Question about 2004 Dodge Dakota

1 Answer

Location of oxygen sensor on 2004 dodge dakota

I need to change my oxygen sensors on my 2004 dodge dakota v6. I don't see them easily and was wondering if someone could give me advice on how to find and change them.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 111 Answers

One of them is located on the driver's side of the motor and connects to the exaust manifold.

Posted on May 22, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have p0743 p0138 p1763 and 1763 codes on 1998 dodge dakota v6 3.9 loss power


p0743-? p0138-oxygen sensor input voltage maintained above the normal operating range. p1763- governor pressure sensor volts too hi.

Nov 05, 2011 | 1998 Dodge Dakota

1 Answer

On a 2004 Dodge Caravan, the code P0032 apparently means that the oxygen sensor needs to be replaced at bank 1 sensor 1. I'm trying to determine which location this is - upstream or downstream. Both...


Bank #1 is on the side that cylinder #1 is on

Sensor #1 is the one closest to the engine (upstream)

Sensor #2 is the rear or monitor,they don't
get replaced (downstream)

Jun 24, 2011 | 2004 Dodge Caravan

1 Answer

Where is the location of the coolent temp. sensor on a 04 dodge truck v6 3.7 . I need to replace it.


Dodge Dakota 3.7L v6:




0996b43f80204b36.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. ECT sensor location-3.7L, 4.7L engines.

icn_arrow.gifBack to Top Inspect/Test/Replace Because ECT (engine coolant temperature) sensor procedures vary depending upon their location, first locate the part. You may need to partially drain the engine coolant to prevent coolant spillage.

  • Disconnect the negative battery cable.
  • Unplug the ECT.
  • Then, unscrew it.
  • Reverse the removal procedures to install the new part.
  • Connect the negative battery cable to the battery.

Feb 15, 2011 | 2004 Dodge Ram

1 Answer

I am stupid when it comes to cars, just to warn you. i need to know exactly how to get to my crank sensor on a 1991 3.9L Dodge Dakota 2wd auto.


V6 and V8 engines
See Figure 3
  1. Remove the air cleaner assembly.
  2. Unplug the wire from the sensor.



0900c15280070e13.jpg enlarge_icon.gifenlarge_tooltip.gif

Fig. Fig. 3: Crankshaft position sensor location-V6 and V8 engines

  1. Unbolt then remove the sensor from the engine.

To install:
  1. Position the sensor to the engine, then install the mounting bolts, tightening them to 70 inch lbs. (8 Nm).
  2. Install the air cleaner assembly.

***This can be viewed at autozone.com. become a member and look up repair guide for crankshaft postion sensor. *** be sure mounting surface is clean before installation.

Jan 03, 2011 | 1995 Dodge Dakota

2 Answers

Location of the throttle position sensor


the censor is located adjacent to the throttle control linkage, and has a 3 wire connection plug

May 30, 2010 | 2004 Dodge Dakota

2 Answers

Crank sensor location for 2002 durango 5.9


should be on the drivers side back of motor stuck in the tranny bellhousing at the top held in by either a 10mm bolt or a 12 mm

Jan 21, 2010 | 2002 Dodge Durango

1 Answer

1997 Dodge Stratus V6 oxygen sensor location


Upstream, as in ahead of the converter, back toward engine. Start at converter and work your way back, should be on exhaust pipe or even on manifold.

Jan 11, 2009 | 1996 Nissan 240SX

Not finding what you are looking for?
2004 Dodge Dakota Logo

Related Topics:

1,093 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...