inside there will be two 10mm bolts holding the glass onto the regulator.

Sep 10, 2009 | 2003 Toyota Corolla

2 Answers

My automaticdriver side window in my 2001 toyota corolla goes down, but won't go back up instantly. It usually takes 1-3 minutes to do so. Any ideas why?


It sounds like your motor is dying.

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to remove the motor which will be secured down by a few bolts

Sep 07, 2009 | 2001 Toyota Corolla

2 Answers

How to change a starter in a '94 toyota corolla


disconnect the battery then there are 2 14mm bolts on trans side then go under car and there is a 14mm nut then the wires need removed i think one is clipped in and the other may be 13mm

Jul 22, 2009 | 1994 Toyota Corolla

1 Answer

Remove a driver side door panel on a 2000 Toyota Limited 4 Runner


remove the screws that hold the inside door handle and clips behind the door panel

Jun 14, 2009 | 2000 Toyota Corolla

1 Answer

Car


Fuses will blow out when there is a wire that's grounded out somewhere. Take the brake light sockets with the bulbs in it out of the lens and check for a wire that's broken or maybe corroded. Something is grounding out when you hit the brakes.

May 26, 2009 | 1994 Toyota Corolla

1 Answer

No light in the dasboard and taillights , But headlights do work


take out the 2 phillips screws that hold in the cluster.there are some bulbs in the back of it,look and see that they are all ok.
the tail lights operate on a separate circuit,but the headlight switch could be bad, as it operates both of those sets of lights in the park and lights on settings.check all the fuses and relays in the fuse box under the hood and lower left kick panel

May 26, 2009 | 1998 Toyota Corolla

1 Answer

Need instructions on how to remove my 2005 toyota corolla radio


Tools required: Phillips screwdriver, small flatblade screwdriver, rachet with 6 inch extension & 10mm socket.
1. Remove negative battery terminal (for stray voltage & airbags.)
2. Remove gear shift trim
3. Remove cable attached to lighter socket.
4. Remove center climate control knob and screw beneath it.
5. Gently pry both bottom corners of climate control face (up then towards the rear) until clear of lock.
6. Pull entire climate control console rearward until clips release. Leave all wiring attached.
7. Remove 4 bolts under radio (10mm.)
8. Gently pry between dash and AC ducting panel (both sides) and pull out.
9. 4 clip hold radio to ducting panel, gently pry while pulling radio out the back.
The rest should be easy...
9. 4 clips hols radio to

Mar 19, 2009 | 2005 Toyota Corolla

Not finding what you are looking for?
1994 Toyota Corolla Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...