Question about 2004 Dodge Neon

1 Answer

Doesn't rev up past 2 rpms

I was driving my car down the street when my check engine light came on. I went to go hit the gas to get up to speed and it started chuggin when it past 2 rpms

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 6,674 Answers

Run into autozone or Pep Boys for free trouble code scan, then write it down and get back to us, or if obvious what problem is diagnosed, replace the part.

Posted on May 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My question: what can cause the car to do this?


I assume the car you are talking about is your 1968 Dodge Dart GTS with a 4-speed manual transmission. The engine has a special camshaft, Chrysler P/N 312044, which has a 60 degree overlap in the valve timing, since the engine is built to rev in excess of 6,000 RPM. The problem with your car is obviously a leaky accelerator pump. Why don't you get a car that (1) does not have to run on premium gas (because of its 10.5:1 compression ratio), and (2) uses fuel injectors instead of a wild 4 barrel carburetor made for 1/4 mile drag racing? I happen to know that that is the car you are referring to, because you did NOT say that it WASN'T!

Apr 29, 2017 | Cars & Trucks

1 Answer

2004 chevy malibu high rpms and revving all by itself


Have the engine checked for vacuum leaks, that will cause a high idle speed. As a 35 year veteran of auto repair I can tell you that engine flushs are a 100% waste of your hard earned money.

Jan 27, 2014 | Cars & Trucks

2 Answers

2002 Chrysler Sebring 2.7 liter... When the car starts, I can only bring the RPM's up to 3000. when I've reached 3000 rpms the RPM's start going up and down...I have replaced the fuel pump what should I...


Nothing, you have hit the rev limiter. The up and down is the computer controlling the rpm. If you drive it, it should rev past 3,000. The computer is designed to keep free wheeling rpm to that level. It will only allow a higher rpm if vehicle is in gear and moving with a load.

Oct 27, 2013 | Cars & Trucks

1 Answer

Rpms rev but car does not go when gas i pressed then transmission feels like it engages


possible that there is an issue with the torque converter clutch servo/solenoid operation
take it to an accredited service center and have it properly diagnosed

Apr 23, 2017 | 2008 Saturn VUE

1 Answer

96 Jeep Cherokee RPM Surge While Driving


If the problem began before you changed the plugs that they are likely OK...Some engines "like" certain brand plugs better than others. You may have a weak ignition coil. Poor spark will generally show up at higher rpm's. Spark should be blue and have good "snap" to it and should easily bridge a 1/4" gap or better. If fuel was contaminated, it should show up at lower rpm's as well. System cleaners sometimes work but often are added far too late to do any good. (tank can hold up to a gallon of water without noticing it.) I use 3oz of acetone and one oz marvel oil per 10 gallons of fuel about once a month...cheaper and more effective than most cleaners. (and does not "melt" gaskets and seals as legend has it) The vehicle speed sensor can also give you problems but needs testing to determine if it's got any problems.
It's difficult to diagnose by remote control, but I hope you benefit form something here!

Jun 12, 2009 | 1996 Jeep Cherokee

1 Answer

2002 explorer idle shake & no rev


bad intake not enough air to the cylinders, spark plugs could be a prob, or ur car is running to lean...i hate a similar prob with it shakeing when idleing but i just tap the gas and it stops

Jan 10, 2009 | 2002 Ford Explorer

Not finding what you are looking for?
2004 Dodge Neon Logo

Related Topics:

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...