Question about 2006 Hyundai Sonata

1 Answer

Blurry flat screen computer monitor Almost impossible to read. 17" Hyundai about a year old.

Monitor screen is blurry. Almost impossible to read. I would describe it as "glittery " Hyndai flat screen is probably about a year old. Embarq(dish network phone line) says it is not their problem. Thank you.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Have you tried upgrading your drivers? or changing the screen resolution?

Posted on May 26, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Hyundai Elantra that says my on board computer is not ready to be tested. Emission results are: readiness- fail, monitor comprehensive- not ready, monitor EVAP not ready,monitor O2 not ready.


Did you recently clear the trouble codes or disconnect the battery? Once all codes are cleared, the computer will not display systems 'ready' until they go through an evaluation cycle. Some of the systems require a certain number of drive cycles before they will display 'ready'. A drive cycle is usually starting the engine from a cold start (based on coolant temperature) and driving until certain conditions are met. I don't know what the requirements are for your car, but my 2003 pickup truck requires more than 10 drive cycles before it will make the O2 sensors and evaporative emissions 'ready'. Most states only require that a certain number of systems are showing 'ready' to pass emissions certification.

Oct 22, 2016 | Hyundai Motor 2002 Elantra

1 Answer

I replaced my Cat in my 2006 sonata 4 cyl.. Now my computer will not complete I have drove it for months and still wont complete .. How can I get it to complete ?? There is no codes coming up on scan


If you got a scan tool. Look at the I/M monitors menu and tell us which ones are on OK/Ready or Incomplete or N/a. Not all monitors will be OK they will have an N/A since your ECU may not monitor A/c charge status or Heated Catalyst. Or post a photo of the scantool screen.

Jan 16, 2015 | 2006 Hyundai Sonata

1 Answer

I have a Dell Dimension e521 desktop that has gone into energy save mode after I ran Norton security check.. Pressing any key or clicking the mouse doesn't do anything. The screen is black and says...


you may find you have the screen resolution set to high, try changing to 1024x768 and try again. if this works it means your monitor ain't up to the job of your better machines.

Nov 15, 2013 | Cars & Trucks

1 Answer

P0068 map/maf throttle position correlation


Hi there:Here's the printout from the diagnostic tool. Year: 2006Manufacturer: ChryslerMake: DodgeModel: DurangoEngine Type: V8, 4.7LTransmission: AutomaticTrim Level: SLTMileage: 127555 KMs
=== Stored Error Code(s) ===Error Code: P2074Possible Causes: Manifold Absolute Pressure/Mass Air Flow - Throttle Position Correlation at Higher LoadError Code: P0068Possible Causes: MAP / MAF - Throttle Position Correlation
Freeze Frame Information:1. DTC for which Freeze Frame was Stored - P2074.2. Fuel System 1 Status - Closed Loop.3. Fuel System 2 Status - Closed Loop.4. Calculated LOAD Value - 74.51 percent.5. Engine Coolant Temp - 199.40 degrees F.6. Short Term Fuel Trim - Bank 1 - -3.91 percent.7. Long Term Fuel Trim - Bank 1 - -3.13 percent.8. Short Term Fuel Trim - Bank 2 - 0.78 percent.9. Long Term Fuel Trim - Bank 2 - -4.69 percent.10. Intake Manifold Absolute Pressure - 22.21 Inhg.11. Engine RPM - 2,404.00 Rpm.12. Vehicle Speed Sensor - 73.94 Mph.13. Ignition Timing Advance #1 Cylinder - 25.50 degrees.14. Intake Air Temperature - 64.40 defrees F.15. Absolute Throttle Position - 31.37 percent.16. Time Since Engine Start - 1212 Sec.17. Commanded EGR - 7.06 percent.18. EGR Error - 0.00 percent.19. Commanded Evaporative Purge - 62.35 percent.20. Fuel Level Input - 93.73 percent.21. Barometric Pressure - 26.35 Inhg.22. Control Module Voltage - 14.35 V.23. Absolute Load Value - 0.00 percent.24. Commanded Equivalence Ratio - 0.00.25. Relative Throttle Position - 0.00 percent.26. Ambient Air Temperature - -40.00 degrees F.
Monitor Information:1. MIL - OFF.2. Misfire Monitor - Complete.3. Fuel System Monitor - Complete.4. CCM Monitor - Complete.5. Catalyst Monitor - Complete.6. Heated Catalyst Monitor - Not Supported.7. EVAP Monitor - Complete.8. Secondary Air System Monitor - Not Supported.9. O2 Sensor Monitor - Complete.10. O2 Sensor Heater Monitor - Complete.11. EGR Monitor - Complete.12. NMHC Monitor - Not Supported.13. Nox Adsorber Monitor - Not Supported.14. Boost Pressure System Monitor - Not Supported.15. Exhaust Gas Sensor Monitor - Not Supported.16. PM Filter Monitor - Not Supported.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.
Thank you for using FixYa.

Mar 04, 2012 | 2005 Dodge Durango SLT

1 Answer

After clearing all im monitor codes and driving


No this will not. Computer has a keep alive . Evap and a.i.r. run on different schedules then other monitors.Usually EVAP is gas tank related.Have some smoke system to see if there are any leaks. In NY you can pass with monitor not running for that year truck

Feb 08, 2010 | 2001 Chevrolet S-10

1 Answer

Since new monitor, computer shuts down dislpys


try adjusting your herz default is 60hz most of the time

Have you tried a old display again and worked?
mabe just bad Monitor try on dif computer see if you have the same results.
another thing would to be update the driver for the video card mabe compat. issue with older card newr monitor

Dec 21, 2009 | Cars & Trucks

1 Answer

WHAT DIAGNOSTIC PROTOCOL IS USED ON i10 1.1ES


dear friend-your i10 has a obd2 plug and it is situated next to bonnet lever below the fuse box,a normal
GLOBAL DIAGNOSTIC SYSTEM monitor will be good to solve your problem.

Nov 02, 2009 | 2009 Hyundai Accent

2 Answers

Repalced battery as old one had dead cell the new battery was fitted and went flat have replaced starter and alt but still get flat battery have check all fuses and all are in woking order and to stage...


check the parasitic draw on the battery. If the draw is greater than 40 ma, something is causing the battery to go flat before it should. Recommend you monitor parasitic draw using a DVOM (Digital Volt Ohm Meter) and unplug one fuse at a time until you discover which circuit is draining the battery.

Apr 29, 2009 | Hyundai Elantra Cars & Trucks

6 Answers

Lexus sc430 tire pressure monitor


there is a reset button for the tpms either just above the accerlator or to the right of the glove box. press it and tah dah....you should be good to go.

Feb 08, 2009 | 2002 Lexus SC 430

Not finding what you are looking for?
2006 Hyundai Sonata Logo

Related Topics:

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...