Power Window on passenger side not working

Rear Passenger Power Window Operation
The rear passenger power window switches receive battery voltage through the window lockout control circuit if the window lockout function is disabled. Ground for the rear passenger power window motors is supplied through normally closed up and down contacts of both the rear passenger power window switches and the driver power window switch. When the either rear passenger power window switch is placed in the down position, the power window motor down control circuit is switched to 12 volts and is applied to the down side of the rear passenger power window motor. Since the other side of the rear passenger power motor is connected to ground through the normally closed up contacts of both the rear passenger and driver power window switches, the window travels down. By placing the rear passenger power window switch in the up position, the polarity of the power window motor is reversed and the window travels up.
The rear passenger power windows can also be controlled from the driver power window switch.

Did you try pushing the lock out switch on the drivers master switch ?

Power Windows not working - CarGurus

www.cargurus.com > Questions > Honda > Accord

CarGurusOct 9, 2012 - Power Windows not working - I have a 2006 Honda Accord and thepassenger and back power windows quit working all at once. ... My key less entry doesn't work either after I replaced the master Window control unit. 6 out of ...

Passenger Power Window Not Working ' ClubCivic.com - Your Online ...

www.clubcivic.com > ... > Interior / Audio / Electronics

Oct 28, 2009 - My passenger side window is not responding to either the driver side orpassenger side switch. It is in the up position and wont go down.

Beings as everything that stopped working is on the passenger side, I'd think some wiring got disconnected or broken.

Sounds like a passenger switch malfunction.

Make sure the window lockout button is not depressed on the master window switch. This will turn off the other switches and not let them control there respective windows.

Power is supplied to all the windows from one fuse and one relay. So if the master switch operates the window than we know the fuses and relays are o.k. We know the master switch will operate the window so that tells us the window motor and ground side of the passenger window motor circuit are also good.

Which leaves us with a bad switch or no power to the switch. The passenger window switch gets its power to operate independently from the master switch window lockout button. When the button is off power is supplied to the passenger switch and allows the passenger to operate the window themselves.

The only thing you need to do is check for power at the passenger switch on the brown wire with orange stripe. If there is power there then you have a bad switch.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Inspect or replace the window lock and unlock switch on the drivers door power window switch. There is a lock and unlock switch that will disable the switches to the other power window in the Jimmy. Check to make sure that switch is in the unlock position to have the other power window switch to work.
Thank you for suing fixya and good luck.

u have to open the door pad for inspection of power winow motor and linkages

Replace the Driver side window switch. These have a corrosion issue.

2006 chrysler town and country passenger side window suddenly stopped working.
other windows work, sliding doors work as does rear hatchback.
fuses seem to be good.
might there be a safety switch that somehow got pushed that keeps the passenger window from opening?

The pass door window switch needs to be replaced.