Question about 1995 Chevrolet Camaro
Top goes down but does not come back up with switch
If the motor is only moving top one direction, either the switch is bad or the motor is bad. You can use an ohmmeter or volmmeter to test the switch. Place meter probes on the wiring that attaches to motor. Now press the switch in both directions. See if there is power in both directions from switch. If not the switch is bad. If you do get power both directions, than the motor will need to be replaced.
Posted on May 23, 2009
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Thank you mspastryguri
By using the window master switch method, it reset the computer and the roof went all the way down and locked.
Posted on Nov 15, 2009
You are probably low on fluid.
Behind the rear seat is the motor/pump/reservoir.
With the top down, fill the reservoir till it overflows with ATF. Cycle the system a few times. Repeat till the reservoir will accept no more fluid.
Look for leaking lines or cylinders. The fluid must have gone someplace.
Always replace lines and or cylinders in pairs.
Posted on Jan 25, 2010
Tips for a great answer:
Apr 26, 2018 | BMW Cars & Trucks
Apr 08, 2016 | Cars & Trucks
Mar 17, 2014 | 2003 Volkswagen New Beetle Convertible
Apr 12, 2013 | 2001 Saab 9-3
Sit in back seat passenger side. Remove panel which is on top which is below rear window, same panel where seat belt goes into panel at top. You will need to remove #2 Phillips screws which hold panel in place. Screws are hiding behind seat belt front cover where belt goes down in panel, under cup holder which allows arm rest cover to lift off and one more right on left side of head rest in corner. Remove panel. You will see switch which is in vertical position. If for any reason you want to by-pass switch, just unplug switch. Radio will still work in standard mode. The amp sound will not increase in performance when top is down and sound will not be as sharp.
Jan 20, 2013 | 2005 Toyota Camry Solara
May 18, 2010 | 2005 Volkswagen New Beetle
Nov 14, 2009 | 2004 Volkswagen New Beetle Convertible
Jun 27, 2009 | 2000 Ford Mustang
May 27, 2009 | 2004 Volkswagen New Beetle Convertible
May 23, 2009 | 2001 Ford Mustang
126 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: