Question about 2003 Ford F250 Super Duty Crew Cab

1 Answer

2003 F250 Power Windows won't work

Where is the relay?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 4,369 Answers

Check fuses 35 & 41 (10 amp, red).
it also shows an accesory delay relay in the fuse panel.
And fuse 601? 30 amp.

make sure you don't have lock-out on driver switch panel activated.

Power Window System
Features and Operation
NOTE: The accessory delay feature will allow power window operation up to 10 minutes after the ignition is off or until a door is opened.
If equipped with power windows, the window control switch (14529):

  • will operate the power windows only when the ignition switch is in the RUN or ACC position.
  • is located on each front door trim panel, and Crew Cab and Excursion rear door trim panel.
  • may be used to raise or lower the driver side, passenger side and rear windows from the LF control on the driver side, or the passenger window from the passenger switch.
  • includes a one-touch down (OTD) feature for the driver door window.
  • can partially lower the driver side window when the LF window control switch is depressed half way (first detent).
  • will completely lower the driver side window when the LF window control switch is fully depressed and then released (second detent).
Power Window System — Modes of Operation
There are two modes of operation for the power window system.
Manual Mode
When the LH window control switch is pressed to the first down position, the window will move down until one of the following conditions are met:
  • The LH window control switch is no longer in the first down position.
  • The LH window control switch is pushed to the OTD position, causing the windows to enter auto mode.
Auto Mode
Auto mode provides the OTD feature. The OTD feature is activated when the LH window control switch, for the LH window, is pressed to the second down position.
Auto mode will be terminated when any of the following conditions are met:
  • The LH window control switch is pushed to the UP position.
  • The LH window control switch is released (OFF position) and then moved to the DOWN position (first detent) or OTD position (second detent).
  • Note: Delayed accessory feature must be active.
The OTD feature is controlled by the window control switch.

---------------------------------------------------------
Condition Possible Sources Action
  • All power windows are inoperative
  • Fuse(s).
  • Circuitry.
  • LF window control switch.
  • Accessory delay relay.

Posted on May 27, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 windstar eec wiring scematic


Find another relay with an identical part number(maybe the fuel pump relay)& swap it in place of the suspect EEC relay.See if the buzzing quits.If it does,the EEC relay is bad.There might be a ac WOT cutout relay or fan relay with an identical part number that you can use instead of the fuel pump relay.The fuel pump relay & EEC relay will both have to be in place in order for the engine to start.A relay should click when you turn the key on,but it shouldn't make a buzzing noise.BTW-the EEC relay is energized when you turn the key on and then it supplies ignition on power to the computer,injectors,solenoids and fuel pump relay.Therefore, if the EEC relay is defective, these components are Not going to work.If you don't hear the fuel pump prime when the key is first turned on,that's a sign the EEC relay is bad.One of the injector wires should have battery voltage, if the EEC relay is powering up.If your vehicle doesn't have a matching relay to the EEC relay(except for the fuel pump relay)just pull the FP relay out and slide it into place of the suspect EEC relay for testing purposes.If the buzzing noise stops,then replace the relay because there's no way to test if the car will start without having both relays in place.

Oct 11, 2015 | 1996 Ford Windstar

1 Answer

Power windows and radio stop working on my 2003 f250 super duty pick up


Coould be a bad connection in your ignition switch!

Jan 24, 2015 | Cars & Trucks

1 Answer

What relays are in the Maxifuse/Relay Center?


Depends on vehicle but generally a hi-lo cooling fan relay, fuel pump relay, starter relay,fuel injector relay, a/c relay and on certain models hi& low beam headlight relays.

Nov 02, 2014 | 1999 Oldsmobile 88

1 Answer

Where is fuel relay 2003 f250 super duty crew cab?


check owners manual ,nut it might be in the power distribution box under the hood ,or behind the right kick panel under dash

Oct 05, 2014 | 2003 Ford F250 Super Duty Crew Cab

1 Answer

My 2003 Saab 9-5 Aero 4-cyl Turbo Won't start. However, I have power in car, lights windows and radio works. But it won't turn-over. It could be Starter or Starter Relay. I can't find out


Ok, those systems might still work because the not require as much energy as the starter. Check the Battery Voltage with a good Voltmeter. If below 12, there might be your problem!

Mar 26, 2013 | 2002 Saab 9-5

2 Answers

Flashers not working


possible relay fault ? check all fuses not just the one thats for stated device

Mar 08, 2013 | 2002 Volvo S60

1 Answer

One headlight on my 04 f250 lowbeam only won't work even with new bulb


Try a new Relay. Sometimes Ford uses the same part in other sockets. The horn relay may be interchangeable for testing.

Relays are shown in the help section of Autozone.com when you register your vehicle.

Jan 30, 2013 | 2004 Ford F250

1 Answer

2003 Ford F250 super Duty diesel radio and windows wont work


u probably have a relay in the fuse box lose or a bad ground

Mar 30, 2012 | 2003 Ford F250 Super Duty Crew Cab

Not finding what you are looking for?
2003 Ford F250 Super Duty Crew Cab Logo

Related Topics:

1,919 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...