Question about 2001 Toyota Camry Solara
High beam headlights work, but low beams do not.
Inspect headlamp relay, located in engine room junction box #2. If relay is OK suspect faulty headlamp switch.
Posted on May 24, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
To my knowledge a 2003 Toyota Camry uses a dual filament halogen bulb, either by Osram, Philips or Sylavania. If on the dashboard, the blue indicator lits when the switch is moved to bright or the passlight is engaged but no headlight, then it could jut be busted bulb (or part of it since you still have driving/low beam). In some cases, it could be the relay that supplies power direct to the bulb. At other times, it could be fuse(s) assigned to high beam. At certain instances, it could be also a loose, corroded or burned connector.
Corrective measure for your concern would be to check the 2 bulbs. This is performed by removing the rear covering (rubber or plastic cap) of the headlight assembly from the rear. The bulbs are held in place by a spring clip that needs to be unlatched from the base/holder. Carefully remove the bulb taking care not to touch the glass envelope. The filaments would be readily visible and cut/breaks would be apparent. If determined that one of the filaments (high beam) is open, replace the bulb(s).
If the bulbs prove to be OK, you need to work yourself backwards tracing the wiring harness. After the bulb, check the 3 prong connector for any corrosion or scorching/burnt marks; clean as maybe required. Next to check would be the relay that provides the +12VDC and then the fuse.
I doubt if the dashboard or steering wheel components involve with headlights may be at fault.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
Posted on Jun 02, 2008
it more then likey a lose wire or bear one. run the line down. i think that the high beams run on diff. fuses. you can try that!
Posted on Jul 13, 2009
Tips for a great answer:
Jun 16, 2017 | Cars & Trucks
Mar 07, 2016 | Honda Cars & Trucks
Jan 24, 2016 | Cars & Trucks
Jan 04, 2016 | Cars & Trucks
Jan 30, 2014 | Cars & Trucks
Dec 29, 2013 | 1997 Chevrolet Blazer
Oct 09, 2017 | Pontiac Cars & Trucks
Sep 09, 2012 | 1987 Chrysler Fifth Avenue
Mar 27, 2009 | 1999 Dodge Caravan
Dec 26, 2008 | 2004 Pontiac Montana
750 people viewed this question
Usually answered in minutes!