Question about Cadillac DeVille

1 Answer

Heater blows cold

It blows warm on low fan but any other fan speed its ice cold

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 110 Answers

If water temp ok sounds like not enough hot water getting to heater core maybe cooling system flush will help

Posted on Jan 04, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Bloomingidoi
  • 49 Answers

SOURCE: Heater only blows hot (well, warm) on full speed of fan

Replace the temp control on this car, it should be electrical control not cables.

Posted on Dec 03, 2008

dgjtex
  • 405 Answers

SOURCE: 2005 Pontiac Montana SV6 heater blows cold when slowing to idle

How cold is it there and does your engine cool down any while going slow? If it does it may mean you need a hotter thermostat installed, My first thought would be to check the coolant level in the radiator and the coolant reservoir! Hope this helps and Merry Christmas

Posted on Dec 23, 2008

  • 4 Answers

SOURCE: Heater on driver-side blows barely warm air other vents blow cold

the most probabale cause of this would be a disfunctional hear core if you replace your heater your heater will more than likley work the the way it's supposed to

Posted on Jan 18, 2009

emissionwiz
  • 74896 Answers

SOURCE: heater blows cold air ac blows warm air

Your problem is the air temp control blend door actuator is defective and not controlling temp u set. to change/access this part the dash assembly must be removed from the car.

Posted on Mar 24, 2009

  • 2 Answers

SOURCE: heater blows cold air at low speed and idle

I worked at a Nissan dealer for 18 months and we'd get a lot of these in. The cold heat at idle is accompanied by a sloshing noise from behind the dash - you've got an air pocket in the heater core. What we used to do was lift the front end of the car about 3 feet off the ground using the hoist and take the rad cap off. Then we'd run the engine at a fast idle (jam a screwdiver against the throttle stop to hold it fast or put a slight weight on the pedal if it's Electronic Throttle Body. Run the heater on full heat and the engine like this. You'll see the rad 'burping' as the air in the cooling system travelling to the highest point it can - the open rad cap. Top up with a 50/50 mix of coolant and water as you go. When it burps no more, you have a full cooling system and should not suffer any more "cold heat".

If you do this yourself, PLEASE use jack stands, block the back wheels and put the parking brake on!!!

answer from a Nissan mechanic, (not me)

Posted on Dec 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My heater is not working except on one side in my 2007 impala driver side it blows warm passenger cold


To troubleshoot this types of problem,click the link below :----http://howtobyme.blogspot.in/2012/02/heater-blows-only-from-defrost.html
--------Go through the procedure to confirm the issue.

------
Engine Overheats and heater blowing cold?

http://howtobyme.blogspot.com/2011/11/engine-overheats-and-heater-blowing.html

---------
Heat blows cold on drivers side and hot on passenger side?

http://schematicsdiagram.blogspot.com/2011/12/heat-blows-cold-on-drivers-side-and-hot.html

-----------

No heat on car? http://technoanswers.blogspot.in/2012/02/no-heat-on-oldsmobile-silhouette.html

------------
Heater blows intermittently and temp gauge goes erratic? http://technoanswers.blogspot.com/2012/01/heater-blows-intermittently-and-temp.html------------Heater blows cold? http://schematicsdiagram.blogspot.in/2012/02/heater-blows-cold.html
---------Car heater blowing warm, but not hot air? http://schematicsdiagram.blogspot.com/2011/12/car-heater-blowing-warm-but-not-hot-air.html-------- Heater/AC blower motor not working?

http://technoanswers.blogspot.in/2012/02/heaterac-blower-motor-not-working-on.html

------------
A/C, heater, defroster fan, not working? http://technoanswers.blogspot.in/2012/02/ac-heater-defroster-fan-not-working.html Heater problem? http://technoanswers.blogspot.in/2012/02/heater-problem-on-isuzu-trooper.html---------

This will help.Thanks.

Feb 27, 2012 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

2005 jeep liberty blows cold air through the heater.


could be the thermostat if it was just stating to go bad,could also be a vacume problem not letting the door for the ac/heat close all the way for a few min.and if its really cold out like below 35,then its going to take longer to warm up,my jeep takes like around 20 min at idle to warm up.yours could be a case of over cooling in cold weather too ie(electric fans on before it warms up)that would be the thermostatic sensor.

