Question about 1992 Cadillac Eldorado

1 Answer

Trunk pull down motor

Looking for instructions to instal

Posted by on

  • iikloiber Jul 12, 2009

    I replaced the pulldown switch ,the trunck pulls down but now the new battery gets drained dead. Kenny K.@ iikloiber@hotmail.com THANX!

  • honeymokey
    honeymokey May 11, 2010

    Is it not working? Did you replace the pull-down switch that fixes 98% of them?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 3,113 Answers

Replace the pull-down switch. This is what fixes 98% of them.

Posted on May 25, 2009

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 9 Answers

SOURCE: 86 camaro trunk pull down motor

buy a replacement unit from the junk yard or from ebay. or do as i did and make the uint into a manual open only. vist thirdgen.org and look in the tech articles for the best help

Posted on Jan 05, 2009

countrysi248
  • 443 Answers

SOURCE: Trunk pull Down Motor Suddenly stopped working

did it quit making the noise when you lightly push down on the trunk? most people slam these trunks and your not suppose to you are only to put light pressure on them and they pull it closed theirself.. you might check your relays under the hood and look in the box lid to see which one it is.. if this is not the problem you might have to replace the motor to the latch .. you might check with a test light to see if there is power to the motor first though .. thanks and holler if you have more Jerry .

Posted on Apr 26, 2009

  • 91 Answers

SOURCE: trunk locks but wont pull all the way down

sounds like it may be but first i would spray the moving points with wd - 40 and make sure nothing in trunk is it the way (lube is the cheapest place to start).

Posted on Apr 27, 2009

honeymokey
  • 3113 Answers

SOURCE: how to replace pull down trunk 1995 Cadillac Deville

Replace thr pulldown switch .

Posted on Jun 15, 2009

RJones1125
  • 373 Answers

SOURCE: Trunk lid will not pull down

i had the same problem, there is a stop switch that is bad. (got one from a junkyard but it was bad also). haven't found one online yet, but will ask my local ford dealer if part is still available.
so untill i find one, i got the motor to stop at the all the way down position (trunk closed) and then unpluged the motor.

Posted on Aug 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why doesn't pull down switch grab the trunk lid?


There's a motor that pulls the trunk lid down after it latches. The motor is under the latch on the body side. to test it, push a philips screwdriver shank into the latch like it was grabbing the trunk pull down motor to see if it triggers the motor to operate

Feb 19, 2016 | 1995 Cadillac DeVille

1 Answer

96 Lincoln Town car trunk will latch but the part that brings the trunk all the way down is not working


look under the cover under the trunk lid, and the motor that pulls the lid down. sometimes the bolts come loose and the motor slides, or a wire is loose on the motor or the fuse is blown. good luck and let me know if I can help more.

Aug 26, 2014 | 1996 Lincoln Town Car

3 Answers

I have a 1996 lincoln towncar and the trunk isn't closing all the way. from what i have read it is probably the pull down motor???? could you tell me where that is located and what to do to test it to see...


The pull down motor is easy to change open your trunk and look where it latches thats your pull down motor it is probably 3 10 milimeter bolts you will probably have to take out the plastics that cover it up and push back or remove the trunk liner material by it. change your motor and you will have to adjust the motor by lightly snugging the bolts and closing the trunk till it is in the right position then tighten bolts and reinstale liner

Feb 28, 2011 | 1996 Lincoln Town Car

1 Answer

1993 Cadillac Seville...my trunk pull down latch stuck in upward position. The trunk is not closing all the way. How do we fix it?


What you need is the gear's to the trunk motor, these gears are sold by them self. not hard to install in truck motor.

Aug 23, 2010 | 1993 Cadillac Seville

1 Answer

The trunk actuator motor isnt pulling down


I replaced the trunk pull down actuator cost 65$ @ junk yard

May 06, 2010 | 1994 Buick Park Avenue

1 Answer

97 town car trunk pull down stopped working ???


i pulled entire lower assembly off, removed motor casing and found that the plastic ring gear that pulls the truck down was stripped. I then pulled the whole thing apart using simple tools and turned the ring gear by hand to about 3/8 inch above the full down position. I then reassembled and re-installed without the switch and without the motor. Trunk closes like a normal trunk now (no pull down obviously. I am not a mechanic and it only took about an hour and two beers, no money. 93 lincoln town car.
Note: you will need torx bits but that is the only thing "specialized" in the operation

Oct 19, 2009 | 1997 Lincoln Continental

1 Answer

Trunk lid will not pull down


i had the same problem, there is a stop switch that is bad. (got one from a junkyard but it was bad also). haven't found one online yet, but will ask my local ford dealer if part is still available.
so untill i find one, i got the motor to stop at the all the way down position (trunk closed) and then unpluged the motor.

Apr 26, 2009 | 2004 Lincoln Town Car

1 Answer

Trunk pull Down Motor Suddenly stopped working


did it quit making the noise when you lightly push down on the trunk? most people slam these trunks and your not suppose to you are only to put light pressure on them and they pull it closed theirself.. you might check your relays under the hood and look in the box lid to see which one it is.. if this is not the problem you might have to replace the motor to the latch .. you might check with a test light to see if there is power to the motor first though .. thanks and holler if you have more Jerry .

Apr 23, 2009 | 2004 Lincoln Town Car

1 Answer

86 camaro trunk pull down motor


buy a replacement unit from the junk yard or from ebay. or do as i did and make the uint into a manual open only. vist thirdgen.org and look in the tech articles for the best help

Jun 24, 2008 | 1986 Chevrolet Camaro

Not finding what you are looking for?
1992 Cadillac Eldorado Logo

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...