I cant get headlight assembly off
SOURCE: Removing Headlight Assembly on 2003 Ford Focus Ultimate Edition
Jack up the front of the vehicle. Secure the vehicle with at least once JACK STAND. Open the hood of the car. Remove the front grill. Remove the fasteners on the head light assembly that are located on the exposed inner fender and the one that was under the front grill. Lay on your back and look between the front fender and the head light assembly. You only have about 4 inches. Remove that screw. All screws are either Phillips or torks.
SOURCE: removal of headlight assembly on a 2000 ford focus
There are 2 screws on top and 1 below the headlamp. The top ones are
easy. You'll have to lie on your back to remove the bottom one as you'll have to reach up behind the bumper to get to it. It'll be close to the fender wall
SOURCE: 2004 ford focus headlight ajust ment
Your adjustment screws should be white nuts (adjustable with an allen wrench, or a socket, or a pair of pliers) located behind the headlamp assembly right up against the fender
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall. You only need to do this and the aiming for your low beams as your high beams are on the same bulb
Your headlights should also say VOR. When you turn on your headlights, aim them right at the mark that you put on the wall, with the brightest cutoff directly under the mark
SOURCE: My headlights need adjusting on my 2009 Ford
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
Testimonial: "WOW...! What a super cool website. Thanks for the help...."
SOURCE: how to replace a 2001 ford focus headlight switch
p, li { white-space: pre-wrap; }
Turn the engine off, open the hood, and disconnect the negative battery cable (--) with your pliers. Locate the power distribution box against the firewall on the driver's side of the engine compartment. Flip up the latch and remove the plastic cover. Determine which headlight fuse you want to replace. The 2001 Ford Focus uses four headlight fuses--one for each headlight. Fuse number 16 is for the passenger side low beam; fuse number 17 is for the driver's side low beam. Fuse number 26 is for the passenger side high beam; fuse number 27 is for the driver's side high beam. Grasp the fuse with your fingers and pull it straight out of its mount. Insert the new fuse in its place. Replace the plastic cover and reconnect the negative battery cable.
189 views
Usually answered in minutes!
×