Question about 2001 Hyundai Elantra

1 Answer

Po711 code my car is posting a po 711 code .when driving the car has low pickup but it will shift (auto trans )

Posted by on

  • Paul McGrath
    Paul McGrath May 11, 2010

    This code represent a problem with the Trans fluid temperature sensor's range/performance. The only thing you can do here is ckeck connections (connectors) to it. If you don't find any problems with the wiring/connectors, replace the sensor. However, I'm not aware of any instances with this sensor causing a drivability/performance issue. Here's an excerp:
    P0711 Oil temperature sensor rationality

    check (See 2005 Tucson Shop

    Manual, Page TR-188)

    • MIL on

    P0712 Oil temperature sensor - short circuit

    • MIL on

    • 2-3 shift flare

    P0713 Oil temperature sensor - open circuit

    • MIL on

    • Harsh P-R or P-D engagement

    • Damper clutch does not engage

    • No 4th gear engagement (1996-2000 Elantra, 1997-

    2001 Tuburon, 1995-2005 Accent)

    • 2nd gear hold (1999~ Sonata, 2001~ Elantra, Santa

    Fe & XG, 2003~ TIburon, 2005~ Tucson)

  • Michael Masters
    Michael Masters May 11, 2010

    what engine is this?

    what size??

    what liter??


×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 776 Answers

This DTC code is set when the ATF temperature output voltage is lower than a value generated by thermistor resistance, in a normal operating range, for approximately 1 second or longer. The TCM regards the ATF temperature as fixed at a value of 80 °C(176°F). Solution: Eliminate wiring as the cause. Once you've done that, Recommend you replace the sensor. Otherwise, take the vehicle in to a Hyundai Shop and pay the diagnostic fee. They'll tell you what the problem is and the cost to repair it (parts, labor, & tax).

Posted on May 30, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My truck runs great while parked but when i try to drive it has no power with a load


Take it to your mechanic and have it checked for a partialy clogged catalytic converter.

Nov 08, 2015 | 1990 Toyota Pickup

1 Answer

Slow pickup on takeoff


You don't specify make, model, year, engine or transmission, but if an auto, a common cause of this is failure of the 1-2 shift solenoid in the trans, meaning that it cannot find low gears, hence the sluggish takeoff.

It is not an expensive part, but it is best to have the vehicle on a hoist as the trans pan must come off. Also this fault should cause the check engine light or the overdrive light to blink a trouble code.

Feb 10, 2014 | Cars & Trucks

2 Answers

My 1995 Nissan pickup xe truck when I put it in drive it will not shift out of first and once I get to the speed of 25 miles a hr. it shifts into neutral until it goes down to appx. 15 mph then it kicks...


V6 or I4 engine? xe = i4?
bad tranny.?
low or too high ATF levels.
clogged bottom filter before pump, (shifts hot?)
RE4 trans is 4speed electronic
RL4 xxx trans is manual only
this side of your tranny has a tag is it RL/RE4 or or 3speed.

3 speed or 4 speed the FSM show four A/T used then .
there are 5 tranny total then ,4 AT (1 m/t)
on car diagnosis varies greatly by type.
fluid checks (if electronic the Tcm blink codes (DTCS)
pressure checks. for weak pump.
that stall rpm tests.
here is one used on your car
http://www.bulkpart.com/Merchant2/graphics/Catalog-pdf/RE4R01A.pdf

Oct 16, 2013 | 1995 Nissan Pickup

1 Answer

2000 ply. voyeger 4 cyl. auto trans.on hard stops in drive acts like netural ! than bang burns rubber


Hi, have you checked the fluid level and when was the last transmission filter replacement?

Nov 14, 2011 | 2000 Plymouth Voyager

1 Answer

Code po 711


trans temp sensor

Jul 13, 2010 | 2001 Dodge Dakota

2 Answers

PO 171 and PO174 codes but different problem


transmision shifts are based on engine load imputs a 171 and 174 refer to a lean condition therefor the shift is being based on an assumed cold engine so yes it may be related

Apr 23, 2009 | 2003 Ford Explorer Sport

1 Answer

1999 DODG 3500 AUTO TRANS SHIFTS TO 2ND WITH A LITTLE HELP


I have a 1999 Ram B 1500 Van, auto transmission, 5.9 L engine.
Same problem, trans hesitates in 2-3 upshift, sometimes 1-2
to 2-3 upshift. Posts trouble code P1756 - Transmission Govenor pressure too low at below 15 to 20 Psi. Transmission pump shot or valve body leak stops trans from reaching proper pressure to shift, which is minimum 15 Psi.
Either trans is leaking in valve body, valve is stuck, shift solenoid on valve body is sticking, or pump is shot.

Feb 14, 2009 | 1999 Dodge Ram

1 Answer

My shifting is weird


You have a trans issue, have the system self tested for codes, Kragen auto and others do this for free. Get back to me with the trouble codes.

Sep 21, 2008 | 1999 Ford Escort

1 Answer

Problem code po711. what is this? Will not let car complete the inspection for North Carolina.


This code is set by the TFT, that is the tranmission fluid temperature sensor, have you towed anything lately that might have overheated the trans? If not erase the code and drive it, it may be a fluke.

Sep 04, 2008 | Hyundai Santa Fe Cars & Trucks

Not finding what you are looking for?
2001 Hyundai Elantra Logo

690 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...