Question about 1983 Chevrolet C2500
Need wiring diagram for printed circuit connector\guages&indicator lights
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Jan 21, 2017 | 2007 Pontiac G5 Gt Coupe
Jan 05, 2016 | Suzuki Cars & Trucks
Jul 04, 2015 | AC Cars & Trucks
Dec 15, 2014 | 1995 Dodge Dakota
Jan 16, 2014 | Ford F-350 Cars & Trucks
Oct 05, 2012 | 1995 Dodge Neon
Jul 22, 2012 | 1983 Nissan 280ZX
I've made up the following instructions, on how to clear VSC & TRAC Warning lights:
Zero Point Calibration of Yaw Rate and Deceleration Sensors Using Paper Clips (or jumper wires).
First, locate the 16-pin ODB II connector under the steering wheel (beneath the dash). The pins are numbered sequentially backwards from right to left (from the wide side of the connector looking at it from underneath).
Take two normal-sized paper clips (or suitable jumper wires). If using paper clips, straighten one edge of one of the paper clips. For the other, bend it open to a 90-degree angle (like an elbow).
Insert one paper clip/wire into pin # 14 (Ts), and the other paper clip/wire into pin # 4 (CG) of the OBD II connector - DO NOT allow the paper clips/wires to make contact at this point. 1. Ensure the shift lever is in "P" range. Verify that the VSC indicator light is illuminated, indicating the Recorded Zero point is erased.
Refer to diagram below:
2. Turn the ignition switch to "ON" (not start).
3. Momentarily touch the two paper clips/wires together (short) and separate again (open) - Repeat this process 5 times (within 8 seconds of turning ignition on).
4. Turn the ignition switch "OFF".
5. Remove both paper clips/jumper wires from the OBD II connector.
6. Turn the ignition switch "ON" (not start) - wait until VSC warning light turns off (approx. 20 seconds), then wait 2 seconds.
7. Turn the ignition switch "OFF".
9. Re-insert paper clips/jumper wires to terminals #4 & #14 of the OBD II connector (as per above diagram).
10. Turn the ignition switch "ON" (not start) - VSC warning light should remain illuminated for 4 seconds, then start flashing at 0.13 second intervals.
12. After VSC warning light flashes for 2 seconds, turn the ignition switch "OFF".
13. Remove paper clips/jumper wires from the OBD II connector.
Drive your vehicle to confirm VSC & TRAC warning lights have been reset and no longer illuminate.
"If this has helped you resolve your issue, please be kind enough to leave a testimonial"
1. Ensure the shift lever is in "P" range.
Verify that the VSC indicator light is illuminated, indicating the Recorded Zero point is erased.
Jun 10, 2011 | 2001 Toyota Sienna
Apr 24, 2011 | 1984 Ford F 150
Aug 13, 2009 | 1996 Mercury Sable
Sep 18, 2017 | 1983 Chevrolet C2500
183 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: