Question about 1997 Oldsmobile Aurora

1 Answer

When I hit a bump in my 99 aurora the rear and dash lts go out

When I hit a bump the dash lights and rear lights go out and then sometimes they come back on

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Check the body controller above the driver kick panel left side of the panel . This may have a connector problem . Possibly melted connector. Or there is a ground loose somewhere in that area.

Superfreak

Posted on Jun 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 olds will not start


What have you checked so far ?

Jul 15, 2013 | Cars & Trucks

1 Answer

Dash lights and radio lights sometimes work or flicker when hit a bump. Any ideas?


Might be a loose battery cable. Just a thought. did see other post where you stated that you've disconnected battery several times. Hope you find/found a solution.

Mar 13, 2013 | 1998 Jeep Grand Cherokee

1 Answer

99 gmc sierra z71 ..when i accelerate there is a bump in the rear and when i stop the rear seems like its trying to catch up...and sometimes when it hit 2nd gear it hits hard (bumping sound) please help...


It may be the u-joints are bad.On level ground put it in N then get under and grab the drive line at the u-joint and see if there is any play in it.If you have movement there bad.It could be badly worn shocks doing it.Or even a broken spring

Jun 08, 2011 | 1999 GMC Sonoma

1 Answer

I hear a loud clunking noise on my rear passenger side of my 2001 oldsmobile aurora when i hit bumps and the bumps are small


Likely this is a sign of a worn shock/strut. Repalcing the shock/struts will improve the ride quality as well. Do have the suspension inspected for safety. A lot of places will do this for free.

May 09, 2011 | Oldsmobile Aurora Cars & Trucks

1 Answer

I HAVE A 2001 AURORA. SEEMS TO HAVE A GROUND PROBLEM SOMEWHERE. HIT A BUMP IN THE ROAD ALL LIGHTS WENT OUT. LOST POWER STEERING THEN THE CAR QUIT. STARTED LATER AND EVERY THING IS FINE. HAVE NOTICED...


clean your battery terminals-lift the rear seat, the battery is under the passenger seat, disconnect the terminals (both), use a wire brush and get the cable lugs shiny on the inside, where they clamp onto the battery terminals. Then clean the battery posts, hoop up the positive cable first, then the negative cable-while you are there, look at the negative cable and make sure it other end is tight and not rusted where it connects to the body.

Mar 21, 2011 | 2001 Oldsmobile Aurora

2 Answers

My interior lights flickers when I hit a bump in the road or just sitting still. What causes this?


I would replace the light switch, but first I would have a confederate
go around and jiggle all the door jamb switches while I observed the dash lights. Something is loose, often the brightness control for the dash lights is the culprit.

Sep 15, 2010 | 2000 Chrysler 300M

2 Answers

2001 Oldsmobile Aurora Rear Rattle


If it's making a clunk noise when hitting bumps, check the mounting plates and bushings that hold the rear end to the frame. GM made these plates out of aluminum and the bolts that go through the plate and the bushings rot out and the rear end slams against the frame.

Aug 28, 2009 | 2001 Oldsmobile Aurora

1 Answer

Intermittent dash failure 99 dodge caravan


take out the screws in the top of the cluster.remove the cluster.it is a double sided pc board and there will be broken solder joints on the back side of the pc board.resolder all the pins if you can solder,if not take it to an electronics shop and have them solder it.

May 14, 2009 | 1999 Dodge Caravan

1 Answer

I HAVE A 99 AURORA AND THE TAIL LIGHTS AND DASH LIGHTS DONT WORK WHAT WRONG


do the headlamps or brake lights work? probably just a fuse

Jan 16, 2009 | 1999 Oldsmobile Aurora

Not finding what you are looking for?
1997 Oldsmobile Aurora Logo

Related Topics:

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...