Question about 2004 Volkswagen Touareg

1 Answer

Touareg 04 rear driveshaft replacement

How difficult it is to replace the rear driveshaft. The only reason I am doing it, is because the center bearing braked is loose.
Regards
Alfonso E

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

By the labour book I use it says 2.9 hours to remove the driveshaft plus another .5 to change the bearing.

Posted on May 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do you replace rear oil seal in 1994 Isuzu Standard tranmission


Chockblock front wheels to prevent truck rolling, and jack vehicle up and place a jackstand under frame to prevent vehicle falling. Remove driveshaft, seal is now visible to be pried out for new one to be lightly tapped into place with a rubber mallet or hammer, along with a wooden block, taking care to keep new seal straight while replacing. replace driveshaft and check fluid level, lower vehicle and remove chockblocks.

Feb 13, 2015 | 1994 Isuzu Pickup

1 Answer

I have an 04 F 150 in the u-joint went out and I put a 99 F 150 driveshaft in it will it work I replace the whole rear driveshaft


It should if it's the same length and the caps are the same size and check the Centre bearing mount.

Dec 18, 2014 | Cars & Trucks

1 Answer

How do i change engine oil in 04 vw touareg


Hi. I suggest taking this vehicle into a workshop to change the oil. There are cover etc under the vehicle so is difficult unless th evehicle is picked up high.

Jul 13, 2014 | 2004 Volkswagen Touareg 4.2

1 Answer

I have a 2wd 2003 chevy s-10 extended cab short box pickup. The rear half of the driveshaft is starting to vibrate. I was told I had to replace the whole driveshaft, but I am finding it very difficult to...


You shouldn't have to replace the whole shaft. Go to auto Zone or Advance Auto Parts and tell them you need the Rear u-joint for the Drive Shaft of that vehicle and they should have it. The replacement process is a little tedious but can be done. Get the Haynes repair Manual on your vehicle, while your there at the Auto parts store, and look up the Drive Shaft. It will tell you how to remove, inspect and if needed replace the U-Joints on your drive shaft. If in fact for some reason, and I have never seen or heard of this, the U-Joints can't be replaced the Manual will tell you. Because they are usually pressed in on the shaft itself some say you have to replace the whole thing but they can normally be removed with a little muscle.

Aug 07, 2010 | 2003 Chevrolet S-10

1 Answer

Do we have to replace the whole driveshaft if the carrier bearing goes?


if its not scored on the machined end or out of round it will still be good to used

Mar 21, 2010 | 2005 Volkswagen Touareg

2 Answers

Rear drive shaft


sorry to say but that is true it comes as one piece it is a press fit into place. not the best design true but it is what it is.

Sep 10, 2009 | 2004 Volkswagen Touareg

2 Answers

Brake Pad Replacement,2004 VW Touareg,V6 instructions


yes, you need a piston retract tool for the rear cylinders. rear piston must turn clockwise as it is being retracting.

Jun 11, 2009 | 2004 Volkswagen Touareg

1 Answer

2001 Jeep Wrangler 5spd.... 2wd is out!


Either you have broken something inside the transfer case but equally likely is that you blew up the spider gears in the rear differential. I'd remove the cover and take a look. If they're broken, it won't be difficult to see.(smaller gears inside the center section) And, they are replacable
Hope that's all it is!
Good Luck!!!

Apr 01, 2009 | 1991 Jeep Wrangler

1 Answer

Replacing headlamp touareg 04


Instructions for halogen light replacement are here

http://files.mytouareg.info/%2A%20Touareg%20%2A/FSM%20%26%20Installs/Halogen_Headlamps_94-01.pdf

Jan 17, 2009 | 2004 Volkswagen Touareg

Not finding what you are looking for?
2004 Volkswagen Touareg Logo

Related Topics:

1,930 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...