Question about 2005 BMW 1 Series

Open Question

Reset immobilizer bmw

Need to reset immobilizer cause battery went flat

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
czaa
  • 4521 Answers

SOURCE: how do i reset a 1997 bmw 7 series immobilizer

these cars are very complex--buy a haynes manual for troublshootn--du a scan that runs a data stream and never ever bringit to a dealer

Posted on Nov 21, 2011

Ad
  • 1 Answer

SOURCE: need to reset to run flat tyre warning light on

i have a bmw , 1 series, i have just put air in my tyres and there is now a warning light on the dashboard, have i over inflated my tyres?

Posted on Aug 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My BMW 7series 7351 2004 wont start,it just cranks. started when I removed the battery and put it back. it gives me fault code 2737 anti tampering protection


That fault will cause a no start, it senses an unauthorized person is trying to start eh car. You need a shop to scan the system control module and see what is causing the fault.

Sep 23, 2016 | 2004 BMW 7 Series

1 Answer

How do I reset immobilizer for ford forte auii


They are all different but many systems will work if you leave key turned to on for 5 to15 minutes or so (need good battery) and then click right to start. Bigger issue may be chip key or ignition "reader" in vehicle may have lost contact due to age.

Jan 11, 2015 | Ford Cars & Trucks

1 Answer

I parked my 2001 Taurus sel it ran when I parked


It is possible that the car's alarm/immobilizer system is preventing the vehicle from starting. Manufacturers, in an effort to prevent car theft, have the immobilizer activate if the battery circuit is interrupted for more than a certain number of minutes. This keeps car thieves from cutting battery cables to prevent alarm activation. If the battery goes flat-line dead, the same thing can occur. You need a special tool available at a dealer or repair facility to reset the immobilizer.

Oct 17, 2014 | 2001 Ford Taurus

1 Answer

Why my 2001 boxster doesn't start, after battery charged ?


try resetting the ECM program as the immobilizer may have been activated by what you have done or the dead flat battery

Apr 22, 2017 | 2001 Porsche Boxster

1 Answer

The computer says the immobilizer coil is open/short


Did you reset the computer. Usually disconnecting the battery for about 10 minutes should do it. If this does not fix it, you need to recheck your work. Something you did has caused the message. Did you short circut a wire, burn a fuse, forget to reconnect something? The immobilizer probably works by immobilization of the vehicle's coil circut. Thus, causing the computer message to display about the coil issue. Try reset computer of vehicle should work.

Apr 05, 2013 | Volvo S40 Cars & Trucks

1 Answer

How do i reset a 1997 bmw 7 series immobilizer


these cars are very complex--buy a haynes manual for troublshootn--du a scan that runs a data stream and never ever bringit to a dealer

Nov 21, 2011 | 1997 BMW 7 Series

1 Answer

I have a 2004 BMW Z4 and a light was left on and the battery died. I replaced the battery and when I turn the ignition all of the ligkts inside and out work. The locks work with the key remote and the top...


You should have just purchased a battery charger and then you wouldn't have disconnected the battery and un-paired the alarm system and immobilizer. There would have been enough residual energy in a flat battery to keep the immobilizer happy.

Disconnect the battery completely for at least 2 hours. Hold the positive and negative terminals together for 5 minutes. Put the key in the ignition and connect the negative lead of the battery. Connect the positive in one swift movement. Leave the vehicle for 5 minutes to reset and re-pair the chip in the key and the chip in the ignition lock.

It would have worked if the key was in the ignition when you connected the new battery.

Jul 30, 2017 | 2004 BMW Z4

1 Answer

Have bmw 523 auto will not start,turns over,have charged battery,do i need to reset immobiliser?help,this car cannot be towed i am told because its an auto?


You shouldn't have to reset immobilizer. And your car CAN be towed, if done correctly. It can be towed from the rear. The preferable way is aboard a flat bed.

Jan 04, 2011 | 2009 BMW 5 Series

2 Answers

My 540i bmw got wet in a flood. how do i turn the emobelizer off.


If it just clicks then i would suspect the battery is dead. Try to jump the battery.

Jun 20, 2017 | BMW 328 Cars & Trucks

1 Answer

Car not starting


yes remove the immobilizer unit and then start, then reset the immobilizer unit and connect it back and check if it is working..........

May 19, 2008 | 2006 Audi Allroad

Not finding what you are looking for?
2005 BMW 1 Series Logo

Related Topics:

266 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...