Question about 2003 BMW 325

1 Answer

What size is the main rotor nut on a 2003 bmw 325i I think its around 47mm

What size is the main rotor nut on a 2003 bmw 325i I think its around 47mm

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

That would be the axle nut, not the rotor nut and it is 36MM 12 point., this does not have to be removed to remove the rotor!!!

Posted on May 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1989 mw 325i brake lining light comes on when


your brake pads have a small sensor built in and when they contact the rotor it competes the curcuit and the light comes on your pads are worn out i suggest replacment soon or run the risk of needing new rotors

Feb 23, 2010 | 1988 BMW 3 Series

2 Answers

Abs brake light dsc on 2003 bmw 325i


many reasons for this. A bad relay can do it, or a wheel speed sensor can to. Also the relay may be at fault. You can have the codes checked for free at any Auto Zone and they will tell you what part is bad

Jan 24, 2010 | 2003 BMW 325

1 Answer

The left break light sensor comes on and off on the car indicator and will cause the three pack of lights to go out also this will happen with the right side of my 2003 bmw 325i with 45K


water in the rear brake light assemblies. common problem. remove the brake lite assembly------very very easy thing to do. there are three nuts holding it in from inside the trunk. once they're off the whole assembly just pops out. then it can be cleaned. usually the rubber gasket around the assembly leaks water into the lights and messes up the contacts where the bulbs screw into the circuit board.

Nov 03, 2009 | BMW 325 Cars & Trucks

1 Answer

Remove radio 2003 bmw 325i


Go to an auto parts store and get a Haynes repair manual for your vehicle and look up disassembly of the dash board area. That will be the best solution to getting that radio out.

Oct 06, 2009 | 2003 BMW 325

1 Answer

Car wont start?


May sound stupid, but use a voltmeter to double check your batteries' charge.

Just cause its new..stranger things have happened..

Check your battery connections? tight?

Check your grounds around the engine compartment frame.

Loose? Rusty?

Check starter ground for same problem.

Check the fuses and relays in the fuse box in the engine compartment.

Your main heavy duty components are fused there.

Good luck.

Oct 02, 2009 | 2003 BMW 325

1 Answer

NEED TO KNOW IF 2003 BMW 325I HAS A RADIO CODE AFTER BATTERY HAS BEEN DISCONNECTED


I have 2003 bmw 325i and I took my car to the dealer, and he said my car does not need any code.

Jul 01, 2009 | 2003 BMW 325

1 Answer

How to replace rear shocks on 2003 bmw 325i


You have to take the trunk liners off of both sides. There will be 3 13mm nuts on each side for the shocks, and under the car is a 16 or 17mm bolt that has to be removed. I hope this helps.

Mar 31, 2009 | 2001 BMW 325

1 Answer

2003 BMW 325i, Metal-on-metal grinding left turn only


This sounds like a wheel bering. If you turn left on a bad passengerside bering it growls louder because more pressure is shifted onto it.

Mar 22, 2009 | 2003 BMW 325

2 Answers

Loose handbrake on bmw 318 1995 model


hi, as a general rule as i have never worked on a bmw if you take away the moulding from around the hand brake there are two wires connected into the handbrake unit with a couple of nuts you just adjust the nuts accordingly hope this helps

Mar 06, 2009 | 1989 BMW 3 Series

1 Answer

2003 BMW 325I Power Steering


when looking at the engine with the hood up, look to the right hand side for something that looks like this (#1 in the pic): http://www.realoem.com/bmw/showparts.do?model=ET37&mospid=47720&btnr=32_0957&hg=32&fg=20

it will be black in color, but don't confuse it with the oil filter housing. power steering reservoir will have a unique cap (#2 in the pic) that can be removed with your hand. the one that has the large nut on top is the oil filter. remove the cap and put in the correct fluid.

hope this helped.

Jan 26, 2009 | 2003 BMW 325

Not finding what you are looking for?
2003 BMW 325 Logo

Related Topics:

395 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...