Question about 1997 Mitsubishi Eclipse

1 Answer

Engine and transmission removal from 1997 Mistubishi Eclipse

I would like to know if it is possible to pull the engine and transmission out as one. If so, what are the steps start to finish? Any advice is much appreciated. Thanks.

Posted by on

  • its420_us May 11, 2010

    It is possible to drop them as one. Nobody is going to sit here and type a story book to tell you how to remove it. Buy a "haynes manual" for your vehicle, and read it. It will tell you the exact steps to take.

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

Is this front wheel drive? If so, the entire drive assembly comes out the bottom. You have to disconnect everything needed and raise the car off the engine cradle assy. I do it with Ford Taurus's all the time, even SHO's.

Posted on May 25, 2009

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 55 Answers

SOURCE: Pulling engine and transmission from 1997 Mitsubishi Eclipse

yes it is. they both drop out the bottom of the car. you will need a hoist and engine table

Posted on May 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

99 automatic volkswagen beetle reacently started to jerk. What woulde be the cause?


they are several problems, but the first step is get a scanner and check for codes, if there is a code follow the troubleshooting about the problem, that it can save some time.

Dec 17, 2014 | 1999 Volkswagen Beetle

1 Answer

Where do I add Transmission fluid on a 95 ford Probe??


So you know, I am not insulting you. I don't know what you know or what you don't know. From your symptoms, I'm confused. If you pulled the trani pan down and the trani dip-stick still read "Full", you pulled the wrong dip-stick. Your transmission takes Mercon and you will need a narrow funnel that will fit inside the trani dip-stick tube. Follow the dip-stick tube all the way to the bottom and verify that it goes to the transmission. When you pulled the trani pan down you should have four or more quarts empty into your drain-pan. Until you can confirm that the the trani is properly filled, don't continue to use the car. Running the engine while the trani is empty can damage internal componants. If you have any questions, please write back, good luck.

Apr 13, 2014 | 1995 Ford Probe

1 Answer

94 voyager is stuck in second gear. no check engine light


if you are not mechanical, or don't have the tools, like an engine horst, to work on this, my best advice is bring it to.a good transmission shop with these front wheel drive transmission, the engine needs to be supported to pull the transmission out sounds like a snap ring broke, or valve body needs a rebuild, it could also.be your governor not building up enough pressure, because when you shut if off, and start it again, your pressure builds up.again these front wheel drive transmissions are not fun to work on, so if your not familiar with these transmissions then it's best to.have a transmission shop fix for you

Dec 05, 2013 | 1994 Plymouth Voyager

1 Answer

How many litres of fluid will fill a 1991 holden rodeo transmission?


General advice:Relative
Manual transmission back dif 1,5-2l,front (gear box)3-3,5
Automatic:Over 4l.
Yet,u need to confirm with the dipstick (the one availabile or a rigid wire used as deepstick)
U may take note of what comes out before replacing.
Some transmission need to start the engine and run the trans then ceck level again.
I know is a general advice,but u must treat the cars as a innumerous marks/models and deal fine without factory specs.If not,u need owner manual,dealers visit,shop info,etc.
Cheers let others know if u done it.

Oct 27, 2013 | Cars & Trucks

1 Answer

I did a transmission and filter change on my passat. However i missed a step in d fill process causing my tyranny to be underfilled. Eventually after idling the engine and adding more atf. The transmission...


frist . you must .fil two to three liter , then start engine shift to revers , fill two liter while you are filing ATF observe the atf evel . this one will take 3 minute , untill finish . shift to parking , fix all plugs then start and check . if the atf is need to add you will feel late in ******* with knoking . all this case becuz of less ATF in torqe convertor insinde and this will fill only when runing

Jul 27, 2011 | 2000 Volkswagen Passat 4Motion

2 Answers

I need a step by step on replacing a radiator on a 1998 Mercury Mountaineer V8 5.0 with automatic transmission.I would like help on this exact SUV please anybody know????


its very simple. just remove the top shroud. then there should be two bolts on top holding the radiator secure, remove any fans, pull back the hoses, there might be some ol lines to the radiator (pull those to) everything goes back the same way

Nov 19, 2009 | 1995 Buick Skylark

1 Answer

Just started to pull away from a stop in 1st and


sounds as though your input shaft broke, this would cause a loud clunk, cause it to feel as though in gear, and cause no pull.

Oct 26, 2009 | 1988 Nissan Maxima

2 Answers

Pulling engine and transmission from 1997 Mitsubishi Eclipse


yes it is. they both drop out the bottom of the car. you will need a hoist and engine table

May 24, 2009 | 1996 Mitsubishi Eclipse

Not finding what you are looking for?
1997 Mitsubishi Eclipse Logo

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...