Question about 1989 Toyota Camry

1 Answer

How replace transmission seal, gasket and filter

How do you replace a transmission seal, gasket, and filter on a 1989 Camry? It's not a Solara. What should it cost to fix if I can't do it? Los ANgeles

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 316 Answers

If you can pull and replace your trans yourself, you can get your drive axle seals, main seal, filter and gasket for $100.00 or less.

Posted on May 24, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i drain the transmission fluid in camry


A/T?

some have drain others not.
why not get a full flush with filter.
avoid Jiphphyboobs.
go to a real shop with real ASE techs, and bingo a real fuse.

when you drain the pan about 1/3 comes out.
so if its filthy ATF, that dont cut the mustard.
worst case.
to do it right, you, drop the pan, (big huge flood) and then
replace the filter.
they put the new gasket, and seal it up and do
a full flush with the special machine, that replaces all ATF fluid.
(2 tanks and pump on a cart)
its not cheap but automatic shifting is a luxury. so you must pay.
not doing it right , invites low transmission life.
do it at the 60k mile service point.
(ignore all EPA bs to contrary)

Feb 12, 2014 | 1992 Toyota Camry V6

2 Answers

Change transmission oil


Hi Peter, If your Camry has an automatic transmission, for normal driving the auto fluid should be changed every 40,000km, there should be a drain plug on the transmission pan that takes a 10mm hex drive or 17mm socket to undo. You have two choices after driving the car onto ramps or jacking up and supporting on jack stands so you can safely get under the car. 1 - You can loosen and remove the transmission drain plug to let the auto fluid drain out into a container (careful not to lose the sealing washer) refit and tighten the drain plug and washer again. Remove the auto transmission fluid level dip stick, using a suitable funnel pour about 2.5 litres of suitable new auto trans fluid back into the transmission via the dipstick tube (I believe they take dexron 2 of 3 type fluid). Start the car and move it onto a level surface. With the engine running, handbrake on and brake pedal applied, shift the transmission from park through every gear selection slowly into 1st gear, then back to park. Leave engine running. Wipe the dip stick & insert it back into the dip stick tube fully, remove and check where the fluid level mark is on the end of the dipstick. If the fluid level indicates low or does not show at all, add 100ml of additional fluid and recheck the level till the fluid reaches the full mark on the dipstick. 2 - The second option is everything in the first option but includes replacement of the transmission filter and pan gasket. I would only do this if the car had travelled high km or the pan gasket was leaking. At the point where you've drained the old fluid into a container and refitted the drain plug and washer, remove all the transmission pan bolts and the transmission pan. If you have the time to let the fluid drain overnight prior to removing the pan it's a good idea because once the pan is removed, fluid will continue to drip from the transmission. You'll need to remove the old pan gasket, some may be stuck to the pan and or transmission, a razor blade type gasket scraper can be good for this but be careful not to scratch either surface when cleaning off the old gasket. Remove the bolts/nuts that hold the transmission filter onto the bottom of the transmission. Careful caus more fluid may drain out of the transmission or filter once removed. Fit the new filter and filter tube gasket & bolts/nuts, careful not to over tighten. Fit new pan gasket, pan and bolts. Continue with fluid filling procedure from option 1. I would suggest you only use option one and remember to double check the drain plug is tight. Also, remember to dispose of the old fluid correctly. Cheers

Nov 30, 2013 | 1993 Toyota Camry V6

1 Answer

1997 camry ce 1mz v6


Almost certainly it is coming from the rear bank cam cover gasket, for which leak the Camry V6 is notorious. Other common places are the distributor shaft o-ring seal, the crankshaft nose seal (replaceable), and the oil filter adapter bracket (if fitted)

If you get the cam cover gaskets done, specify Toyota parts, as the aftermarket parts don't last, they harden quickly.

Nov 07, 2013 | 1997 Toyota Camry

1 Answer

1989 ford bronco C6 transmission leaking fluid at manual shaft


I have a 1989 Ford Bronco 351 w with a C-6 Transmission. I just did a transmission service, replacing the gasket and filter. Now my transmission is leaking when the bronco sits for a few days.Help!!!

