Question about 2008 Chrysler Aspen

1 Answer

08 chysler aspen the speed message is not working after I installed engine

Truck turns on drives good also has esp light on and speed odometer don't work

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 49,253 Answers

Check for a wire that you have not connected up around the gear box area

Posted on Jan 04, 2014

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
ndguy2481
  • 251 Answers

SOURCE: Speed gauge is not working in car.

more then likely it is a speed sensor located between the motor and transmission

Posted on Dec 08, 2008

  • 972 Answers

SOURCE: 2007 Aspen - Heater/AC Fan does not work on lowest setting

probably has a bad blower motor resister

Posted on Mar 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Speedometer, odometer and cruise control not working in '97 Taurus Duratec


computer probly needs to be flashed or reprogrammd to sync w new motor---some independent shops have the factory gear to do this-dealers only go back like 5yrs

Nov 17, 2013 | 1997 Ford Taurus

1 Answer

After accident chysler 300 any way to determine how fast car was traveling


the 300 could have been doing 55 -a t-bone to the rear axle will rip it apart and a p/u rears try to slid sideways on dry pavement don tak much to make it slide or spin sideways-and a 300 nose is all plastic and their computers are in engine bay cost more to repair so total is insurance choice of action-to determine if the speed is a factor u will need a lawer who deal with accidents one is that they usually have a person or a retired police office who are trained in accident reconstuction and they can request data from black box in other vehicle-but if ur the causing factor [improper turn -improper lane chnge-failed to yield right of way etc...]most lawyers wont take case

Apr 06, 2013 | Chrysler 300 Cars & Trucks

1 Answer

Engine check light is on and odometer stop running


Vehicle speed sensor. This runs the odometer/speedometer. Top of tranny, a cable runs all the way to the back of the odometer.

Feb 14, 2013 | 1997 Honda Accord

3 Answers

How to shut off gascap light chrsler aspen check engine light goes off but because gascap light stays on check engine light returns. So how can i clear gascap light


You may have a faulty gas cap. If you are tightening the cap down securely the light will go off after the car is driven about 40 miles. I suggest installing a new gas cap which should cost about $15 at your local auto parts store. *** Please rate me on this answer.***

Jun 05, 2010 | 2007 Chrysler Aspen 4x2

2 Answers

Car speedo & odometer sometimes work OK, other times not at all.


Most likely a speed sensor is going bad (most cars and truck do not use mechanical speedometer cables anymore) most sensors are located near the differential in rwd cars or near the drive shaft on the transmission. Best bet is to get a Haynes manual for your car to help locate the speed sensor. Remove it and take it to the auto parts store so you can visually compare it to the replacement. Install the new speed sensor and it should restore your speedometer and odometer.

Aug 19, 2009 | 1996 Honda Civic

2 Answers

2001 ram 15oo, speed,tach,oil press,batt,fuel gauges all stopped working at once. message on odometer says--no buS . no noticeable difference in engine performance.


i am having the some problem with my 2001 dodge ram 1500 all of my gauges stop working after the engine light came on now on myodometer says no bus, Can you help me with it

Jul 17, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Speedometer and Odometer not working , Break Light and Abs light on


Most likely you have a check engine light on also. And if you have codes pulled it will be 0500, speed sensor. Replace the one on the rear axle and all should be good. Oh and don,t forget to have code cleared.

Jun 29, 2009 | 1999 Dodge Ram

1 Answer

Odometer not working


yes the speed sensor controls the speedometer and odometer and they are electrical no more drive cable installed

Jun 21, 2009 | 1995 Nissan Pickup

1 Answer

2001 Focus: Speedometer at 0, blank odometer, rough shifting


needs a vehicle speed sensor, its on the trans. if the engine was just put in( within like 2 or 3 days, not weeks) then it may have been busted in the engine swap. hope this helps and good luck

Jun 08, 2009 | 2000 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...