Question about 2004 Dodge Caravan

1 Answer

Diy waterpump replacement 04 dodge caravan

Water pump replacement told buy dealer there are stains on pump if need to replac how and what is the proceedure. I do most of my own repairs

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

Try these two websites to see if they have you van listed if they do you be able to get pictures and diagrams showing you how to repair your van and the other one is and try your your local library and get your hands on a Haynes auto repair manual for your van

Posted on May 25, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to replace a bypass nipple on the water pump housing

How do I change the bypass hose? - DodgeTalk : Dodge Car Forums ... > ... > 2G Dodge RAM - General Talk
Mar 9, 2008 - I usually change the bypass hose every time I have the pump off for this very reason. ... Edelbrock ProFlow,52mm TB,180* t-stat,e-fans, pacesetter long tubeheaders, ..... Dodge B-Series Vans 1971 - 2003, Dodge Caravan/Grand Caravan ....DuoWing, Dodge Caravan General Talk, 1, 04-14-2007 09:46 PM ...

Aug 26, 2015 | 2000 Dodge Grand Caravan

1 Answer

I have a 3.8l grand caravn and it's leaking antifreeze from the part that the lower rad hose is conected to. i'm assumeing that it's the water pump.


Mar 04, 2011 | 1999 Dodge Caravan

1 Answer

Need to know where the waterpump for 1994 dodge caravan is and how to remove and install it

The water pump is driven by the timing belt, the timing belt will have to be remove to install the water pump, if you have never done this type of job, I would paid some one that has, it a very intens job, or best to buy a repair manual.

Dec 01, 2010 | Dodge Caravan Cars & Trucks

1 Answer

What is the general time to replace a waterpump on a 02 2.4l dodge caravan

Remove and replace water pump pre Mitchell labor time 3.8 hrs.

Jan 16, 2010 | 2002 Dodge Caravan

2 Answers

How do i get the waterpump out after unscrewing the bolts dodge caravan 05

it should just come out take new one and look at it to make sure have all the bolts out some have hard to see bolts

Aug 09, 2009 | 2004 Dodge Caravan

2 Answers

Replacing a 2005 dodge caravan water pump

undo the front motor mount with engine on a jack to support motor the let jack down or up to gain needed clearance to put new pump in

Jul 27, 2009 | 2000 Dodge Caravan

1 Answer

Water pump bearing went out. leaking water need to see manual on how I can replace waterpump

Difficult to get to but not complicated to replace. Remove housing bolts, clean the surface, (engine side) then put on new one with gasket if applicable. Tighten botlts in sequence slightly so as not to warp new waterpump...they are made of cast aluminum, (pot metal), and if you individually tighten, you run the risk of warpage and developing a leak. This is an easy fix...but in a tight spot.

Jun 19, 2009 | 1993 Dodge Caravan

1 Answer

99 dodge caravan 3.0 water pump

it is located on pass side behind timing cover the timing belt runs the water pump so the timing belt will have to come off this is a big job!

Feb 01, 2009 | 1999 Dodge Caravan

1 Answer

1997 dodge caravan waterpump replacement

OK, disconnect neg battery cable, drain cooling system, remove splash shield under right front fender for easy access to water pump bolts, loosen clamps and disconnect hoses from pump, remove drive belt, remove water pump pulley bolts, remove pulley (tip: loosen bolts on pulley before removing belt), remove water pump bolts (5) , separate from the front cover, clean the bolt threads and the threaded holes in the front cover to remove any corrosion and sealant, remove and discard o ring and clean mating surfaces, careful not to gouge or scratch mating surfaces, install new o ring into the groove, install the pump to the front cover and tighten to 105 INCH pounds, pulley bolts are 21 FOOT pounds.Good Luck! countrycurt0

Oct 05, 2008 | 1997 Dodge Caravan

Not finding what you are looking for?
2004 Dodge Caravan Logo

Related Topics:

821 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides