Question about Cars & Trucks
The heater blower gets the air from a chamber at the bottom of the windscreen and this area would be full of snow so I would expect that some snow would be drawn into the car on start up of the blower. Try changing the vent setting to car recirculation so that the car air is used and not outside air.
Posted on Jan 03, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
if you hear the fans blowing and no heat is coming
then you mite have to replace the heater.
before you try to replace the heater talk to Lords
Posted on Dec 04, 2008
Disconnect the heater hoses from the water pump and the intake manifold. Get a compressor and blow out the hose (put the air hose into the the hose that came off the mainfold. then flush the system and replace the antifreeze.
Posted on Dec 12, 2008
SOURCE: 2000 GMC Jimmy won't start
i had the same problem and replaced the fuel pressure regulator. Cost about $45 at advance auto store or about $90 at napa auto stores. Once i replace that my truck started right yup and runs like a champ
Posted on Jul 13, 2009
your heat/cool and vent selection options are controlled by engine vacuum through small clear tubes attached to the rear of your climate control interface. Other vehicles have small steel pull wires that operate the desired changes. You might try removing the trim and any fasteners affiliated with the interface/console. GENTLY pull outward and look to see if any of these tubes are pulled off or cut/damaged. Did anyone recently install a new stereo in the vehicle? If so, the vacuum tubing and or pull wires that change your outlets could have been damaged when the stereo unit was pushed into place. Hope this helps
Posted on Sep 09, 2009
Testimonial: "Very good information. THANKS!"
Tips for a great answer:
Jun 19, 2011 | 2000 GMC Jimmy
Jul 22, 2010 | 1997 GMC Jimmy
Feb 10, 2010 | 1995 GMC Jimmy
Nov 27, 2009 | 2000 GMC Jimmy
Aug 23, 2009 | 1983 GMC Jimmy
Jan 07, 2009 | 2000 GMC Jimmy
Nov 19, 2008 | 2000 GMC Jimmy
45 people viewed this question
Usually answered in minutes!