Aug 08, 2012 | Ford Bronco Cars & Trucks

1 Answer

How to fix a front leaky oil seal in a 1995 Toyota Camry LE


Three seals to check. easiest is the valve cover seal. Number and remove the 4 wires going into your spark plugs. remove 4 nuts holding the cover and replace seal.
Next easiest is the distributor O-ring. Remove air filter assembly remove the distributor cap, then the distributor. With the valve cover still off, loosen the 2 bolts that clamp the distributor down. Remove the 2 terminal leads going into the distributor (4 wire terminal/2 wire terminal) Mark the case of the distributor and the case of the head with one line so you can line it back up on reinstallation. remove the 3 bolts holding the distributor down. Replace O-ring. replace distributor, align, tighten the 2 bolts, then tighten the 3 bolts. replace terminal wiring and cap. replace air filter assembly. Replace valve cover with new gasket. Place spark plug wires back into their proper places. The last one is the oil pan gasket. Drain all oil and remove all blots holding the pan. drop the pan and replace the gasket. Put it all back into place. Do not over tighten the pan bolts as this will cause the gasket to deform, making it leak again.

Nov 22, 2010 | 1995 Toyota Camry

1 Answer

Trying to remove oil pan from 1989 chevy 1500 350 eng to replace the gasket can you help me?


2wd Models
  1. Disconnect the negative battery cable. Drain the engine oil.
  2. Remove the oil dipstick.
  3. If necessary remove the exhaust pipe crossover.
  4. If equipped with automatic transmission, remove the converter housing pan and the transmission oil cooler line retainer from the bracket.
  5. On 1996-98 models, remove the oil filter and if equipped, the oil filter adapter.
  6. If necessary, remove the starter brace and bolt and swing the starter aside.
  7. Remove the strut rods, if equipped.
  8. Remove the oil pan and discard the gaskets.
To install:
  1. Apply a suitable sealant such as GM part number 12346192 or its equivalent to the front cover-to-block joint and to the rear crankshaft seal-to-block joint. Apply the sealant about 1 inch (25mm) in both directions from each of the four corners.
  2. Clean all gasket surfaces and use new gaskets to assemble.
  3. Install new gasket and seals.
  4. Install the oil pan.
  5. On 1988-95 models, tighten the pan bolts to 100 inch lbs. (11 Nm). Tighten the pan nuts to 17 ft. lbs. (23 Nm).
  6. On 1996-98 models, tighten the oil pan nuts and bolts to 18 ft. lbs. (25 Nm).
  7. Install the strut rods, if equipped.
  8. If removed, install starter, starter brace and bolt.
  9. If equipped, install the oil filter adapter.
  10. If removed, install the oil filter.
  11. If equipped with automatic transmission, install the converter housing pan and the transmission oil cooler line retainer to the bracket.
  12. Install the exhaust pipe crossover.
  13. Install the oil dipstick.
  14. Fill the engine with oil and check for leaks.

Aug 07, 2010 | 1989 Chevrolet S-10 Blazer

1 Answer

Should i replace my dead transmission in my 200k Mile 1994 Toyota Camry with a junk yard replacement? Is it a good idea or just another bad gamble


thats fine, but check the mileage of the junk vehicle. Also FULLY service that replacement transmission Oil, Filter, Seals..etc

May 22, 2010 | 1994 Toyota Camry

1 Answer

Leaking oil?


List of possible locations for engine oil leaks:

Valve cover gasket
can,crank and oil pump seals.
rear main seal
oil pan gasket
Transmission oil leaks
Vents, dipstick,torque converter ( need to examine shell to pin point whether its the oil pump or a converter seal)transmission gasket,axle seals, drain plug.

May 21, 2010 | 1994 Toyota Camry

2 Answers

1989 Camry Le V6 sluggish in acceleration, I have installed new plugs and wires


YOUR FUEL FILTER COULD BE STOPPED UP OR TRANSMISSION IS SLIPPING DUE TO LOW FLUID OR DIRTY STOPPED UP TRANSMISSION FILTER OLD FLUID.YOU COULD HAVE WORN CYLINDERS AND RESTRICTED EXHAUST SYSTEM OR STOPPED UP CATALYTIC CONVERTER.

Feb 28, 2010 | 1989 Toyota Camry

1 Answer

How to do transmission gasket


Front of car on jackstands,drop pan(need to catch about 7 quarts or fluid).I always remove all the 10 MM bolts on the small side,then loosen th big side to contain the mess....You will proboblhy want to replace the filter while your at it,since a filter kit usually comes with gasket....around 30 bucks then do not overtighten new gasket...good luck...Lee

Oct 03, 2008 | 1989 Buick Park Avenue

Not finding what you are looking for?
1989 Toyota Camry Logo

Related Topics:

413 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...