Question about 1999 Chrysler 300M

1 Answer

Car had been running fine, went out the other day to leave and the car would not start, everthing came on but car would not turn over no check enjine light has ever been on

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Chrysler Master
  • 2,007 Answers

Clean and tighten battery cables, ensure that your battery is charged up. Make sure it is all the way in "park".

Posted on May 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

92 Toyota 4runner truck was running perfectly fine Later in the day went to start and the alarm just started going off and wouldn't turn off. Truck won't start even with keys turned in igniti


The alarm system somehow got activated , this is usually because the battery becomes discharged or disconnected try doing this:
Remove the key from the ignition
disconnect the negative battery terminal
put the key back in and turn to ON
exit the truck and leave door open
reconnect the battery terminal
get in and leave door open, if the alarm horn stays off it should start.

Dec 07, 2012 | 1992 Toyota 4Runner

1 Answer

I have a 2002 pontiac grand am 3400 It was running fine one day when girlfriend got home, went to leave again and it wouldnt start... Changed Starter, Changed Ignition Switch, Checked all fused I could...


Could ber the anti theft security system. These are known for turning off starters. Check out this link for info. http://vatspasslockpasskeysecurityhelp.yolasite.com/

Jul 01, 2011 | 2002 Pontiac Grand Am

1 Answer

Car turns over but will not run idles rough then stalls degreased engine was able to get running took for test drive ran fine went home let sit for couple of hours went to drive it again turns over but...


sounds like you got the thing wet....DO NOT PRESSURE WASH/STEAM CLEAN ENGINE COMPARTMENT.leave the hood up and hopefully it will dry itself out,or if you can start it, let it run for an hour at least on tickover with all electrics on and a/c on full.A NICE SUNNY DAY WOULD ALSO HELP.....

Aug 18, 2010 | 1994 Lexus GS 300

4 Answers

Car Won't run right and now not start


Check the gas it could be contaminated, Not to sould like a Wise guy but are you sude it 's not deisel fuel you put in.

Aug 03, 2009 | 1995 Oldsmobile Cutlass Supreme

2 Answers

92 Dodge Spirit Wont Start, think it is a fuel problem.


look at the transponder wire i had the same problem after trying everthing we found it to be the transponderwire.

Jan 24, 2009 | 1994 Dodge Spirit

2 Answers

1999 Pontiac Sunfire wont turn over


ok i had kinda the same problem. if your father or bf is decent with mechanics ask him to check any see if there is any spark if not tell him to check the cranksensor to c if there is an current going to it, also when u go to start the car is there a (theft system light that comes on in the dash and flashes if so, turn the key fully as if you were going to start the car but dont crank it and leave it be for about 15-20mins or until the light stops flashing. then turn the key off and try start again. the thing is that when u install a stereo into one of these cars theres a anti theft system that stops fuel from going to the injectors. thats why when u install a aftermarket stereo u are supose to get eh harness so that it doesnt engage the ats(anti theft system). and if there is no current going to the crank sensor cut the wire long enough to hood an extra wire to it and then hook it up to ignition fuse in the fuse box(inside the car) this will send a a current to the crank sensor so when u turn the key on it will start. this is only a temperary fix. just gives u enough time to pick up the money to bring the car to the garage and get it checked correctly. anything else just ask. Jeremy

Aug 01, 2008 | 1999 Pontiac Sunfire

Not finding what you are looking for?
1999 Chrysler 300M Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...