Question about 1997 Dodge Dakota

Open Question

How do you reset the factory alarm on a 97 dakota sport

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 396 Answers

SOURCE: 97 dakota truck factory security system goes off

Sounds like a computer problem. May need to have it reflashed, or replaced.

Posted on Jan 15, 2010

Ad
  • 3 Answers

SOURCE: 1998 Dodge dakota alarm

Dodge did not put "alarm systems" on there trucks during that generation all there is, is an keyless entry and panic button. anything else is aftermarket

Posted on Nov 21, 2009

Testimonial: "Thank you. Although, I have seen similar posts where people were talking about "factory" alarm systems, they must have been mistaken."

  • 32 Answers

SOURCE: 97 toyota 4runner factory alarm not allowing to start

lock your doors and close it wait till alarm resets and then unlock door with key and this should take care of you problem

Posted on Jan 05, 2010

  • 184 Answers

SOURCE: I have a 97 wrangler sport with factory alarm

You'd be better off just replacing the battery because a failing battery is going to lead to even more problems! I'm not sure on that specific model but can you take out a fuse? Or disconnect the horn?

Posted on Mar 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How to disable alarm in 1999 monterro sports


disconnect the battery...wait 30 mins and the pcm should reset.

Jan 07, 2015 | 1999 Mitsubishi Montero Sport

1 Answer

Disconnect factory alarm


There is a fuel pump shutoff on most cars. Look in the owners manual. The reset button is usually located inside the vehicle near the gas cap (just in front of the gas cap). Usually a small rubber grommet or access panel that you pop off and press a button.

The button lets the fuel pump and engine control activate again.

Rear bar impact, roll over (or almost roll over) will activate the safety feature.

May 08, 2014 | Suzuki Sidekick Cars & Trucks

1 Answer

How to reset factory alarm in 1997 Chevy Suburban without a keyfob


to disarm the factory alarm try unlocking driver door with the key. does it blow the horn or does it have a siren?

Jan 25, 2014 | 1997 Chevrolet Suburban

2 Answers

How do you reset car alarm? put battery in, now alarm goes off and not stop. 2000 mitsubishi montero sport


Hi:
I have montero sport 2000 also. If you call your local mitsubishi dealer and give them your vin number on your rig they will be able to give you codes to punch into probbably your stereo that will reset a factory alarm. good luck...

Aug 07, 2011 | 2000 Mitsubishi Montero Sport

1 Answer

I have a 2000 Dodge Dakota 3.9 Sport with an A/C, and i CANNOT find the part number from Autozone or anywhere for the correct serpentine belt length or part number. can anyone help? how long should the...


These are Auto Zone part numbers:Dayco Belt P/N 5070973, 97 1/4 inches long for factory installed A/C. If the A/C was dealer installed the P/N is 5070955, 95 1/2 inches long. The cheapest belt is a Duralast PN 973K7 97 1/4 inches long, that says it fits both factory and dealer installed a/c. I'm not sure how you would tell the difference between factory and dealer a/c. If in doubt, get the longer belt and make sure they can get the shorter belt if you need it.

Feb 09, 2011 | 2001 Dodge Dakota

1 Answer

I just bought a 97 pontiac trans sports and i dont remember the anti theft thingy to starty it and the guy i bought the van from is gone


Contact a Pontiac Dealer, I believe on that van, if you take and cycle the key off and on 3 times, that will reset the alarm and anti theft thingy.

Jan 28, 2010 | 1997 Pontiac Trans Sport

1 Answer

97 toyota 4runner factory alarm not allowing to start


lock your doors and close it wait till alarm resets and then unlock door with key and this should take care of you problem

Jan 05, 2010 | 1997 Toyota 4Runner

1 Answer

1998 Dodge dakota alarm


Dodge did not put "alarm systems" on there trucks during that generation all there is, is an keyless entry and panic button. anything else is aftermarket

Nov 21, 2009 | 1998 Dodge Dakota

1 Answer

97 dodge dakota stereo problems!!!!


if it has factory radio pull it out and check the ground wire on the the back if it is not hooked up radio wont work

Jun 01, 2009 | 1997 Dodge Dakota

Not finding what you are looking for?
1997 Dodge Dakota Logo

Related Topics:

606 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...