Question about 1995 Nissan 200SX

1 Answer

Blowing 30amp ignition fuse.

The car started blowing the 30amp fuse that is located in the fuse box by the engine I believe is labeled ignition, most of the lettering is worn off. Took it to a shop to trouble shoot and they did not find a problem. The starter sounds good when it is turning over the engine. It has happened 4 times in the last 3 days. Any advice on where to start trouble shooting would be appreciated. Intermittent problems are a pain as you are well aware of. Thanks, Gene

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 308 Answers

First check the wires connected to the battery for missed alignment. then change the fuse to 30 above amp.

Posted on Jul 23, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 1999 Dodge Avenger V6. Keeps blowing Engine Fuse under hood


Fusible link 3 feeds the PCM. the ASD relay, and fuel pump relay. Assuming it has A/T, that fusible link also feeds the starter relay, the EATX-ECM, and the EATX relay. A short in any of those elements could be causing the trouble.

Dec 16, 2016 | 1999 Dodge Avenger

1 Answer

Where are fuses for blower motor 2011 mustang


Located in the SJB smart junction box , F4 30amp an there is a blower motor relay , an fuse F15 ,10amp an fuse F45 5amp, an a blower motor speed controller ! hope this helps

Mar 23, 2015 | 2011 Ford Mustang

2 Answers

I have a 1999 dodge avenger that keeps blowing the 30amp engine fuse under the hood it only blows the fuse when I crank the ignition checked all the words not sure where to look anymore any suggestion's


If it just keeps blowing it could either be a bad ground somewhere or theres to much power getting pushed to it for some reason when u start it, blowing the fuse

Jan 03, 2015 | Cars & Trucks

1 Answer

2002 PT Ignition start fuse blowing


PCM?? No they are wrong I think, keep looking at every wire fuse 30 supplies power to, you will need buy the factory wiring diagrams.

Oct 24, 2012 | 2006 Chrysler PT Cruiser

2 Answers

30amp AM 2 fuse blows as soon you turn on the key & car will not start


This is common about this time on these Camrys. I own three. The AM2 fuse is blowing because a coil, capacitor, or supressor has gone bad in the distributor. To test this disconnect the two wire connectors to the distributor. Replace the AM2 fuse. Turn the ignition. If the fuse doesn't blow. The distributor.

Jul 01, 2012 | 1994 Toyota Camry

1 Answer

Ignition Fuse keeps blowing


Hi Jeff , in what fuse box is this 10 amp ign. fuse located ? I am looking at a power distribution diagram and i see a IGN 3 10amp fuse located in the I/P fuse box ! Is this the fuse that blows ? I see where you replaced the 10 amp with a 30amp . That is never a good idea , you don't want to make your problems worst . Melt wiring harness , could start a fire . Do you know how to do electrical trouble shooting ? How to use a wiring diagram , power distribuition diagram ? That fuse is hot in the run , powers the rear Heat / A/C , automatic level relay, ESC - electronic suspension control module , rear wheel steering control module , Plus someother thing's depending which vehicle , Y91 - ULT . Your Taho doesn't have all this options . http://www.bbbind.com/free_tsb.html find the thing's that fuse powers , disconnect them one at a time till the problem goes away .

Apr 08, 2017 | Cars & Trucks

1 Answer

Fuses keep blowing


need to see if u have a short a wire must be toching the car somwhere wire must have a cut in it

Oct 05, 2009 | 2002 Saturn Sl

1 Answer

Wiper fuse keeps blowing intermittently.


It looks like the wire circuit for the wiper motor is touching the car body when shaken so the only thing you can do is shake the wires and terminals yourself while engine is running then maybe you can pinpoint where the earthing is.

May 08, 2009 | 2001 Hyundai Accent

1 Answer

Ignition fuse kepts blowing


then there is a short circuit on that node. try to analyze also what was that 30amps fuse for? example, is it for lights, audio, aircon? You also need a simple multimeter to check if it still shorted.

Mar 29, 2009 | 1991 Mitsubishi Galant

Not finding what you are looking for?
1995 Nissan 200SX Logo

Related Topics:

454 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...