Question about 2006 Chevrolet Impala

Open Question

Can't turn key in ignition of 2006 Chevrolet Impala

When inserting key...the ignition won't turn to start the car.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 156 Answers

SOURCE: My Spare Key Won't Start My Car

ok well here's the thing. This key has not been used before. The keys are cut to the specs of the ignition so they may be undercut so to speak. I know on my car i can turn it upside down it will work. But on the other hand it could just possibly be a back up for when you lock your keys in your car (not likely but it's still possible). You can keep putting your key in and out a bunch of times and **** the steering wheel back and forth as you turn the key to get it used to the ignition switch. See if that works and if not i will see what i can come up with in the meantime for this exact car.

Posted on Mar 05, 2009

  • 6982 Answers

SOURCE: 2001 Chevy impala had ignition switch replaced,

Turn the key to "on" and let the light flash. It should stop flashing after about ten to twenty minutes. Once the light is on steady, turn it off, then start the car. I usually put another battery on jumper cables attached to the cars battery so it does not run down and die before the system re-arms.

Posted on Aug 16, 2009

  • 124 Answers

SOURCE: Problem with 2006 Chevrolet Impala --Windshield washer fluid

Sounds like the fuse blew out again. Look at the wiring that goes to the washer fluid pump and check for any place where it might have rubbed against something causing it to short out. Fix this 'short' before you replace the fuse again or you will continue to have problems.

Posted on Nov 05, 2009

  • 1 Answer

SOURCE: i need a serpentine belt assembly guide or diagram for a 2006 3.5 liter v6 chevrolet impala

Diagram 9-5 on this page:
http://www.daycoproducts.com/daycoweb.nsf/Serp%20Rout%20Guide%20Illus.pdf

Posted on Nov 14, 2009

roniecon
  • 6826 Answers

SOURCE: I replaced the ignition in my 04 chevy Impala and

You have to have the key coded with the ignition switch at a lock smith,or the dealer.

Posted on Jan 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I remove a key stuck in the ignition of a 2006 Chevy Impala?


KEY WILL REMAIN IN IGNITION LOCK UNTIL CAR IS IN PARK FULLY. PERHAPS THE CABLE TO THE SHIFTER IS TO BLAME

Apr 09, 2015 | 2006 Chevrolet Chevrolet Impala LT

1 Answer

Why won't 2006 impala will not start and key is stuck in ignition ?


FOR THE STARTING PROBLEM CHECK TO SEE IF THE SECURITY LIGHT IS FLASHING IF IT IS CONSULTOWNERS MANUAL ON HOW TO RESET IT IT CONSIST OF TURNING THE KEY OFF AND ON IN A CERTAIN SEQUENCE AND COULD BE CAUSED BY YOUR IGNITION CYLINDER MALFUNCTION WHICH IS WHY YOU CANT GET THE KEY OUT. BUT BEFORE TRYING TO FIX IT CALL GM AND MAKE SURE IT IS NOT PART OF GM IGNITION RECALL.

Jun 04, 2014 | 2006 Chevrolet Impala

1 Answer

2006 impala transmission replaced but no indicator


Might flash computer. Sounds like security is locking ignition out thinking something was stolen. This happens when car parts are changed sometimes.

Dec 30, 2013 | 2006 Chevrolet Impala

2 Answers

My 2005 chevy impala won't start since someone broke into my car


i would say when the person broke into your car they set off the security system which stops the car from starting, the way to reset the security is to put your key into the ignition turn the key until all the dash lights come on and let them stay on about 15 minutes after the 15 minutes have expired turn the key off and wait about 3 seconds and then your car should start. hope this helps.

Jan 29, 2013 | 2005 Chevrolet Impala

1 Answer

Key will not turn on 2004 cherolet impala


Try spraying release oil down the ignition barrel with key inserted, if this fails probably new ignition switch assembly..Good-luck......

Dec 31, 2012 | 2004 Chevrolet Impala

1 Answer

Ignition won't turn to start car. like it is jammed or locked up.


a binding tumbler would do it try and tap on the face of the cylinder with a small hammer to loosen it up tap on it not beat on it

Aug 13, 2012 | 2004 Chevrolet Impala

1 Answer

06 impala won't start


check to see if you have positive to positive and make sure that the ground is secure... does any lights come on at all when the key is turned on
is the next question

Dec 28, 2011 | 2006 Chevrolet Impala

1 Answer

How do I program my key for my 2006 Chevy Impala?


Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
Originate New Master Key (PK3 or PK3+ key)

1. Insert new key into ignition cylinder and turn it to the ON (RUN) position.
The security light on the dash will illuminate and stay on for ten minutes.
2. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back to the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
3. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back on the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
4. After the security light has gone off the third time, the key has been programmed
into the vehicle’s computer and will operate the car. It has replaced ALL the
previous electronic key codes and is the ONLY key programmed into the
vehicle’s computer.

Add Duplicate Key (PK3 or PK3+ key)

1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.

May 20, 2009 | 2006 Chevrolet Impala

2 Answers

Key won't go into the ignition


This is exactly what happened to my truck last night. The steering wheel moves freely. I had a hard time putting the key in the ignitition. The ignition will not turn. Neither will the shifter. It seems like it is not in park but then how did the key come out? My car is a 2004 Chevy 2500HD. Did you even get a solution to your issue?

Mar 16, 2009 | 2006 Chevrolet Impala

1 Answer

Starting


Does a light come on that looks like a lock?? This is GMs Passlock problem. It a fault in the ignition cylinder. The car won`t turn over. If you remove the key, the car will start in 8 to 10 minutes. Some have found that spraying an electronic spray or silicone based spray in the ignition and rapidly turning the key back and forth may help. Repeat this several times. Replacing the ignition switch is an expensive option, but may have to be done.

Jun 29, 2008 | 2002 Chevrolet Impala

Not finding what you are looking for?
2006 Chevrolet Impala Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...