Question about 2006 Triumph Tr 7

2 Answers

Clutch roblem I have a Triumph 900tt. Every time that I put the bike in first gear, it dies. It won't start in first either.

Posted by on

  • jeremy_deato May 25, 2009

    Tightening the cluch cable should fix it?

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Make sure that your side stand isn't down, or the side stand switch isn't busted, that will stop you moving off, if it is down or is busted.
Could be the clutch though not adjusted properly

Posted on Jun 05, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Triumph Master
  • 2,007 Answers

Your clutch isn't stopping the tranny. Can you adjust it? It needs to be tighter. I'm not much of a bike guy, and haven't owned one since i was a kid, but i know i could adjust the clutch cable.

Posted on May 25, 2009

  • Dar
    Dar May 25, 2009

    I would think so. Your clutch is dragging so when you put it in gear it kills it, and it won't start because it can't spin it good enough. I'm just guessing, but it's worth a shot.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Triumph st 1050 2010 Started bike and left running too long. Came back later to find bike had powered off and was very hot. Unable to start. No power with ignit ion on and red start switch on.


Try disconnecting the battery, wait a few minutes, reconnect it, and try again. If that doesn't work, then you will need to take it to a Triumph repaired for diagnosis.

Jul 08, 2017 | Triumph Cars & Trucks

1 Answer

99 Roadstar Dies when i put it in gear just changed the oil i have went fine, but know matter what ive checked keeps dieing


Are you sure you put the oil in the engine and not the transmission, check both the engine and trans dip sticks to make sure they are at the correct level.

Mar 17, 2015 | Cars & Trucks

1 Answer

I added fuel additive to my fuel had timing chain done 2 days ago now It won't idle it dies and runs real rough at high RPM's. If you put it into drive gear kills motor.


Sounds like a spark plug or wire issue. Anytime the vehicle starts to skip, die, or (run rough) its usually these minor things. However if that does not help, start looking into your fuel system. Always try cheapest first. Plugs and Wires....Good luck...

Jun 07, 2013 | Cars & Trucks

1 Answer

Sputtered out and now it won't stay running; dies when put in gear.


Mass air flow , crank sensor . I wouldn't discount anything . Having a scan tool that can view engine sensor data would be a great help too , testing fuel pressure and flow and back pressure test the exhaust .
058 Engine Hard to Start or No Start Lean Fuel Condition
055 Engine Hard to Start or No Start Scan Data for EGR
057 Engine Hard to Start or No Start Ignition Module Test
007 Catalytic Converter Testing



Jun 10, 2017 | 1999 Buick Regal LS

1 Answer

92 SL1 won't idle-wants to die without pushing gas-just put in new plugs


Remove, clean and inspect the idle control valve on the throttle body. These tend to clog up over time, or the stepper motor fails. Check this before anything else.

Nov 07, 2012 | Cars & Trucks

1 Answer

I have a rav4 that won?t go into gear once the engine is started. If the engine is off it will go into gear. So every time I have to stop I must turn off my car put it in first and then start it again....


Change the gear oil. If the gear oil is leaking get it fixed as soon as possible. If all the oil has leaked then it may have severely damaged the gear box.

Aug 17, 2009 | 1998 Toyota RAV4

1 Answer

1979 Firebird Esprit hard to start and keep running, dies in gear


it sounds like timing to me if it dies when you put it in gear.it can idle fine but when you put it in gear and it dies then you have timing problems

Jan 13, 2009 | 1979 Pontiac Firebird

1 Answer

1990 chevy full size van dies when you put in gear


check basics first - dist cap,rotor,plugs,etc.Then put a pressure gauge on fuel line and check reading to specs for truck. you may need a fuel pump

Jan 11, 2009 | 2004 Chevrolet TrailBlazer

1 Answer

The engine dies when i put into gear 1st time but not after.


Sounds like idle speed motor may need cleaning, or replace. Doesn't cost more than $5-$10 for a can of throttle body cleaner, and some time, to pull it off & clean & retry before spending too much on other areas. Tuned up, and fuel filter changed lately?

Dec 31, 2008 | 2001 Dodge Ram 2500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Triumph Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

luis

Level 3 Expert

500 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Are you a Triumph Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...