Dec 01, 2011 | 2005 Jeep Liberty

1 Answer

Air works great but no heat just blows cold air


For this types of problem,i suggest you to check this help links:----Car heater blowing warm, but not hot air?http://schematicsdiagram.blogspot.com/2011/12/car-heater-blowing-warm-but-not-hot-air.html
---------A/C, heater, defroster fan, not working?http://technoanswers.blogspot.in/2012/02/ac-heater-defroster-fan-not-working.html
--------Heater problem?http://technoanswers.blogspot.in/2012/02/heater-problem-on-isuzu-trooper.html
---------Engine Overheats and heater blowing cold?http://howtobyme.blogspot.com/2011/11/engine-overheats-and-heater-blowing.html
-----------Heat blows cold on drivers side and hot on passenger side?http://schematicsdiagram.blogspot.com/2011/12/heat-blows-cold-on-drivers-side-and-hot.html----------------This will help.Thanks.

Sep 05, 2011 | 2007 Suzuki SX4

1 Answer

My heater blows warm air when fan on low then when you turn the fan on high it gets cold.


This indicates that enough hot water isn't getting from the engine into the heater core at a fast enough pace to keep up with the increased demand when you have the fan on higher speeds, and that the system is restricted. If your temperature gauge is indicating the engine is at normal operating temp. or you can tell by the general temperature of the engine, then more than likely, you'll need to have the entire system cooling system tested & flushed good luck

Jan 29, 2010 | 1997 Chevrolet Venture

2 Answers

On my 2000 Jimmy when I'm at low speeds in the city it usually blows quite warm out of the heater (not always). But suddenly it will quit blowing any heat at all. On the highway it just blows cold. The...


Hello. First, it is probably that the clotch in the coolin fan isn't working. When the coolin fluid is warm, the temperatur put it in work, and the fan works rapidly, when the temperatur lows, the clotch loose the fan an is waiting the warm up again. But your Jimmy don't have the coolin fan in the principal belt, it have an electric coolin fan. In that case, your problen is for a low level of coolin water, or the relays of the electric fan don't work properly.
Finaly, my english isn't good, because I speak in spanish, but if my bad english solves your problem, i'm geting so well. I working every day in electronics cars, and that is the basic metod of analyse that I use.

Dec 21, 2009 | 2000 GMC Jimmy

1 Answer

No heat air is blowing cold


First you have to identify what causes the problem.
To do this you have to:
1) When engine is cold check the level of coolant. If it is low fill it up.
2) Start engine and check if engine reaches regular temperature. If your engine is not heated enough it means your thermostat does not work properly and should be replaced.
3) If engine temperature is normal, then check the temperature of pipes that go to/from heater core. These pipes are located up the fire wall (easier access is from the passenger side). If pipe/pipes are cold (even engine is worm) it means you heater core is plugged and should be flushed. Keep in mind, flushing the whole cooling system is different from flushing heater core.
4) If pipe/pipes are hot/warm, turn off the fan, switch controller to the hot position, wait for 3-4 minutes and turn on the fan. Note if the cold air blows first or warm air blows first but it cools down in 5-10 seconds. If the air blows cold than it is most probably the problem with blend door or blend door actuator.
5) If air blows warm first and then cools down, then while running engine and remaining the transmission in PARKING position, press on the gas pedal until your engine reaches 3,000 RPM. Check if your heater blows warm/hot air. If it does, then your water pump does not work properly and should be replaced. If the air still cold, I would suggest to flush the heater core.

Oct 22, 2009 | 1998 Ford Taurus

1 Answer

Heater not working


First you have to identify what causes the problem.
To do this you have to:
1) When engine is cold check the level of coolant. If it is low fill it up.
2) Start engine and check if engine reaches regular temperature. If your engine is not heated enough it means your thermostat does not work properly and should be replaced.
3) If engine temperature is normal, then check the temperature of pipes that go to/from heater core. These pipes are located up the fire wall (easier access is from the passenger side). If pipe/pipes are cold (even engine is warm) it means you heater core is plugged and should be flushed. Keep in mind, flushing the whole cooling system is different from flushing heater core.
4) If pipe/pipes are hot/warm, turn off the fan, switch controller to the hot position, wait for 3-4 minutes and turn on the fan. Note if the cold air blows first or warm air blows first but it cools down in 5-10 seconds. If the air blows cold than it is most probably the problem with blend door or blend door actuator.
5) If air blows warm first and then cools down, then while running engine and remaining the transmission in PARKING position, press on the gas pedal until your engine reaches 3,000 RPM. Check if your heater blows warm/hot air. If it does, then your water pump does not work properly and should be replaced. If the air still cold, I would suggest flushing the heater core.

Oct 17, 2009 | 1998 Ford Taurus

1 Answer

Heater on driver-side blows barely warm air other vents blow cold


the most probabale cause of this would be a disfunctional hear core if you replace your heater your heater will more than likley work the the way it's supposed to

Jan 18, 2009 | 2001 Dodge Grand Caravan

1 Answer

Heater only blows hot (well, warm) on full speed of fan


Replace the temp control on this car, it should be electrical control not cables.

Dec 03, 2008 | 2000 Ford Escort

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7689 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...