Question about 1998 Pontiac Grand Prix

2 Answers

My A/C is squeeking and I need to replace it. Can someone give me instructions on how to replace the A/C Fan Motor?

How do you change the A/C Fan Motor on a 1998 Pontiac Grand Prix GTP?

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Pontiac Master
  • 3,854 Answers

The Blower Fan is located under the glove compartment on the passenger side. You have to take out the three plugs holding the carpet on then you can see the blower motor. Take off the three screws holding on the blower motor, disconnect the wire harness then just do every thing in reverse to put the new one back in!!!

Good luck and hope this helps.

Posted on May 22, 2009

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Yea and its a pain in the but to get to.

Posted on Jun 09, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Heater fan blade squeeks

loose fan or faulty heater motor, remove inspect and or replace it

Dec 09, 2013 | Chevrolet Cars & Trucks

1 Answer

05 Maxima squeeking from front. changed control arm and 2 motor mounts and still

The steering column shaft mounts to the rack and pinion steering gear with a type of u-joint and a pinch bolt to hold the steering column shaft tight on the rack and pinion stub shaft. This coupling may have gotten loosened, so you should check it. It is all hidden by the boot over the steering column on the floor. If you can get the boot to slide upward a bit, I think you can see the coupling. Or, you may need to look at it from underneath. The rack's stub shaft is on top of rack right where the steering column would come from the floor.
Here's an idea: put the front up on jack stands or blocks. Then you could watch and listen while someone turns the steering wheel back and forth.

Jul 24, 2013 | 2005 Nissan Maxima SE

1 Answer

Fan works in high speed only, replaced control panel, no change.the compressor will not operate, replaced compressor relay and clutch relay, no change any help!!!!!!!

I can't help with your compressor issue but I can with your blower motor fan. It is more than likely the blower motor resistor. They're designed so that when they fail they default to high. I can't really give you a location or installation instructions since no vehicle information was provided but generally they are located close to the blower motor itself on near the plenum chamber.

Jun 01, 2011 | Ford Contour Cars & Trucks

1 Answer

How to change fan belts

Recommend a 1990 Nissan Stanza Chilton's repair book from the auto parts store. It will give you step by step instructions on replacing your fan belt to rebuilding your Nissan's motor and a lot of other stuff.

Jan 27, 2011 | 1990 Nissan Stanza

1 Answer

Heater AC fan squeeks all the time

Bearing in blower fan motor starting to go bad, you could try using WD-40, but will squeek again, best to replace it'

Jan 13, 2010 | 1998 GMC Sierra

1 Answer

Brakes squeek

did you spray some brake stop squeek on the back of the pads before you installed them try these websites and and the stop brake squeek you be able to pick up some at any auto parts store even Walmart.

Aug 28, 2009 | 1994 Honda Civic

1 Answer

The blower fan on 1997 Jeep Grand Cherokee squeeks when running.

Maybe that's why they call it a squirrel cage. Seriously, noise is either from something caught in the fan or a bearing in the motor is dry and beginning to fail (motor needs replacement) Either way you need to remove motor to check it.

May 11, 2009 | 1999 Jeep Grand Cherokee

1 Answer

2000 Audi A4 Squeeking Fan, Can I change the bearing


Jan 25, 2009 | 2000 Audi A4

1 Answer

Skeaky serpentine belt

are you positive the squeek is coming form the belt area?

the squeek can be from several other places, fan clutches can cause a high speed squeek, take the fan off and see if that cures it, the water pump front bearing can also be the culprit but that is hard to figure out without swapping in a new water pump, and lastly look at the AC compressor clutch, see if the squeek changes when you turn on and off the AC

hope this helps,

Oct 12, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
1998 Pontiac Grand Prix Logo

Related Topics:

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides