Question about 1997 Plymouth Voyager

2 Answers

1997 PLYMOUTH VOYAGER DRIVER WINDOW DOSNT WORK

HELP Driver's side power window stopped operating. It's not the fuse; you can hear it trying to work. Haven't pulled off the panel yet, but I'm imagining it's a gear or drum problem. Does anyone have special information on this problem regarind 1997 Plymouth Grand Voyagers? (Mine is an SE, 3.3, 6-cylinder). Thanks, Dave

Posted by on

  • 1 more comment 
  • storytym May 26, 2009

    Thanks for the post, Joseph.  


    To clarify, the window seems to be out of the track.   My wife was in the car when it happened, and she said the window kind of slowly descended into the door frame no matter how much she hit the "up" button.   I don't think it's a fuse, as you can hear the motor trying to raise the window when you hit the "up" button for the power window.   Is the window regulator usually at fault in a case like this, or is just the motor?
    Thanks,
    Dave

  • storytym Jun 04, 2009

    Thanks for the help. I ended up replacing the motor and the regulator. When I pulled off the door panel, the cable between the motor and the regulator upright was all twisted and gnarly--it had totally fatigued out.

    After installing the new motor and regulator, the window works perfectly.

    Thanks,
    DS

  • joseph_ramz May 11, 2010

    Does this mean the window fell out of track and is not going up/down,or is it stuck at the same point?I.e-closed or open?I have a feeling you could be in need of a window regulator assembly.

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 159 Answers

I agree with joseph. the window regulator is bad. it runs off of a cable system

Posted on Jun 04, 2009

  • edward80 Jun 04, 2009

    glad i could be of assistance

×

Ad
  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

So it was the culprit?that is a part that takes alot of wear and tear not just in your model-but in all cars and trucks

Posted on Jun 05, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Driver's side window not working


https://www.google.ca/search?q=1998+Plymouth+Grand+Voyager+power+window+relay&num=50&rlz=1C1ASUT_enCA578&espv=2&es_sm=122&tbm=isch&tbo=u&source=univ&sa=X&ei=yY5NU-irNIaCyAGIuIGADA&ved=0CFEQsAQ&biw=1920&bih=993

If it won't actuate from the passenger OR driver side you'll have to pull the door panel. It WON'T be a fuse, it's the motor unless you can hear it trying and something's broken in there.

Apr 15, 2014 | 1998 Plymouth Grand Voyager

1 Answer

Power window won't work 1998 plymouth grand voyager


if more than one power window not working you have blowed fuse or you have window on lock out mode on the master control switch on the driver side.if master window control switch on driver side wont work but 2 windows will work using their switch the master control switch on driver side is bad.

Oct 01, 2012 | 1998 Plymouth Grand Voyager

1 Answer

What will cause my guages to stop working on my 1997 plymouth voyager


theres a fuse box on inside the van on the drivers side and check the 10A fuse where it says radio there connected... change it see how it goes

Sep 06, 2011 | 1997 Plymouth Voyager

1 Answer

The cruise control is not working on our 1997 plymouth voyager, however the horn works and the air bag light turns off properly so I'm not sure if it would have the spring problem some of the other...


could be the plasic pipe has broken that supplies vacuum to the servo momted at top rear of engine on left[drivers]side. or a fuse has popped check ALL of them because some fuses feed other fuses and are not labeled as such on the fuse panels

May 08, 2010 | 1997 Plymouth Voyager

1 Answer

Power window not working


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. Then pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything.

Aug 14, 2009 | 1997 Plymouth Grand Voyager

1 Answer

Overheating and electrical issues


try a coolant sensor or a new van

Jul 20, 2009 | 1997 Plymouth Grand Voyager

1 Answer

The gadges in my 1997 plymouth grand voyager stopped working?


I Had The Same Thing Happen to Me in my 97 Ply. Grand Voyager,I Checked All THE Fuses and Tried to reset every thing by disconnecting the battery,still no help but being old school I just gave it a small whack atop of the dash board and everything started to work so if all else fails give it a whack and hope it falls in place might just be loose,hope this helps

May 11, 2009 | 1997 Plymouth Grand Voyager

1 Answer

1997 PLYMOUTH VOYAGER DRIVER WINDOW DOSNT WORK


I had this problem with mine, I have the later model after yours but if you remove the interior cover, and carefully pull back the plastic, you`ll see the motor, if you loosen the three screws just enough so the you can remove the two screws that hold the motor to the winder mech (watch out for the two square nuts that can fall out once you remove the two screws), You`ll probably find that the carbon brushes inside have stuck in a position where they don`t touch the commutator. Clean them up and operate them a couple of times and you`ll probably find that it works, however, Mine is still sluggish meaning that the brushes will be getting hot due to the current and they may fail again. I`ve found out that the window lift cables have to be replaced because even with the motor removed, the glass is extremely hard to move up and down. I`ve lubricated it and everything I can think of but the motor still finds it hard to move. I hope yours runs OK. Ian

Feb 19, 2009 | 1997 Plymouth Voyager

Not finding what you are looking for?
1997 Plymouth Voyager Logo

Related Topics:

454 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...