Question about 1995 Honda Accord

1 Answer

Starter is good. but still no noise when key turns over.

Took the starter out and had it tested. it is good so i put it back in. still no noise when i turn the key over. Somebody told me to cross the bendix to see if its bad but i have no idea what a bendix is. i need help bad.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Honda Master
  • 358 Answers

Rhere is a small wire and a large wire at the starter. you can use a jummper wire and jump from one wire to the other if you have voltage at the big wire it should crank over if the startwer is good. if not you have other issues with the starting system.

Posted on May 23, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What would cause a load noise after replacing starter?

Some starters must be aligned for the proper engagement; with chevys it is with shims. Check your shop manual for your car model and vin to find the procedure for setting the proper clearance.

Oct 02, 2015 | Cars & Trucks

2 Answers

My 2002 Taurus won't start, all electric goes out when I turn the key. I took starter out and had it tested good. put it back in and it cranked. Next morning same problem. Battery is good and

You may have a bad starter solenoid. Could maybe be a bad relay also. Check your ground and power wires from your battery to make sure there are no breaks where it could be grounding out. Battery and starter may be good but bad wires won't let it get power to starter.

Jan 22, 2015 | 2002 Ford Taurus

1 Answer

Car will not start

I don't know how you tested the battery and starter, but let's go over it again. If the motor makes no noise when you turn the key, turn on the headlights. If they're bright, chances are the battery is good. Now, turn on the key and move shifter to N., Try to crank again. Next, back to P, and get somebody who trusts you to find the starter motor and gently bang on it with a hammer while you turn the key to start. Other things it could be is the ignition switch, the neutral safety switch, or starter relay, which all need testing point to point with a test light. Good luck!

Dec 27, 2014 | 2006 Jeep Liberty

1 Answer

2000 pontiac gtp 3.8 se. I changed the

It is good b/c I took it out and tested it ? How ohm testing ? That's the wrong test to be doing ! Voltage drop testing in the vehicle . Starter Voltage Drop

Mar 25, 2017 | Cars & Trucks

1 Answer

Had starter checked and it is good.have to turn key back and forth several times before car doesnt make any noise or anything,it does nothing at all until the 2nd or 3rd time sometimes

Could be a worn out ignition switch & the
starter solenoid could be bad

Don't personally care how or what was tested,
based on what I see on this site, not much is done
correctly, when you pay someone

Apr 03, 2013 | 2003 Mitsubishi Lancer

1 Answer

Have no fire and the shut off relay is clicking. The battery is fine changed relay and the same clicking noise happens when i turn the key on

Good battery, good relay. Take out the starter and have it tested. Although the same thing happened to me and the starter tested fine....twice ( after being told it was fine, I cleaned it up and put it back, still no good ) I replaced it anyway and all is good. The auto store felt so bad they gave me a lifetime starter for the price of a rebuilt. The tester doesn't put enough load on the starter to truly test it. Hope that helps.

Jun 14, 2010 | 1995 Jeep Wrangler

1 Answer

1991 jeep cherokee laredo won't start

you can test your signal wire to the starter by having someone turn the key to start while you put a test light on the signal wire at the stater.If there is no signal on the light then there is a problem with the sending wire from the ignition.

Mar 07, 2009 | 1991 Jeep Cherokee Limited

Not finding what you are looking for?
1995 Honda Accord Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides