- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
95 Lincoln town car coolant leak under intake SOLUTION EASY
Ok this is a 4" piece of hose leaking on a tube that runs under the intake manifold and fastens to the rear of the engine with 2 small bolts that are very hard to get to. The heater core hooks up to this tube with a 5/8 hose that's 3/4 on the other end going into the heatrer core. Solution: remove alternator see clamp on hose? remove it. If you can't remove it, clamp vice grips on it and take a steak knife and cut through the hose towards the rear of the engine. Now with large screw driver pry the hose and clamp off the nub on the rear of the water pump housing. You may have to move the tube and remaining hose out of the way first. Just stick your hands in there and force it out of the way. Now you have a clean nub to hook a 5/8 bypass hose to. Here's where you get it. Go back to the heater core and and remove the hose that connects to this tube that runs under the intake. Just cut it where it hooks to the tube and remove it carefully from the heater core because this is now your needed bypass hose. Now with a couple feet of 3/4 hose and a coupler you have all you need to reroute this water outlet around the engine to the heater core. Take your hose you cut from the other end of the tube and removed from the heater core and and fasten it to the nub on water pump housing use new screw type stainless Steel clamps. You have to take this one apart to put it on. Stick a 3/4 coupler into the other end and route a long section of 3/4 hose under alternator to the heater core using SS clamps where needed. job done... Just leave the old tube where it is under the intake manifold......Thank you Very Much
U have a failed air temperature control electric blend door actuator, to replace this part requires the dash be removed from the car, the part is located on the outside of the heating duct about center of dash.
hi, if you look right at the back of the engine bay and about half way down the bulk head below the bottom of the windscree under the bonnet you should then see 2 pipes coming through the bulk head these run from where the thermostat is to the heater matrix so look for these 2pipes coming through the bulk head from the engine bay to the heater matrix behind the dashboard.
Let me know if you follow what im saying hope i have given you enough info to find what your looking for
If your talking about the heater pipe and hose under the intake....(to ease removal you can remove the inlet air cowl/wipers/etc.) remove upper intake/coils/fuel line etc. the tube is bolted to the back of the RT head...replace the entire tube/hose assemble....IF the tube at the frt of the block is corroded/damaged/etc. you will need to replace that also (remove waterpump for access and installation)...change you T/Stat at this time also....hope this helped you...GL
there is a small heater hose on the pass side rear from the firewall(heater core) to the intake manifold. the plastic manifolds have a tendency to split where the hose fitting goes into the intake. If that is where it is leaking the manifold needs replacement.