Question about 1997 BMW 5 Series

1 Answer

No gas to inj

1988 325 i no inj pouse

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

Make sure your fuel filter is not clogged and there is gas getting to the fuel rails by the injectors and give this website a try its www.alldatadiy.com and i hope i have been able to give you some help Michigan Man.

Posted on May 22, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Running rich 2lt duel over head cam


Check coolant temp sensor. They fail quite often and will make engine run as if the choke is on, thus killing gas mileage and perhaps running poorly. Other possibles are clogged converter or muffler.

Mar 16, 2014 | 1999 Dodge Neon

1 Answer

Checking tbi injecter voltage


On a 1988 model which should be the same as 87, I show two injectors in the throttle body. Inj 1 has red and blue wires and inj 2 has green and white wires.
The red and white wires should be battery voltage, and the other two are ground signal wires from the computer.

Dec 20, 2012 | Chevrolet Silverado 2500 Cars & Trucks

1 Answer

1999 4.3 spider inj. new tune up filters gas analyzed fuel press 50 but dropping slowly


check fuel lines as well as the seal on your gas cap I believe their is a fuel regulating valve on this unit

Sep 04, 2012 | Chevrolet Cars & Trucks

1 Answer

What is the piece called that the gas lines hook-up to on top of the gas tank???? gas tank is on a 1988 toyota pickup-4cyl-Fuel Inj -4x4


That is called the fuel pump mounting and it is normal for a truck of that vintage to have stuff drop on it like mulch and not get cleaned and rust out the mounting and the lines.

Nov 05, 2010 | 1988 Toyota Pickup

2 Answers

Car ran out of gas, when gas was put in the car just cranks but wont start.


I know with some cars, you need to put in at least 5 gallons of gas after running out in order to reset the sensor so it starts sending the gas

Sep 11, 2009 | Chevrolet Impala Cars & Trucks

1 Answer

My 96 v6 4.0 grand cherokee is reading these codes


douple ck all the ground wiresto engine,trans bell housing ,battery or frame/firewall look for any that may have separated from any pack of wires or broken off eyelets then thightnen all points,,.these grounds are very important to comp/injection controls and can cause a multi code problem like yours.

May 05, 2009 | 1996 Jeep Grand Cherokee

1 Answer

Fuel Injectors leaking


Where the injector's mount to the fuel rail and into the eng. there are o-ring's.Check the o-ring's for damage.If the o-ring that seal's the inj. to the fuel rail is damaged it will leak alot from the pressure of the pump and make the car act like it's running on 3 cylinders because there is no fuel going to the cylinder to ignite.If there is a bad seal in the area where the inj. goes into the cyl.head it will leak a little and should be fixed as well.When installing new o-ring's lube them up litely for a easier install.Be sure to clean the gas up so you dont ignite any spilled gas.Hope this help's.

Mar 02, 2009 | 1997 Pontiac Sunfire

1 Answer

No gas to manifold,car will start adding gas to throttle body


yes gas should be coming out of the fuel line at the motor. if not the pump is bad. you will need to drop the tank to get to it as it is in the tank

Dec 01, 2008 | 1993 Pontiac Bonneville

1 Answer

Starts but dies when given more gas.[when you try to speed the engine up]


I bought a Chilton Book # 28700 for the Geo Metro at Pepboys. I looked at the 1995 Geo Metro wiring diagram and on page 6-37 shows "Y/B" wire which is the yellow/black wire that connects from the fuel injector ( my car has one that shoot gas into the carburator) to the computer of the car located behind the glove compartment. What I did is that from the engine I followed this wire all the way to the ECM ( engine control module or computer). This meant that I had to remove the electric tape and protective skin off from around the bunch of wires and dig thru to follow this Y/B wire. As I got deeper I found that it fused together with another wire. All I did was pull them apart and the car worked normal again. Of course you have to wrap lots of electric tape around it, also the other wire it was fused to, and when finished, just wrap the bunch of wires with the protective skin and electric tape and you should be set to go. Hope this works, good luck!

Oct 10, 2008 | 1995 Geo Metro

Not finding what you are looking for?
1997 BMW 5 Series Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...