Question about 1995 Honda Prelude

1 Answer

My car won't go into gear

I try to put my car into gear but it feels like its jammed and it wont go through, but when the car is turned off the gears go in just fine.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 351 Answers

You have a clutch problem, may need adjusting or you may need a new clutch

Posted on May 27, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

When i start my car and go to put it in gear it wont move.


When you say rocky spot, what do you mean? If you mean there were rocks in the roadway, you could have put a small hole in the transmission pan which leaked all the fluid out of it. First thing I would do is check the fluid level on the transmission dipstick and look for leaks on the ground under the car.

May 01, 2015 | 2002 Ford Taurus

1 Answer

Why wont my samurai transmission input shaft turn.


5 speed

is it still on the bench>????????
i rebuild many

1: the bearing in the front is bad.
2: the tranny is locked, bad shifter rail, detents
3: 4th gear is not a gear, it just locks themain shaft.
so if in 4th gear and input is jammed, that means
the cluster is jammed. if the cluster jams for any reason
it will be jammed in neutral. too, because the cluster always spins.
bottom counter shaft is called cluster. to old folks.

tell me , with the lid off tranny box.
did you test all gears, by moving the collars 1 by one.?????
each gear,? if not why not.????? never skip this step or fail big time.

then test all rail detents to make sure they all work(lid off)
and never allowing 2 gears selected at once (job1)????

then put in a new shifter sheet and try all gears on the garage floor,
all assembled!
then turn input by and and shift all gears on garage floor
i even use a huge drill motor to test tranny on floor, with tape on tip
of pilot shaft. and shift all gears,

this is all basics, , never just throw it together, do the tests.
as you go.

this one is close,
http://www.fixkick.com/tranny/5speed-rebuild.html


Aug 29, 2014 | 1988 Suzuki Samurai

1 Answer

1996 toyota camry no gears all of a sudden no prior issues leaking oil wont rev over 3000rpm


Time to rebuild the transaxle

That job is five times the cost of what
the car is worth,get rid of it

Mar 04, 2014 | Cars & Trucks

2 Answers

1997 taurus key won't turn in the ignition, gear selector won't go into gears


Usually a sign the tumblers in the lock cylinder have worn out or jammed.
You may have to get the lock cylinder drilled out and replaced.

Jan 13, 2013 | 1997 Ford Taurus

2 Answers

Push on clutch and caR WONT GO IN GEAR UNLESS MOTOR OFF


Some of that model had an unusual clutch mechanism, which has probably broken due to wear. Read here

http://wiki.answers.com/Q/How_to_adjust_clutch_on_1995_ford_escort

In the event yours is instead fitted with a hydraulic clutch, either

- the hose has split
- the clutch throwout lever has broken or collapsed

Mar 21, 2012 | 1995 Ford Escort

1 Answer

Changed the flywheel and now it wont turn over feels like the pistons in the engine one is stuck


loosen the bell housing bolts and move the transmission back 3/4" and see if the motor turns, if so you need to remove the transmission and replace the pump gears, the problem is most likley the torque converter came out of the pump gears and is jamming the pump, if so the ears on the gear is most likely cracked, if you don't run the motor you may be able to save the pump.

Jul 20, 2011 | Chevrolet Blazer Cars & Trucks

1 Answer

Car wont start without pushing keypad, key turns and lights,radio etc appears but car wont start. its a 1996 model


check the earth wire from the battery, if it is a poor connection the car will not start but you may still get lights etc.

The starter motor could be completely jammed. put the car in gear with the keys not in the ignition and push the car forward until you feel the engine turn over, this may free the starter motor up.

Jan 28, 2010 | 1996 Toyota Camry

1 Answer

After being stored clutch willnot engage


do you mean wont disengage? does the pedal feel normal, or like its pushing nothing?cant put it in gear? or goes in gear but wont move?. if you put it in gear but car wont move, the clutch is toasted. if you can put it in gear with the engine off, but not when its running, check the clutch master fluid. if its low or out, then the slave or master is leaking and you will need to replace both. if the clutch arm IS working, and the pedal feels normal, sometimes you can put in gear, and start it with the clutch pedal depressed and drive it, and goose the gas to "break the disc loose"

Oct 14, 2009 | 1997 Suzuki Sidekick

1 Answer

My car wont go into gear


Well, absent any additional information from you, if you have difficulty shifting gears when the car is in operation, you may have any of three problems: the master cylinder, slave cylinder or the mechanical synchronizer of the transmission malfunctioning. Here's a diagnostic article that explains it very well:
http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Transmission_System_Shifting_In_Manual_Transmission_No_Poss_Engine_Runs.htm

Another closely similar article that is good to read--even though the first one sounds a lot like yours--is this one:
http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Transmission_System_Stuck_In_One_Gear.htm

Hope this helps!
Brad

May 26, 2009 | 1995 Honda Prelude

Not finding what you are looking for?
1995 Honda Prelude Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...