Question about 2002 Toyota Prius

1 Answer

2003 Prius sometimes will not start, engine light comes on. Removing key from ignition, reinserting key, & turning wheel till it locks will then allow the car to start. Engine light stays on for a

2003 Prius sometimes will not start, engine light comes on. Removing key from ignition, reinserting key, & turning wheel till it locks will then allow the car to start. Engine light stays on for a day or so, then all is normal. Happens only on first start when it's cold or wet

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

I had a wire connector on the front of the engine that had so much tension, the wires broke. I didn't notice until a wet day when the car wouldn't start (and the Check Engine light was on). (The error code was related to an Emissions error.) The connector is located on the engine, front, just left of center. Hope this helps!

Posted on Jan 12, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Unable to turn the key in ignition...a little play in steering wheel, but key refuses to turn


Trying smacking the shifter hard to the park position which it is already. There is a lock that stops the ignition from unlocking if the gear selector not getting into the P position all the way.

Oct 18, 2014 | 2005 Dodge Dakota

1 Answer

Kia 2005 Amanti: Electronics go black and reset to 12:00 and Jan 1. Removing key and trying again in neutral or with open driver door sometimes works and other times doesn't.


cud hav computer or module issues--a readout scan shud b done-it shows voltages that a tech can decyfer------try using anothr key-chip cud b worn---------or disconnect batt a few --------or pull plug on computer and clean it-pins get dirty-----may reboot to normal--------go to a private shop for scan-not a dealer

Dec 11, 2013 | 2005 Kia Amanti

2 Answers

Gear noise left front 2008 prius sound like a tire rubbing against a plastic fender but it is not and the faster you go the louder it gets . Even worse when you steer to the right. And quite to the left.


It's most likely a bad left front wheel bearing or possible tire noise, switch the left front tire with the rear tire and see if the noise changes. If not have the wheel bearing checked, it may need to be replaced.

Oct 02, 2011 | 2008 Toyota Prius

1 Answer

Ignition is locked, recently changed battery & now can not start truck. tried reseting alarm by unhooking battery, turned steering wheel also played w/ gear shifter to no avail. 2002 avalanche


Turn on the ignition with engine OFF.
Try to start engine, then release the key to ON
Wait 10 or more minutes till SECURITY TELLTALE turns OFF.
Turn OFF the ignition, wait 5 seconds.
Repeat this procedure 3 more times, it takes 30 minutes.
You must turn the ignition key OFF before starting the engine.
To be on the safe side OFF means take the key off, and hold on your hand for 5 seconds.
If you missed something visit GM dealer, and they gladly will provide you a print out of this procedure.

Sep 05, 2010 | 2002 Chevrolet Avalanche

1 Answer

Problem starting my 2003 dodge ram


no if you took it to autozone obviously you have a good ign coil.im sure you have tried turning the wheel at the same time you turn your key. other than that i would replace the lock cylinder and key.

hope2help shack

Apr 18, 2009 | 2004 Dodge Ram 1500

2 Answers

How to get key out that is stuck in ignition


Remove steering column shroud(cover)and tap ignition barrel with small hammer while twisting key backwards and forwards,also turn steering wheel backwards and forwards sometimes this is enough to release key as the locking pins in barrel and the steering lock pin do sometimes jam.You will have to remove steering column shroud to replace ignition barrel if tapping/hitting it doesnt work anyway so its not a wasted effort.Good luck,let me know how it works out

Nov 12, 2008 | 2003 Oldsmobile Bravada

1 Answer

Program ignition key to central locking on porsche 996 1998


Well, you can sometime catch the code again. Pt the key in the ignition and turn till the dash light come on (dont Start) then press and the Lock button while keeping the Lock button Pressed and turn the dash light off and put the key with the lock button Press for 10 second afterwards. If not successful first time try again. This should do it.

Oct 23, 2008 | 1998 Porsche 911 Carrera

5 Answers

2003 Prius Hybrid System Warning Light


My Toyota Prius hybrid warning light has come on three times in eight years. If I turn the car off for 20 minutes, the hybrid light is off but the check engine light is on. After a while, the check engine light goes off. I think this problem is related to moisture somehow entering the hybrid vent on the driver's side. All three times this has happened, the weather was wet. Kevin Cardiff

Jun 19, 2008 | 2003 Toyota Prius

Not finding what you are looking for?
Cars & Trucks Logo

384 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...