Question about 1994 Mazda 323

1 Answer

Mazda 323 wont start until cold

Mazda starts every morning but wont start again for a few hours....turns over but no spark.

Posted by on

  • atseagrove Jun 13, 2009

    No this car doesn't have a distributor, it has 2 coil packs connected to the spark plugs....I have replaced the KNOCK sensor ($300) which made no difference. I have been told maybe I should change the CRANK sensor???? is this different to the knock sensor????

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 111 Answers

If this vehicle has a distributor, try replacing the pickup coil. This should be located under your distributor cap and is responsible for spark. When your engine compartment gets warm from normal conditions, this plastic piece of **** shrinks and the metal tab attached to it doesn't make a good enough connection to conduct the electric spark to your plugs. Hope this helps!

Posted on May 23, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mazda 323 ignition


run fault codes and look for cam/ crank position sensors faults. check that the cam shaft is turning ( broken timing belt/chain). Check that the immobiliser is operational.

Feb 14, 2014 | Mazda Cars & Trucks

1 Answer

Have a mazda 323 it wont start has new dizzy cap new rota new sparkplug leads have to tow it it starts runs all day morning have to tow it again wat your thoughts


Have you checked to see if you don't have spark to the plugs or normal fuel pressure when it fails to start ?

Jun 08, 2013 | Cars & Trucks

1 Answer

Mazda 1990 323 1.8L LX, 5 minutes after the start up she stop no way tos restart again only when sitting about 1/2 hours start again but stop....


Start by having the charging system checked,unless the car engine spins but doesnt start,if it spins over and wont start then it not the charging system,when the car dies check for spark, remove a sparkplug wire insert a screwdriver in boot and place 1/4 inch near metal and crank engine and see if theres spark,this will help pin point your problem if theres spark then the next thing to do would be to spray starting fluid in throttlebody and see if it starts,hope this helps let me know the results.

Jun 09, 2010 | 1990 Mazda 323

1 Answer

Mazda 323 1,6l,2002model.started jerking while driving and engine died.when cranking spark jump only once on coil for 1&4cyl,second coil no spark at all.bridged apropr.term in diagnostic socket but led...


i have mazda 323 2002 1.3 b3 engine manual transmission in cold engine will starting idling but did not raising 5 to 10 minits and in runnig it will be jerks

Mar 20, 2010 | 2000 Honda Accord

1 Answer

My 1989 mazda 323 wont start


Hi there
You may need to do a few more things: * Change Spark Plugs * Check HT Leads * Check Battery Voltage * Fuel Filter * Get a mechanic to check your Carb settings.
As i say this could be either one thing or the other but could be a combo of these.

I have the same car and i've worked on it alot so theres a few things you need to check out.
But if you repost on here please give me more details: ie, ill the starter crank,

May 17, 2009 | 1989 Mazda 323

2 Answers

1993 mazda 323 no start condition


sound like timing problems. check timing belt or needs changing.

Apr 09, 2009 | 1993 Mazda 323

1 Answer

Mazda 323 stops every now and again wont start leave for hour starts ok does this every now month or so suspect crank censor year 2000


this vehicle is the same as ford in regards to wiring and computer software but only on US models us in europe have to put up with encrypted software and manufacturers pins in the OBD II connector.When it doesnt start pull a plug lead off and stick an old plug in to see if any spark,no spark change sensor ...spark and no start then sticky fuel pump.if both working and no start then engine immobiliser could be at fault try the spare key eliminate all posibilities

Nov 12, 2008 | Mazda 323 Cars & Trucks

Not finding what you are looking for?
1994 Mazda 323 Logo

Related Topics:

566 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...