Question about 2000 Ford Expedition

1 Answer

No oil Pressure, with knock.

Oil pressure drop to 0 eng started to knock then after a couple of starts oil pressure came back no knocking

Posted by on

  • Devon Sacco
    Devon Sacco May 11, 2010

    Is the oil level where it should be on the dipstick?

  • Kenzie Stewart
    Kenzie Stewart Apr 15, 2014

    Yes it was where it was supposed to be and then i lost pressure so i overfilled to see if the pump would pick it up and it's where its filled to.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

The first thing I would do is change the oil filter. Also, what engine do you have.

Posted on May 27, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil pressure drops engine knocking and dies


Hi Josh, Sounds to me as if you've got serious engine damage. This will probably need a replacement engine or a rebuild. Sorry pal. Regards John

Feb 23, 2014 | 1998 Dodge Dakota

1 Answer

Have a 2004 f150 left town took exit heard knocking oil pressure dropped to 0 then up back down is it oil pressure sending unit or pump or maybe o ring from pump to tube


Pull the sump and check the main bearings for spinning in cap. The knock indicates a bearing and the fluctuating pressure indicates a oil hole being opened and closed as the bearing shell moves over the oil hole in the crank.

Mar 21, 2013 | 2004 Ford F150

1 Answer

1998 ford explorer oil pressure


Knocking in engine and low oil pressure usually means bad main bearings. May have been caused by bad oil pump or just worn out bearings due to high mileage. If this is problem needs engine or rebuild old engine.

Jul 15, 2012 | 1998 Ford Explorer

1 Answer

My 98 blazer sounds great until it gets warm


I switched to Lucas oil with adding Lucas oil stabilizer and it increased my low oil pressure problem

Mar 13, 2012 | 1998 Chevrolet Blazer

3 Answers

I got in my 2001 Expedition, started it up and the oil pressure light came on. The guage was down to 0. I stopped it and started it again. The guage press. went up and then slowly dropped at first and...


oil pump gears inside the lower engine, or electrical. 1st make sure its full on oil, then sheck it with another pressure guage to confirm its not actuall pressure.

Jan 02, 2011 | 2001 Ford Expedition

2 Answers

Intermittent oil pressure loss at highway speeds


sending unit may be bad. If engine is not knocking or tapping when pressure reads 0 likely that's the case.

Jan 02, 2010 | Dodge Cargo Cars & Trucks

1 Answer

Engine knock hard over 2500 rpm


Does the oil light come on or the knock occur during the engine warm up after a cold start?
There could be a couple of problems causing the issue. You could have an oil pressure pump or pump pressure regulator sticking. I would have a mechanical oil pressure gauge installed and verify oil pressure at idle and 2500 rpms to make sure oil pressure is in normal ranges.
You could also have excessive piston rod bearing, crankshaft bearing or cam shaft bearing wear that will cause oil pressure to drop too low to prevent the rod knock your hearing at 2500 rpm.
You said a knock and not a ticking noise,so I don't believe a lifter is the issue at 2500 rpm.
Start with the oil pressure check and go from there.
Let me know.
Regards,

Aug 22, 2009 | 1996 Dodge Stratus

1 Answer

The oil pressure gauge keeps dropping down to 0 while i am driving


If you don't hear any ticking or knocking while the pressure gauge drops, the problem is probably a failing "oil pressure sensor". If you do hear a ticking or knocking, the problem is probably a failing "oil pump".

Jun 03, 2009 | 1997 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Ford Expedition Logo

Related Topics:

280 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...