Question about 1990 Toyota Camry

2 Answers

Vacuum lines to carby

I need a vacuum line map for the carby

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 22 Answers

The carby? What's a carby? The 2 available engines both have EFI, not a carburetor. Unless this is a non-usa car?

The vacuum line map is on a sticker located on the underside of the hood.

Posted on Jan 14, 2010

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 88 Answers

There is usually a diagran under hood 20 dollar manuel from oriely best bet

Posted on May 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need vacuum hose diagram 89 Ranger 2.3 liter fuel injected I have 6 points on hub need egr line need map sensor line. Does it split to at map sensor.Have air recirc valve pass side.fuel press vac good


The fuel pressure regulator and the MAP sensor need to have there own lines. Everything else can be spliced together. Put the check valve to the recirculation valve.

Sep 03, 2015 | Cars & Trucks

1 Answer

83 Chevy s10 with carbureted 4.3l. Need to know where vac lines go. Truck runs great but dies when put into gear. Any ideas. Holley 4150 carb. There is 3 lines from tc. Ones a vent, other 2 idk where to...


one will go to the distributor vacuum advance unit- one probably goes to the vacuum actuator on the transmission one may go to a vacuum damper unit attached to the carby to slow down the throttle plate return

Jul 20, 2014 | Chevrolet S 10 Cars & Trucks

1 Answer

Does map sensor have a vacuum line?


Yes, there has to be a vacuum line from the intake manifold. It measures intake manifold vacuum and converts it to a varying electrical signal to the computer.

Mar 27, 2014 | 2003 Dodge Dakota Club Cab

1 Answer

Need to know where the vacuum line goes when it comes out of the map sensor on a 1987 chevy blazer


From the map sensor to vacuum port on the front of the TBI unit somewhere near the fuel inlet and outlet lines

Sep 28, 2013 | 1987 Chevrolet S-10 Pickup

1 Answer

Where does the long (30 inch) vacuum hose from the Air cleaner hook on?


You should be able to hear a sucking sound from where the line is supposed to go. Probably on the base of the carby. You can spray a little aero start around where you think the leak might be ie: carby. the aero start will be sucked into the open vacume port & the revs of the motor will change. Sorry I don't know exactly where it goes.

Jun 29, 2012 | 1987 Ford Econoline

1 Answer

Exhaust pipe is blowing out a mist of black smoke


BLACK EXHAUST SMOKE IS A RICH FUEL MIXTURE.CAUSE BY WEAK SPARK IGNITION, FAULTY MAP SENSOR CHECK MAP SENSOR VACUUM HOSE AND ELECTRICAL CONNECTOR BECAUSE BAD MAP SENSOR WILL CAUSE RICH FUEL MIXTURE CHECK THE VACUUM LINE GOING TO FUEL PRESSURE REGULATOR, MAKE SURE FUEL PRESSURE REGULATOR GETTING VACUUM AT VACUUM LINE IF NOT LOOK FOR BROKEN OR DISCONNECTED VACUUM LINE TO FUEL PRESSURE REGULATOR, CHECK FUEL PRESSURE REGULATOR VACUUM LINE IF YOU SEE GASOLINE IN VACUUM DIAPHRAM TO FUEL PRESSURE REGULATOR REPLACE FUEL PRESSURE REGULATOR,CHECK THE EVAP CANISTER IF GAS SOAK IT WILL CAUSE RICH FUEL MIXTURE.

Aug 05, 2011 | 1995 Chevrolet Blazer

1 Answer

1993 olds 3.1 mfi i dont have vacum to the map sensor at idle if i give it gas then i do why ?


YOU SHOULD HAVE VACUUM AT IDLE TO MAP SENSOR.WIDE OPEN THROTTLE VACUUM WILL DROP. SO YOU NEED CHECK AND REPLACE ALL VACUUM LINES ON INTAKE MANIFOLD.THATS WHERE YOUR MAP SENSOR GETS IT VACUUM FROM.

Apr 20, 2011 | 1993 Oldsmobile Cutlass Supreme

1 Answer

Need 95 gmc jimmy vacuum diagram. I have a loose


THat goes to your map sensor. If you look very closely under your hood there will be a vac line diagram there

May 09, 2010 | 1995 GMC Jimmy

1 Answer

Daihatsu CB 60 carby diagram.


This is the autochoke version that should help you.

Feb 23, 2009 | 1992 Daihatsu Charade

1 Answer

RPM Inconsistent


you may have a vacuum leak recommend getting a can of carby cleaner and spraying it around the inlet manifold ( avoid the H/T leads as you can start a fire) and vacuum lines and see if the idle comes up failing that you may have a problem with a map sensor our yes te throttle potentiometer could of failed if this is not a vacuum problem you may need to go to the dealer

Dec 27, 2008 | 1991 Toyota Camry

Not finding what you are looking for?
1990 Toyota Camry Logo

Related Topics:

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...