Question about 1996 Chevrolet Blazer

1 Answer

Could this be a cold start problem

Same problem with engine wont start unless i prime the carb with gas this is just in the morning after first prime engine will start fine until it sits too long

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,600 Answers

Defective fuel pump the check valve is allowing it to lose prime replace fuel pump.

Posted on May 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car wont start during cold winter mornings


Clean throttle body and change fuel filter.

Jan 28, 2016 | Cars & Trucks

1 Answer

2001 Hyundai accent wouldn't start this morning after sitting two days prime and no codes kept screwing with it I primed and runs then only primes sometimes but still runs great miss chug


Hi Miss Chug:
I'd start by using some carb/injector cleaner and make sure that the fuel delivery system is working properly.
If this is a carb type engine, make sure the automatic choke is not sticking.

Jun 30, 2015 | Hyundai Cars & Trucks

2 Answers

My vehicle does not start well in the cold..


THERE ARE 2 TEMP SENSORS ONE IS FOR THE LIGHT OR GAUGE AND THE OTHER IS FOR THE ECM. IF THE ONE FOR THE ECM IS FAULTY IT CAN CAUSE HARD COLD STARTS

Dec 23, 2014 | 1998 Chevrolet Suburban

1 Answer

Car not starting in morning


It sounds as though you are imitating a cold start injector by pouring fuel into intake. I would start there

Aug 03, 2014 | 2003 Pontiac Grand Am

1 Answer

Cold start cranking problems 1987 toyota truck wont hardley crank when cold then fires fine after gets crunk till next morning


My 1987 truck I use to have had a choke and it would stick open some times. When you get in the vehicle, you have to press the gas pedal to the floor once to set the choke and add enough fuel to start the vehicle. I assume your vehicle has a carburetor and would suggest the following:

When your engine is cold, take off the air cleaner cover and base and look the butterfly valves. They are fist valve on the top of the carb air inlet. Go and step on the gas pedal once. Observe if the valves move to the almost closed position or not. If they don

Jan 05, 2011 | 1987 Toyota Pickup

1 Answer

Wont start after sitting a few days unless primed with gas in the carb. Replaced fuel pump and filter


primer pump in carb is bad it's easy to fix and will need to buy carb kit to get it all it is is a small rubber piece that helps pump gas into the carb good luck.

May 20, 2010 | 1979 Ford F 350

1 Answer

In the morning have to hold gas pedal down to start and hold for a minute.. if not will stall..only when its cold ..After it warms up its fine all day..Any advice..


Wrong air/gas ratio of mixture. Nasty problem, can be dirty nozzles or dirty air filter, almost invisible crack in a hose, loose input manifold or similar, low coolant level, making the auto-choker to behave funny, the choker's sensor, old worn gasket on the carb. I haven't looked at Cherokee, so sorry if there are no carb engines for it.

Nov 10, 2009 | 1999 Jeep Grand Cherokee

1 Answer

I have96 blazer will start and run if i prime carb with gas but


did you also replace the fuel filter with the pump?

May 28, 2009 | 1996 Chevrolet Blazer

2 Answers

2000 maxima won't stay started on a cold morning


Have the plastic intake manifold and gasket replaced. I have posted this fixed at least once before and have seen it numerous times.

Nov 23, 2008 | 2000 Nissan Maxima

1 Answer

97 GMC Sonoma


checked fuses , #9 fuse for fuel pump was loose.

Jun 21, 2008 | 1997 GMC Sonoma

Not finding what you are looking for?
1996 Chevrolet Blazer Logo

301 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...