Question about 1995 Chevrolet Blazer

1 Answer

Stuck in 4 wd low

Blazer was switching to 4 wheel drive on its own, while going down the road. I put it in 4 wd low, and now it won't come out. (Yes, I have tried putting it in neutral with my foot on the brake.)

Posted by on

  • deepelem67 Jun 02, 2009

    It turned out it was the switch, which cost about $55. Pulled the old one out of the dash, plugged the new one in...Fixed. Thanks

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 41 Answers

Try backing it up first and make sure nothing is jamed in the linkage

Posted on May 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I get my 1996 Chevy Blazer out of 4 wheel drive? It is stuck.


If it is electronic push button I would go down on side of transfer case and check the control module. It is common for them to go bad. I have taken them off and taken a wrench and taken them manually out of 4 wheel drive to get them home. Module is on Driver side of transfer case. Make sure your dash switch is good, however that module would be my guess. You also have a plunger in the front axle that engages the 4 wheel, that locks the hubs check that as well.

Jan 04, 2015 | 1996 Chevrolet Blazer

1 Answer

My 4 wheel drive will not ingage into 4 wheel high, only 4 wheel low. I have replaced the dash switches and the thing on the transfer case . what else can I do ?


If you can't get 4 high, then you can't get 4 low either. You can get the transfer case to go into 4 low, but unless the front axle is engaged, you will still be in 2 wheel drive. There is a vacuum switch that engages the right front wheel. The left wheel is engaged full time. On earlier models, this vacuum switch is located unerneath the battery tray. It is prone to become disconnected from the vacuum line. Check this and all other vacuum lines that are connected to the 4wd system. The way I test my 4wd Jimmy is to find a dirt or gravel road or parking lot and accelerate hard from a standing start in both 4hi and 4lo. If 4wd is not engaged your back wheels will spin.

Dec 16, 2010 | 2003 Chevrolet Blazer

1 Answer

When drivingtruck in 2 wheel drive the 4 wheel low light will flash and when slow truck down to a stop it will shift into 4 wheel low and will not go back to 2 wheel high


Sometimes the solenoids will stick on the axle neither in 2 or 4 wheel drive, if this problem started when you weren't shifting between two and four wheel drive it is probably the push button switch cluster on your dash going bad

Dec 12, 2010 | 2000 Chevrolet Blazer

1 Answer

Stuck in 4 wd,


its probly the 4 wheel drive actuator

Jul 03, 2010 | 2001 Chevrolet Blazer

1 Answer

Won't shift out of 4 wheel drive low


modulator stuck or damaged located at transfer case take a rubber mallet and hit around where modulator and case connect than try to shift again if nothing than un bolt and lube and move actuator rod, with out try to move electronically w/switch back to 2 wheel drive -if moves should work can replace but look for replacement as back up if happens again just change over

Oct 05, 2009 | 2001 GMC Yukon XL

1 Answer

1991 S-10 Blazer 4x4 4.3


you need to pull the switch out of the dash and look behind the swict hfor the actuator, chances are the stud that touchs the actual relay is broken use a pen or something slender and long to push it to the desiref position, other than thats go to a junk yard and look for that switch, should just pop out with a lil prying..

May 19, 2009 | 1986 Chevrolet S-10 Blazer

1 Answer

4 wheel drive not working


Vacume lines or vacume switch on transfer case,or vacume pod to front axle.

Jan 05, 2009 | 1993 Chevrolet S-10 Blazer

1 Answer

1993 Chevrolet S-10 Blazer won't go into 4-wheel drive


no fuse...mine was stuck in low and i had to replace vacume hose in the transfer case about 200.00 bucks

Dec 29, 2008 | 1993 Chevrolet S-10 Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...