Question about 2005 Nissan Frontier

1 Answer

Oil circulation problem

NISSAN FRONTIER 4X4 oil entering from the turbo to the intake monifold,the oil is leaking where the monifold bolted unto the engine ,also there is smoke coming from the tail pipe after starting the engin in the morning ,what could be the possible causes?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 166 Answers

The possible causes of the oil leak has to do with the PCV. See more on this in this diagnostic article:
http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Oil_Leaks_Into_Air_Filter_Housing_Air_Filter.htm

The exhaust smoke in the morning is due to engine flooding, as noted in this article:
http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Emission_System_Black_Smoke_Exhaust_Exits_Tailpipe.htm

Brad

Posted on May 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can you determine if your oil leak is coming from your turbo on a 2002 volvo s60


Do you have a external leak or does your engine oil drop but you can not see a leak. My S60 had a leak and it was from the return pipe from the turbo to the sump.You can remove the belly plate and look from the bottom at the back off the engine.You will see the return pipe at the bottom of the turbo. If it does not leak at the there the turbo might be worn and it is blowing the oil into the intake.To check remove the intake hose and check for excess oil in the intake system.

Apr 18, 2015 | 2002 Volvo S60

1 Answer

How do i remove yhe lower control arm on a 2008 Nissan Frontier 3.0l turbo diesel?


You need to loosen the torsion bar adjusting bolts until all the tension is removed, remember to mark a reference point from bar to frame so you can get close to the correct riding height after reassembly. Can't tell if you split the ball joint from the knuckle from your explanation but a couple of good solid whacks to the lower knuckle will unlock it. Mark & remove the control arm bushing bolts and use a pry bar to push out arm @ bushings.

Aug 19, 2014 | 2006 Nissan Frontier

1 Answer

Nissan frontier 2005 2.5 liter eng. head torque specs.


Is there a diagram for head bolt sequence nissan frontier 2005 2.5 yd25 turbo diesel?

Jun 10, 2013 | Cars & Trucks

1 Answer

Nissan frontier starter binds the flywheel


You need to put shims in between the starter and the engine block.You should be able to pick them up at your local auto parts store.

Oct 31, 2012 | Nissan Frontier Cars & Trucks

1 Answer

Turbo oil leak into engine


if the turbo is leaking oil into the engine then you have an internal engine problem. the turbo works off of the engines exhaust , therefore if oil is getting back into the intake from the turbo then it is coming from the exhaust. posible worn piston rings or bad valve seals. it also could be a bad turbo bearing and seals letting engine oil leak into the turbo from the turbo oil lines from the engine and blowing back into the intake.

May 26, 2012 | 2007 Toyota Quantum 2.7

1 Answer

Where is and how to change the cranck sensor on 2000 nissan frontier 3.3 4X4.


Hello shalom570,

The crank position sensor is on the rear left-hand side(drivers side) of the engine. See image below.

netvan_185.png

To replace follow steps outlined below.

1. Disconnect crank position sensor harness.
2. Loosen and remove the bolt securing the sensor.
3. Remove the sensor.

To install revers process.

Regards,

Jerry

Aug 20, 2011 | 2000 Nissan Frontier

1 Answer

How to replace oilpump in 2003 nissan frontier. 4 zyl. 4by4 manual shift


hey hit me back in the comments if picts don't load 4L Engine 7924vg43.gif

Align the punch mark with the oil hole before oil pump installation-2.4L engine
Click to Enlarge 7924vg44.gif

Oil pump exploded view-2.4L engine
Click to Enlarge

  1. Before servicing the vehicle, refer to the Precautions Section.

  2. Set the engine to Top Dead Center (TDC) of the compression stroke for the No. 1 cylinder.

  3. Remove or disconnect the following:

    • Distributor cap

    • Distributor

    • Engine under cover

    • Stabilizer bar

    • Oil pump and drive spindle

To install:

  1. Fill the pump housing with engine oil, then align the punch mark on the spindle with the hole in the oil pump as shown.

  2. Install or connect the following:

    • Oil pump and drive spindle. Tighten the mounting bolts to 96-132 inch lbs. (11-15 Nm).reverse procedure on other componets Start the engine and check for leaks.Check the ignition timing and adjust, as necessary.

Dec 12, 2010 | 2000 Nissan Frontier

1 Answer

86 nissan pickup 3.0 5speed 4x4 and i got oil in the water and none visible on the dipstick though,,,i also seem to have lost oil pressure but the light isnt on just low guage and when i got home valves or...


SOUND LIKE INTAKE MANIFOLD LEAK.ANTIFREEZE WILL GET IN CRANK CASE DILUTE ENGINE OIL CAUSE VALVE LIFTER NOISE.TAKE VECHICLE TO RADIATOR SHOP OR GARAGE.LET THEM PRESSURISE COOLANT SYSTEM CHECK FOR INTAKE MANIFOLD LEAK AND HEAD GASKET LEAK.

Dec 10, 2010 | 1986 Nissan Pickup 4WD 1986

1 Answer

2008 nissan frontier oil filter location


Look under the front of the truck. You will see a square removable plate with 2 bolts in it...inches from where the radiator sits. Remove those bolts and you will have access to the filter.

Apr 15, 2010 | 2007 Nissan Frontier SE Crew Cab

1 Answer

Rear engine oil leak....


Oil leak can be attributed to several factors.
1. Gasket failure.
2. Uncontrolled Crank case pressure Failure.

RECOMENDATION:
Tighten both the valve cover and oil pan bolts.
Replace the Positive Crankcase Ventilation Valve and vacuum line.,

INFO: PCV
This is a valve causes a negative vacuum on the engine while its running, As to say if it had a leak in a valve cover it should not be leaking while its running, only when the engine it turned off.

Hope this tip guides you in the correct direction to solve this problem.

R/
David

Mar 05, 2010 | 2001 Nissan Frontier Crew Cab

Not finding what you are looking for?
2005 Nissan Frontier Logo

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...