Question about Cars & Trucks

Open Question

Fisher plow problems - Cars & Trucks

Posted by on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 67 Answers

SOURCE: with plow lights pluged in do not have low beam on

ca mention may be wrong un plug the 2 chk fuse and start overthen u no

Posted on Dec 11, 2009

oldmanewtoys
  • 414 Answers

SOURCE: my fisher plow wont move

Sounds like pump is not working, check all fuild lines. Unless the plow is all electric, then the ground

Posted on Feb 26, 2010

SOURCE: Lights on a fisher xtreme plow wont work

Check your harness plug ends for broken pins. Also the isolation module could be defective

Posted on Feb 07, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a minute mount plow, when I try to use it only goes to left and right side but doesn't go up, when I try to lift the plow goes to the right. What can I do


2002 Fisher Minute Mount Inst-Act Wont Angle [Archive] - PlowSite ...

www.plowsite.com > ... > Truck & Equipment Repair

Nov 17, 2011 - 90 posts - ‎9 authors
My plow went up it was jerking and did it in steps , but , it got there . Now , it onlyjerks when i try to angle it right or left or up . I filled the fluid ... Drop it and if it doesn'traise you can just use a jack and shorten the transport chain to hold it. .... I do havecontinuity on the plow side for all 3 wires going to the plug . Hooking Up A Fisher Minute Mount 2 In Under 1 ...
54 posts
Feb 1, 2011
Plow Wont Angle
32 posts
Oct 19, 2010
What's wrong with my plow?
21 posts
Jan 9, 2003
Looking For Minute Mount Tips
57 posts
Feb 13, 2002
More results from www.plowsite.com

Ultramount Intermittent Angle Problem - Snow Plow Forum - L


Dec 27, 2015 | Cars & Trucks

1 Answer

My fisher minuteman 2 plow will go up and left and right but will not go down


Most of those systems don't have a driven retraction on the piston. It is gravity feed back. There is a valve that is sticking or out of adjustment. http://library.fisherplows.com/?cat=38

Jan 24, 2015 | Cars & Trucks

2 Answers

I have a fisher minuteman plow it will go up, left and right but will not go down what is wrong with my plow


If you have a Minit Mount two it's probably the valve sticking. It's electronically controlled so if it clicks, then the solenoid is working and the shuttle in the valve is stuck. Can be disassembled and cleaned. New ones are best but pricey.

Jan 24, 2015 | Cars & Trucks

2 Answers

I can hear my fisher plow motor but the plow will not lift or angle


There solinoids on pump. Check wiring and grounds. Make sure all small wires are intact and in good condition. But most likely there's a loose corroded or green wire causing issue

Jan 09, 2015 | Cars & Trucks

1 Answer

My fisher plow wont move


Sounds like pump is not working, check all fuild lines. Unless the plow is all electric, then the ground

Feb 26, 2010 | 1998 Chevrolet C1500

2 Answers

Lights on a fisher xtreme plow wont work


I'm guessing that you have already checked to make sure there is power going to the plow lights. If not use a test light and make sure. The most likely problem is the grounds from the plow lights themselves to the frame. Take the lights apart and check and/or replace the grounds, wires inside the case take a lot of vibration and that can cause them to fail.Don't forget to check the bulbs to be sure they're good too. Hope this helps.

Dec 17, 2009 | 2007 GMC Sierra 2500HD

1 Answer

Hi, I have a 2000 dodge ram and when i plug my fisher plow up only one light works on the plow and one on the truck .when the plow is un hooked from the truck all the truck lighs work,and when i hook up...


There is a ground that is deteriorated in the harness. trace the ground lead back from the connection to your truck. Once you find the break, that should take care of your problem.

It is also possible to be a power lead, so check them also, but more often than not it is a ground.l

Hope this helps.

Dec 14, 2009 | 2001 Dodge Ram 2500 Truck

1 Answer

Fisher plow that wont go up and sometime won't turn either way


did you try cleaning the solenoids for the plow? i think this would solve your problem

Mar 09, 2009 | 1996 Dodge Ram 1500 Club Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...