Question about 1996 Oldsmobile Cutlass Ciera

1 Answer

Broken antenna - 1996 oldsmoblie ciera

The antenna snapped in the carwash. how do i replace it?

Posted by on

  • yadayada
    yadayada May 11, 2010

    do u have a power antenna?

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

I assume it is an extendable antenna, if so loosen the ring around the antenna base there are usually like 4 slots on it, after you have removed the ring, have some one turn your car to the accessory mode and turn the radio on, your antenna or what is left should come right out, to install your new one just feed cable down hole and have them turn your radio off you may need to spin the antenna just a touch to let it catch cable, be sure to put your antenna ring back on.

Posted on May 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trying to replace antenna mast on 1998 toyota 4 runner sr5. New antenna does not come with bezel so how do I remove bezel from old antenna and put on new antenna? Thx


Where did you get new antenna? If no instructions talk to the Autoparts store where you bought it. There should be instructions with the antenna. What happened to old antenna? A motorized antenna? If motorized, antenna has a white nylon gear tooth at back end. If it's not motorized it may not match. The bezel usually screws into the motorized device underneath the body work. Should be way to use small wrench to turn just like a nut to remove. Hope this helps. I've changed mine several times, by going throug the carwash without turning off the radio, but
different car.

Feb 27, 2015 | 1998 Toyota 4Runner

1 Answer

Cannot remove antenna for carwash


Many cannot be removed or unscrewed. If it is telescopic, shorten it as much as you can. If not and you are still concerned, visit a handwash facility. These are common.

Mar 10, 2014 | 2006 Toyota Highlander

1 Answer

Antenna


rod screw type antenna you have to replace whole antenna.just screw out old antenna screw new antenna in place.

Jul 01, 2013 | GMC Cars & Trucks

1 Answer

Issues replacing antenna mast


BEST BET TAKE TO A REPUTABLE DEALERSHIP OR A VERY REPUTABLE GARAGE

Jun 24, 2013 | 2000 Volvo S40

1 Answer

Has constant miss while running then shuts down


Your problem is probably caused by a bad intake manifold gasket. It is a common problem with your engine.


http://www.ehow.com/how_6925577_replace-intake-manifold-1996-oldsmoblie.html

Oct 23, 2011 | 1995 Oldsmobile Cutlass Ciera

1 Answer

How do I replace the Antenna on my '95 Oldsmobile


Easy peasy...under where the antenna mounts should be the motor if its retractable and electrical connector..d/c the connector and remove the bracket, antenna should pull out - reverse for installation!

May 07, 2011 | 1995 Oldsmobile Cutlass Ciera

1 Answer

Antenna was broken @ carwash. when you turn radio on it makes a popping noise until radio is on.


u will have 2 disconnect the wire from the anntanea until u fix it. the motor is still trying to run.

Feb 19, 2010 | 1999 Lexus RX 300

1 Answer

1994 MB E320 Power antenna slightly corroded believed to have caused too much resistance and burned out the motor (cannot hear motor trying to work upon turning the radio on/off like it should). How can...


just push it down or take a 13 mm. wrench and pull the mast out of the motoer and cut the plastic strip off the mast and reinstall it but first I would check the fuse for the motor.

Jun 17, 2009 | Mercedes-Benz E320 Cars & Trucks

Not finding what you are looking for?
1996 Oldsmobile Cutlass Ciera Logo

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8567 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...