Question about 2001 Chevrolet Blazer

1 Answer

Fuel pump not pumping

New pump,filter, relay. oil pressure switch.disconected pcm for a few min and changed pump plug that came with new pump.just turns no startany advice.

Posted by on

  • jadamike May 25, 2009

    thanx i was not sure if i had one or where it was, i will check on that now.

  • jadamike May 25, 2009

    which side of the back panel will it be by the jack drivers side or passenger the only panel i seen was for the jack

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,055 Answers

Check for the fuel pump shut off ,in the rear pannel inside the truck!!!!!!

Posted on May 25, 2009

  • Dennis Mulford
    Dennis Mulford May 25, 2009

    if there is one it will be on the passenger side

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1992 Ford E150 has no power to fuel pump, inertia switch good, relays good, new pcm i am lost.


the pressure regulator controls the power requirement to the fuel pump
when pressure is reached , it allows power/circuit to the ECM to be broken which in turn stops the pump relay from working
when the pressure drops , that circuit is energized and the ECM switches on the circuit , to the relay allowing power to the pump to supply fuel to get the pressure back up
for the circuit operation you will need a schematics of the electrics for the vehicle ( workshop manual) as some may not use the ECM but go straight from the pressure regulator to the relay through a fuse

Jun 14, 2017 | Ford Cars & Trucks

1 Answer

I changed out my spark plugs... Spark plug wires... Distributer cap and rotor... Fuel pump and fuel filter and a new fuel pump relay and my fuel pump still will not work on my 1991 caprice.. Can someone...


I guess you know the ignition system is not connected to the fuel pump circuit.
The pump relay gets power from the key switch and the computer grounds the relay to power the pump. You get power for 3 seconds when you first turn the key on. Then you have to have oil pressure to continue powering the pump.
Have you checked the relay to see if it is working ?

Jul 25, 2013 | Cars & Trucks

1 Answer

I replaced my 97 s10's fuel pump checked the fuses &checked the relay & reset my computer changed my fuel filter disconected my security system & still can't get my fuel pump to co


The oil pressure sending unit could be bad. If your oil pressure gets below 7psi than it shuts off all power going to the fuel pump. It is screwed into the engine block just to the right of the distributor.

Oct 13, 2012 | 1998 Chevrolet S-10 Pickup

1 Answer

1998 chevy astro van sometimes works, sometimes not.? At timesm rarely, the astro will crank but will not start. Fuel pump not cycling and making its hum noise so I changed the fuel pump with an AC Delco...


When you first turn on the key, no crank, the fuel pump should run for a few seconds then stop. There shows to be an oil pressure switch in parallel with the fuel pump relay. It's just a redundant power supply to the fuel pump. Once it cranks enough to bring up oil pressure and the switch closes, the pump will run even w/o the relay. Both the fuel pump relay and oil pressure switch get voltage from the ecm b fuse.
At the fuel pump connector, check voltage and ground, when problem is ongoing. Gray wire is voltage--black wire is ground.
You could pull the fuel pump relay, use jumper wire between terminals on load side of relay. The load side is that line with arrow head, when energized that line moves to the other terminal. As you can see, the orange wire is hot all the time, the gray wire carries voltage to fuel pump. If it runs with jumper, then check control side of relay, the control side has to have voltage and ground, dark green wire with white tracer is voltage comes from pcm. The black wire is ground.
astro fuel pump-qgwxdgfz1nju2hdotm0lfflo-4-0.jpg

Mar 13, 2017 | Chevrolet Astro Cars & Trucks

1 Answer

Will start if i put gas down the port/carb seems to have fuel press at test port,,changed the rotor/dist. cap,don,t allway have fuel press may be the knock sensor ?shutting it down. it was hard startind...


sounds like fuel pump relay. next time it want start pull the ecm bat fuse for a few seconds see if it will crank then. knock sensor will not cause this. ecm bat fuse it works the fuel pump relay,fuel pump,injectors,ignition system an the pcm. also the oil pressure switch will shut down the fuel pump if oil pressure drops below recommended pressure . check the connectors on these things that not loose or corrioded.i think you will find the fuel pump relay is what this relay is the problem. this relay maybe in dash or under hood in the relay box.

Dec 11, 2010 | 1997 Chevrolet S-10 Pickup

2 Answers

No fuel delivery to eng., no voltage spurratic


Oil pressure switch activates the supply pump. Replace the oil pressure switch.. New & Need good rating please.

Jul 31, 2010 | 1998 GMC Jimmy

2 Answers

What other problem other than the fuel pump could stop the fuel flow


STOPPED UP FUEL FILTER - RESTRICTED FUEL FUEL LINE.OR BROKEN FUEL LINE.

Jun 18, 2010 | 1996 Chevrolet S-10 Pickup

2 Answers

Ive got a 1997 cavalier it will start but quickly dies out ive got fire to my plugs and fuel to the injectures ive just replaced the ignition switch is there somkind of a security


You need a new fuel pump relay. The engine fires up and runs off the oil pressure switch untill the oil pressure PSI is reached at normal operating conditions. When the oil pressure reaches its operating PSI the PCM or engines computer will shut off that circuit and turns on the fuel pump relay to run the fuel pump untill you shut the engine off

Apr 19, 2010 | 1997 Chevrolet Cavalier

4 Answers

1998 5.9 jgc cranks but wont start.starts with a shot of ether,is this bad fuel pump


could be the pump? or the pump relay? or even a clogged fuel filter crack the line going into the rear of the filter and crank the motor if fuel comes out ? change the filter if no fuel then? check the relay and or change the pump

Jan 21, 2010 | 1998 Jeep Grand Cherokee

1 Answer

I own a 2002 GMC Sierra 3/4 ton. I have cleaned the injectors, changed fuel filter, changed oil and filter, replaced tires, but she is still fluttering and then dyeing. The RPM's drop and it feels like I...


hello,
You have a bad oil pressure switch. I know that sounds strange but It feeds the fuel pump. Some times randomly the PCM does a self check and shuts off the fuel pump relay when it does this it runs off power from the oil pressure switch. The easiest way to confirm this as a diagnosis is to unplug the fuel pump relay when the engine is running. If it dies when you unplug it thats it. if not you will probably need a fuel pump or possibly just a cap and rotor (tune) but I belive it is the oil pressure switch.

Roy

Nov 13, 2009 | 2002 GMC Sierra

Not finding what you are looking for?
2001 Chevrolet Blazer Logo

Related Topics:

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...