Question about Chevrolet Impala

Open Question

Where are the motor mounts in a 2001 chevy impala ?

Location of the mounts

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 333 Answers

SOURCE: WHERE DO I LOCATE THE EGR VALVE ON MY 2001 CHEVY IMPALA 3.8 V6

The egr valve is located at the end of a hose that plugs into youe valve cover. It is pushed right into a rubber grommet that is located in one of the valve covers. I hope this helps. don.t forget to rate my nswer, thanks

Posted on Feb 27, 2009

Ad
  • 166 Answers

SOURCE: which fuse box has blower motor fuse on 2001 chev impala

There is a blower motor resistor located up under the passenger side dash. I believe there is actually 3 fuses that can cause problems with the blower....relays/fuses should be located in the engine compartment fuse block. They are High Blower fuse-HVAC fuse-Radio/HVAC/RFA/Cluster/etc...fuse. Hope this helps.

Posted on Feb 27, 2010

Testimonial: "again thanks much"

leedavidian
  • 1420 Answers

SOURCE: location of blower motor resistor 2005 chevy

Welcome to FixYa.com

http://www..com/#=2005+Chevrolet+Impala+blower+motor+resistors&hl=en&biw=929&bih=907&prmd=s&source=univ&tbs=shop:1&tbo=u&ei=YmqnTOuvJszUngfk4amdDQ&sa=X&oi=product_result_group&ct=title&resnum=3&ved=0CDcQrQQwAg&fp=f85e1de3958a95f2.com

this above is the resister block. next is the location-455789c.png

Thank you for using FixYa.com, Regards, Lee Davidian



A 4^^^^ THUMBS- UP rating is appreciated for answering your question!!!!!

Posted on Oct 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace the lower motor mounts 2001 chevy impala


I suggest you go to your computer and use google to search for "2001 Chevy Impala Motor Mount replacement". You will have a selection of how to support the engine (and replacement of motor mount) you tube videos to watch. Or go to the library and take out a Chilton or Haynes repair manual so you have it close at hand.

Jun 13, 2014 | 2004 Chevrolet Impala

1 Answer

2001 Chevy Impala 3.4L Base


were the motor & trans mounts checked?

May 26, 2017 | 2001 Chevrolet Impala

1 Answer

How to change spark plugs in a 2001 chevy impala 3.8 l v six


The main problem with the 3.8L plugs are the back 2 plugs on the passenger side.
It can be done without moving the engine, but extremely difficult.

The best thing to do is tilt the motor a little. It's easier than it sounds. Most people use a tiedown strap to roll the engine forward, after you remove the top motor mounts (just behind the radiator).

I prefer to use a floor jack and a piece of wood under the oil pan. Remove the upper motor mounts and jack the engine up a little to roll it forward towards the radiator. The rear plugs should be accessible.

Apr 30, 2011 | 2001 Chevrolet Impala

2 Answers

How to install 350 chevy frame mounts in a 1985 chevy impala


The 1985 Impala came standard with the Chevrolet 305 V8. All Chevrolet small block V8's from 265 cubic inches to 400 cubic inches from 1957 to about 1989 used the same block with almost no difference in the castings, so the motor mounts should fit from one block to the next. If you are trying to swap in a 350 newer than 1989, then the motor mounts are different, and you will have to have them fabricated by a local welder, machine shop, or perhaps the best, a local short-track race car driver/builder. Those guys can build anything.

Feb 16, 2010 | 1985 Chevrolet Impala

2 Answers

My 2000 chevy impala shakes while driving.i let


It sounds like you might need to replace your motor mounts, or get a tier allignement done. The allignment you cannot do yourself but the motor mounts you can this requires you to place a jack under you engine and undoing the motor mounts then replace them and take away jack.

Jan 30, 2010 | 2000 Chevrolet Impala

1 Answer

How to replace 2001 chevy impala blower motor control module and the location


Just behind the blower motor is the blower motor resistor board.Under the dash just ahead of the passenger feet.

Aug 23, 2009 | 2001 Chevrolet Impala

1 Answer

How do i change the Blower motor resistor on a 2005 chevy impala?


The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.

Jul 20, 2009 | Chevrolet Impala Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...