Question about 1999 Chevrolet Blazer

2 Answers

Replacing radio in '99 Blazer

How big of a problem is it to take out the dash so I can replace the radio....just purchased an original replacement.......thanks!!

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 23 Answers

Its not too bad. i did the same thing in mine too. there are 2 screws you need to take out from the dash panel under the steering wheel. then there are 2 that you need to take out that you can see when you take that first panel off. take out the screw behind the wheel that is right above the gauges. turn the key on and foot on the brake, tilt the steering wheel down. pop the dash panel out and disconnect your headlight switch, 4wd switch(if applicable), and rear wiper switch. move the panel off to the side. then there should be 4 screws holding in your radio.

Posted on Aug 12, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 37 Answers

The dash panel is snapped into place and the radio is either bolted in or snaps in.The problem is the radio,if original equipment,has to be programed by the dealer or it will not work.GM and others have done this to discourage theft.

Posted on May 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Installed a Sony Xplode into a 99 Blazer and everything on the radio works but will not play through the speakers


The Bose system is complex - it has an amplifier separate from the Bose compatible radio. This amplifier takes low level audio signals from the radio, not full driver outputs from a replacement radio, and by trying to use the replacement radio you may have blown the amplifier. If that is the case, you may not be able to go back to the original radio.
The only option you may have with the replacement will be to find the Bose amplifier and bypass the connections to feed the replacement radio outputs directly to the speakers. This may not be as simple as it sounds, as distribution to the various speakers comes from the amplifier, not the radio, and the wiring from the amplifier to the radio may not have all the wires you need. Before going on, you had better get a wiring diagram for the Bose system (service manual or Alldatadiy.com).

Jun 11, 2017 | 1999 Chevrolet Blazer

1 Answer

Dash lights dont work on my 97 blazer


All lights, or just your illumination lights? Illumination: bulbs need replacing. All lights; SERIOUS problem. There is a dash panel fuse on car. check that. Has anyone done any work recently under dash( like installing a radio)? May be they accidentally pulled a connector loose behind dash. Need to pull your instrument cluster to check that. Usually two big connectors with lots of wires going to back of instrument cluster. If no power at all with key on: check under hood at power distribution center for a main big fuse out.

Oct 12, 2011 | 1997 Chevrolet Blazer

1 Answer

How do i remove the dash of a 2001 chevy blazer to replace a heater core?


big job maybe you should buy a manual for that blazer, also label everything, the steering colum and every thing has to be removed before dash can be removed, good luck.

Oct 09, 2009 | 2001 Chevrolet Blazer

1 Answer

I had a wire running from my amp to the fuse box


You have obviously damaged neighboring wiring in the fuse panel. The reason the dash lights and radio is pulsing is because of feedback.

Sep 04, 2009 | 1999 Chevrolet Blazer

1 Answer

Replacement radio


no codes but not just any radio will fit in the dash, contact these folks for advice and help picking the right radio.

http://www.crutchfield.com/S-h7kThgkJtQZ/

May 12, 2009 | 1991 Honda Accord

1 Answer

A/C Head unit replacement on a 99 Beetle GL


Hi, there are 2 special keys inserted to radio and radio come out.I think you do not need to remove radio to replace a/c unit in beetle.

Mar 07, 2009 | 1999 Volkswagen Beetle

1 Answer

99 stereo out of a 99 CARAVAN


Hello,
Unfortunately you cannot hook this stereo up with out the original plug that fits into the stereo unit. Once you have that then you could buy an wiring adapter that will break out the wires out of the original harness with labeled wires and you can just match them up and tape them together.
Good Luck
Rich Lilja

Oct 01, 2008 | 2000 Dodge Grand Caravan

Not finding what you are looking for?
1999 Chevrolet Blazer Logo

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...