Question about 1996 Lincoln Continental

1 Answer

Need to replace the left rad fan motor, any ideas on how to do it if i have the new part?

How would i change the left rad fan motor on a 1996 lincoln continental? I have the part.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 94 Answers

  1. Remove radiator from vehicle.
  2. Remove fan shroud retaining bolts, and cooling fan motor/blade/shroud assembly.
  3. Remove fan blade retaining clips and blades.
  4. Remove motor mounting screws and motors.
  5. If necessary, remove Constant Control Relay Module (CCRM).
  6. Reverse procedure to install. Torque CCRM screws to 40-56 in lb, and shroud retaining bolts to 24-48 ft lb.

Posted on May 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What make the rad.fan change speeds


If this is the original cooling fan it is very likely the cooling fan motor is defective or the connector to it is heat damaged from the motor problem, Make up a jumper cord from house lamp cord and hook it directly to the cooling fan motor, if the motor still turns slowly then the motor is defective.

Sep 05, 2012 | 1993 Lexus Es 300

1 Answer

How do I replace the blower motor on my 1996 Lincoln Mark VIII


check for power at the blower housing rt side of inner fender well

Aug 29, 2012 | 1996 Lincoln Mark VIII

2 Answers

How do I change the engine radiator fan motors on my 2001 Buick Century?


  • Remove the passenger side kick panel using a Phillips head screwdriver. Pull the rug back from under the blower motor to allow enough room to drop the blower motor without the rug interfering.

  • 2

    Disconnect the electrical plug from the blower motor. Pull the rubber vent hose out of the blower motor.

  • 3

    Remove all the Phillips head screws securing the blower motor to the housing. Drop the blower motor straight down.

  • 4

    Install the new motor in reverse order of removal

Jan 13, 2012 | 2001 Buick Century

1 Answer

My 01 LS 3.9 has cooling issues. After replacing Degas bottle, flushing system and removing all air in system, now the car runs fine with climate control off compleatly or with the heater on. . .but if I...


Have you checked the high side relay, the rad fan if its only one instead of two, the rad fan should switch to high not low. Also flush the radiator that might help too.

Aug 24, 2011 | 2000 Lincoln LS

1 Answer

THE MOTOR IS OFF THE FAN IS STILL ON


This is normal. The fan will run with the engine off till the rad temperature goes below about 100 degrees F. Do not worry about this only if the fan stays on longer than 10 minutes. You may need a new fan relay if it won't go off. Good luck!

Jul 13, 2010 | 1996 Ford Taurus

2 Answers

I need to replace a water pump


good news / bad news

the good news is its a pretty simple job
the bad news is that some of the bolts have a tendancy to break making and easy job a pain in the ****

if you cannot find a shop that will do the job for less than $200 then seek out a high school or college that has an automotive program

most are always looking for work and "IF" they charge anything its CHEAP!!!

May 20, 2010 | 1990 Lincoln Town Car

1 Answer

Procedure of changing the water pump


drain rad ...remove rad ....and all it's hoses ...remove fan...usually a few bolts along it's back side ...where the shaft comes out that's where you water pump is ...remove the water pump ....buy new gasket ,with the new pump ..replace ....gasket glue the new gasket to the pump....do not over tighten the bolts ...go opposite to opposite to tighten ...a half turn is more then enough usually ...good luck ...it's always good to start with new antifreeze after installing the rad ect ...

Jan 02, 2010 | 1996 Buick Century

3 Answers

1996 Chrysler T/C over heats


It takes a while for the fans to turn on. If not, it could be faulty temp sensor or fan relays which can be found by tracing the wires from fan motor.
I also recommend changing the thermostat and using a 50/50 coolant mixture. A thinner oil is also better at keeping the engine cooler. Same with synthetic oil

Aug 14, 2009 | 1996 Chrysler Town & Country

1 Answer

How do i change my fan belt on an audi a4 19 tdi


i just replaced 1 yesterday your best option is to remove the headlights, bumper, you will see 3 torx bolts both sides holding complete front section, remove air conditioning rad pull round to right hand side without losing pipes, the front section should pull round to the left a little prope with axle stand. draw out a digram of witch way the belt goes round all pulleys. to the left of the water pump (big fan wheel) is the tensioner, to slacken place 15mm spanner on bolt and pull anticlockwise.

Jun 20, 2009 | 1996 Audi A4

1 Answer

Rad fan makes car shake 2003 sunfire


I would check the radiator fan in the car for looseness. If the fan wobbles or moves , Then change out the radiator fan. The radiator fan and motor come as one piece. There is a fan relay also should be replaced.
When turning the key only half way to make the dash fan work, indicates that the dash fan is okay.
The dash fan may make a whining or high pitch noise when engage. Then I would change it out because an internal bearing to the fan is going out.

Good luck

Mar 18, 2009 | 2003 Pontiac Sunfire

Not finding what you are looking for?
1996 Lincoln Continental Logo

Related Topics:

579 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...