Question about 1996 Volkswagen Passat

Open Question

1995 Passat Overheating

There is a part with at least three hoses that are broken off. I think it is the EGR valve. How can I confirm what the part is? Here are numbers I found on the part
021129101 & 3911170972
Thank you

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 84 Answers

SOURCE: clogged or broken egr valve

remove the valve and clean it with a brush and some fuel or carb cleaner, easily done. it will effect the overall performance of the vehicle

Posted on Dec 19, 2008

sudel
  • 90 Answers

SOURCE: overheating

Fairly common problem so i would say it is definitely your head gasket. Sorry.

Posted on May 20, 2009

polarcycle
  • 1392 Answers

SOURCE: 1995 Honda Accord V6 Engine Stalls at Approx. 3500 RPM

Yes it could, as this creates a vacuum leak.

Posted on Jul 07, 2009

outdoorsman5
  • 631 Answers

SOURCE: Vaccum hose diagram for 97 chevy tahoe 5.7 liter

I have the diagram you need. If you send me your email I will scan it off and send it to you. outdoorsman592003@gmail.com

Posted on Sep 12, 2009

moparownr
  • 667 Answers

SOURCE: 1999 FORD EXPEDITION 2WD 4.6L EGR VALVE,EGR

Remove the throttle body housing on the top of the intake, it is a 90 degree tunnel like small piece held by 4 small bolts, turn it over and look for two holes, these holes are for the EGR valve flow, they are probably plugged up with carboned crud, clean them out with the tip of a screwdriver if neccessary to remove all the crud, once its clean reinstall it and reset your check engine light, hope this helps, let me know

Posted on Dec 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The egr valve regulator hose keeps blowing out. i took out the catalytic converter, replaced the plugs & wires, egr valve and still the same results


You removed the Cat? Maybe just plug the EGR regulator hose connection since you have no catalyst anymore.

Sep 06, 2013 | 1995 Ford Windstar

4 Answers

Have a 1995 ford contour and took it to pepboys and they got multiple codes. One of the codes came up twice code 332 says egr valve not opening could this cause all the other codes? My husband has checked...


DTC P0332 is for a knock sensor, not egr valve. That's not to say one of the multiple codes you've mentioned wasn't for the egr valve.

What are some of the characteristics the vehicle is showing. By the way, what is the vehicle? In one place it says 1995 contour, in another it says 1995 explorer.

Jan 03, 2011 | 1994 Ford Explorer Limited

1 Answer

Where do I find the EGR valve on a 1995 subaru Legacy 250T automatic


  1. Detach the vacuum hose from the EGR valve.
  2. Remove the two nuts which secure the EGR valve to the intake manifold assembly.
  3. Remove the valve and gasket from the manifold.
  4. Clean all gasket material from both mating surfaces.
  5. Check the vacuum hose for deterioration and replace as necessary.

To install:

  1. Inspect the exhaust gas passages in the intake manifold and clean as necessary. Clean the EGR valve assembly as necessary.
  2. Using a new gasket, install the EGR valve.
  3. Tighten the EGR valve securing nuts to 17-19 ft. lbs. (22-25 Nm).
  4. Install the hose on the EGR valve.f9ec12f.gif

Oct 22, 2010 | 1995 Subaru Legacy

1 Answer

My 1995 passat is overflowing collant put not overheating when i stop driving


any VW group car that has the rad drained MUST be vented of air when at operating temp,undo the top heater hose when hot and vent......(wear rubber gloves)

Oct 14, 2010 | 1995 Volkswagen Passat

1 Answer

I have a mis with my 1995 cadillac eldrado


Pull off the EGR valve and cea the carbon off of it next put a hose on the vac port on the egr and **** on the tube does the egr pintal valve open up? if yes then te egr valve is working, once the egr valve is open put the tip of your toung on the hose and see if it stays open if it does not then the EGR valve is defective. Aslo the fuel trim is affected by EGR vavle hope this helps and thanks for using fixya

Jul 03, 2010 | 1995 Cadillac Eldorado

1 Answer

1996 VW Passat VR6 is overheating, upper hose is hot, lower hose is cool, fluid is not leaking out. What do you recommend?


Thermostat is most likely. Try that first, then my next choice would be water pump. Good luck.

Mar 14, 2010 | 1995 Volkswagen Passat

1 Answer

Intermittently won't hold idle and stalls


The symptom you describe can be caused by either a bad or dirty EGR vavle or a broken / defective vacuum line.

Try this
1. disconnect and plug off the EGR vacuum supply line

2. Connect a vacuum hose of equal size to the EGR valve.

3. Start vehicle

4. draw a vacuum on the line orally.

a. the engine should die or run really bad.

5. Restart vehicle and repeat checking for same result.

6. If EGR valve is performing correctly as stated in steps 4 and 5 thern you most likely have a bad / cracked / damaged vacuum line somewhere.

7. Reconnect original vacuum line to the EGR Valve

8. Locate source of Vacuum leak.

Jan 27, 2010 | 1995 Jeep Grand Cherokee

1 Answer

I have a check engine for a 1995 Toyota Corolla- diagnostic code 71...What is it and also what parts do I need? Thanks


EGR system malfunction. Check EGR circuit/switches. Check/replace EGR vacuum hoses. Check/replace EGR Vacuum Modulator. Remove and clean EGR valve. Test EGR valve by applying vacuum to open. If necessary, replace.

Nov 22, 2009 | 1995 Toyota Corolla

1 Answer

1995 Toyota Camry - Code 71 - failed emissions tests


replace the EGR switching valve and have the machanic clear the engine check light. I think it should help



Mar 25, 2009 | 1995 Toyota Camry

Not finding what you are looking for?
1996 Volkswagen Passat Logo

Related Topics:

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

yadayada
yadayada

Level 3 Expert

75807 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...