Question about 1984 Chevrolet Corvette

1 Answer

Taillight lense removal on 84 vette

How do i remove thetaillight lense on 84 vette

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 161 Answers

If I remember you need to remove them from laying on the ground and going in from under the car behind the bumper. Some models did have 2 screws on the front the older ones had to be removed from behind the bumper.

Posted on May 24, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

84 vette, how do I remove power steering pulley to get the pump out?


Usually you have to take a pulley puller kit and just pull the pulley off the shaft. Installation is reverse, you use a threaded stud in the shaft to pull the pulley on with.

Jul 24, 2012 | 1984 Chevrolet Corvette

1 Answer

How to replace right rear taillight assembly


Access to the tail light cluster should be through panels in the rear corners of the vehicle. Remove the panel and you can remove the tail light cluster to replace the bulbs. This is the position on most sedans, unless, like on pick-ups, the tail light lenses have screws which allow the lenses to be removed to change the bulbs.

Apr 01, 2011 | 2002 Lexus RX 300

1 Answer

How to install replacement taillight assembly


Hello: Open the rear door, you will find two screws on the inside on the side of the tail light, remove the screws pull back side forward to unhook the lenses assembly unplug it, remove board from lenses assembly. Re-install in reverse

Feb 10, 2011 | 2005 Chevrolet Trailblazer Ext

1 Answer

Cannot remove taillight lense.


This video will show you exactly how to remove the tail light on your Grand Cherokee.Hope this helps.
Tony
">

Jan 09, 2011 | 2004 Jeep Grand Cherokee

1 Answer

Water is getting into my taillight lense and leakin into my trunk


it sounds like a trunk seal is bad or the seal around the taillight is bad i hope this helps you

Apr 10, 2010 | 1992 Buick Park Avenue

1 Answer

Need to replace the driver side taillight


if you lower the tailgate those are the screws i think your talking about,yes remove them and swing the lense out pulling from the side the screws were on,it will unhinge its self on the outer side

Dec 10, 2009 | 1998 Dodge Ram 3500 2WD

1 Answer

Left Turn flasher is out. Where the heck is it located and how do I get the ****** out?


Chect the inside of the car trunk for the left turn bulb, its probably covered by the carpet, So lift up the carpet /or the a box covering the taillight, in the mid to late 80"s car manufecturers , began installing , non removeable lenses,So u have to remove just the bulbs.

Jul 15, 2009 | 1996 Dodge Intrepid

1 Answer

My digital dash blacks out in my 84 vette.


THEY HAVE A COMMON PROBLEM WHERE THE POWER SUPPLY MODULE ATACHES TO THE MAIN BOARD.. THEY GET COLD SOLDER JOINT AND NEED TO BE RESOLDERED.AFTER REMOVING THE BACK BOARD AND CLEANING THE CONTACTS ON THE PINS THAT ELECTRICALLY ATTACH THE TWO BOARDS... YOU THE CAN LOOK FOR A SMALL BOARD THAT IS SET OFF FROM MAIN BOARD.. JUST RESOLDER ALL THE SOLDER JOINTS ON PIN IN AND OUT OF MODULE

Jul 02, 2009 | 1984 Chevrolet Corvette

1 Answer

I need to replace the taillight lens.


Open the trunk. Unscrew and remove the plastic T post where your cargo net mounts. Remove the long plastic piece that covers the latch mechanism to expose the (5 or 6) plastic nuts that hold the lense to the body. Once the are off, just pull the lense straight back and unscrew your bulbs....install in the reverse procedure.

Jun 08, 2009 | 2006 Chevrolet Impala

2 Answers

How to remove the top for open effect


there are 4 bolts holding the 84 vette top on. two front two rear. There are holes in the top from the inside 2 behind the visors and two at rear. Wrench looks like an allen wrench. There is a tool for the removal which is usually stored in the glove compartment between the seats.

Apr 26, 2009 | 1984 Chevrolet Corvette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...